Field and pressure response of Yb compounds close to a quantum critical point

YbCu_5−x Al _x provides the possibility to tune ground state properties by a change of the valence due to the Cu/Al substitution, by pressure as well as by the application of a magnetic field. Near to the critical concentration x _cr≈1.5 non-Fermi-liquid properties (NFL) are obvious, obeying hyperscaling. If magnetic order sets in for x>1.5, the application of moderate magnetic fields quenches order and again NFL features become evident. Hyperscaling in this case indicates strongly interacting spin fluctuations.     

Mode beating in spot-size converter lasers

An anomalous modulation in the wavelength spectrum has been observed in lasers with spot-size converters. This intensity modulation is shown to be caused by beating between the fundamental lasing mode and radiation modes in the taper. This results in a periodic modulation in the net gain spectrum, which causes wavelength jumps between adjacent net gain maxima, and a drive current dependent spectral width that is expected to affect system performance. The amplitude of this spectral modulation is reduced significantly by either using an angled rear-facet which reflects the beating radiation modes away from the laser axis, or by using a nonlinear, adiabatic taper.     

ICF空心微球靶传热的有限元分析

 为分析冷冻靶丸外部温度场，应用ANSYS软件对ICF空心微球靶的热传递进行了有限元分析。建立了单元传热的几何物理模型，靶丸微球呈空间均匀分布，计算区域由三个同心球壳组成，分别为液体层、靶丸壳层以及氦气层，氦气层厚度为球壳层厚度的7倍。模型左右两边界设为绝热边界条件，采用智能自动划分网格,设定参数为3，单元类型为三角形。模拟表明，在靶丸工作温度为24 K的情况下，为保持靶丸气泡受力平衡，自洽得到靶丸内部温度梯度为14.02 K/cm，以此求解出所施加的外部温度场为7.758 K/cm。将计算值与现有的实验结果进行了比较，模拟结果与国外实验值(8.2 K/cm)吻合得较好。     

基于频域方法的三维物体分层重现

基于频域方法实现了数字记录和再现三维物体离轴全息图.通过频谱对应关系求得各个面的频谱分布,使用数字滤波方法,成功地消除了零级衍射和共轭像;通过改变再现距离,分别获取了三维物体各个截面的再现像.     

Near- and mid-infrared laser-optical sensors for gas analysis

Semiconductor diode lasers were first developed in the mid-1960s and found immediate application as much needed tunable sources for high-resolution laser spectroscopy commonly referred to as tunable diode laser absorption spectroscopy (TDLAS). In this paper, currently available semiconductor lasers for spectroscopy in the near- and mid-infrared spectral region based upon gallium arsenide, indium phosphite, antimonides and lead-salt containing compounds will be reviewed together with the main features of TDLAS. Room-temperature measurements of atmospheric carbon dioxide near 2 μm will be discussed and recent results obtained with a fast chemical sensor for methane flux measurements based on lead-salt diode lasers operating near 7.8 μm will be presented.     

An airborne diode laser spectrometer for the simultaneous measurement of H2O and HNO3 content of stratospheric cirrus clouds

We describe a tunable diode laser spectrometer for the in situ simultaneous detection of the nitric acid and the water vapour by means of high resolution absorption spectroscopy on rovibronic lines, using a single laser emitting in the mid-infrared (5.8 μm) and a multipass cell. The instrument was designed to be installed on a high altitude aircraft, as a part of a composite payload for atmospheric aerosol studies. The instrument design criteria are discussed and the expected performances are compared with results of laboratory and field operation. Due to the high chemical activity of HNO₃, that makes difficult to use a reference cell, a fast sweep detection of direct absorption was used for the measurement. An absorption sensitivity of about 2×10⁻⁴ was achieved with an integration time of 2.5 s, corresponding to a concentration of about 4 ppb of HNO₃ in the cell and 0.1 ppb in the external aerosol. The data acquisition and processing techniques, based on the full molecular lineshape fitting are also shown and discussed, including some examples of the data acquired during the scientific flights.     

In situ neutron diffraction study (300-1273 K) of non-stoichiometric strontium ferrite SrFeOx

The high-temperature cubic phase of non-stoichiometric strontium ferrite SrFeO_x (2.5≤x≤3.0) has been studied by in situ neutron powder diffraction in air over the temperature range 300-1273 K. The composition of SrFeO_x changes within the range 2.56≤x≤2.81 from 1273 to 673 K, respectively.Rietveld refinements of the diffraction patterns show that the high-temperature cubic phase of SrFeO_x is consistent with a face-centred Fm3c structure. This structure leads to agreement with previous density measurements. This cell allows the high-temperature structure of SrFeO_x to be described in terms of a solid solution of the composition end members. Cubic SrFeO_x at high temperature is found to closely obey Vegard's law. The density of cubic SrFeO_x is also found to exhibit a linear relationship with composition.     

An inverse radiative transfer problem of simultaneously estimating profiles of temperature and radiative parameters from boundary intensity and temperature measurements

A parallel-plane space filled with absorbing, emitting, isotropically scattering, gray medium is studied in this paper. The boundary intensity and boundary temperature profiles are calculated for the inverse analysis. For the simultaneous estimation of temperature, absorption and scattering coefficient profiles in the medium, the sum of residuals of boundary intensity and temperature after being weighted by a balance factor is minimized through using a Newton-type iteration algorithm and the least-squares method. To avoid over-updating for the parameters, the relative updating magnitude during the iteration process is constrained not to be >0.5. It is shown that the boundary intensity measurement alone is not enough to estimate simultaneously the temperature (source) and the radiative properties (both absorption and scattering coefficients) when the measurement data contain sensitive random errors. The boundary temperature measurement can serve as a necessary supplementation to the boundary intensity to make this kind of inverse radiative transfer problem resolvable. It was shown that a compensation relationship between absorption and scattering coefficients makes it difficult to fix them accurately. Parabolic profiles for the three parameters are used to validate the estimation method. When the optical thickness approaches 4.0, the results for the radiative properties are not acceptable, although the result for temperature profile is reasonable. This means the method needs further improvements.     

偏振小孔干涉仪

偏振小孔干涉仪是一种可实用的新型干涉仪。它综合小孔衍射技术、偏振技术和共光路设计为一体,具有条纹对比度可调、抗干扰能力强和非接触检验等优点,可广泛用于各种光学元件及其胶合层的检验。目测精度达1/10λ,计算机条纹处理精度可调。     

Vector semi-rational rogon-solitons and asymptotic analysis for any multi-component Hirota equations with mixed backgrounds

The Hirota equation can be used to describe the wave propagation of an ultrashort optical field. In this paper, the multi-component Hirota (alias n-Hirota, i.e. n-component third-order nonlinear Schrödinger) equations with mixed non-zero and zero boundary conditions are explored. We employ the multiple roots of the characteristic polynomial related to the Lax pair and modified Darboux transform to find vector semi-rational rogon-soliton solutions (i.e. nonlinear combinations of rogon and soliton solutions). The semi-rational rogon-soliton features can be modulated by the polynomial degree. For the larger solution parameters, the first m (m < n) components with non-zero backgrounds can be decomposed into rational rogons and grey-like solitons, and the last n − m components with zero backgrounds can approach bright-like solitons. Moreover, we analyze the accelerations and curvatures of the quasi-characteristic curves, as well as the variations of accelerations with the distances to judge the interaction intensities between rogons and grey-like solitons. We also find the semi-rational rogon-soliton solutions with ultra-high amplitudes. In particular, we can also deduce vector semi-rational solitons of the n-component complex mKdV equation. These results will be useful to further study the related nonlinear wave phenomena of multi-component physical models with mixed background, and even design the related physical experiments.