原子荧光光谱法测定化探样品中的砷和锑

对氢化物原子荧光光谱法测定化探样品中砷和锑元素的分析条件,尤其是浸提法及预还原顺序进行了考察。样品经王水和王水溶液(1+1)分别浸提后以不同顺序预还原,结果表明,王水的氧化性会降低硫脲–抗坏血酸的还原效果,预还原时降低王水浓度能提高测定结果的准确度。在优化的测定条件下,样品中砷、锑测定结果的相对标准偏差分别为0.6%,2.7%;回收率分别为95%～101%,91%～106%;检出限分别为0.020,0.026 ng/mL。改善样品处理方法后测定结果的的准确度得到提高。     

超声辅助提取/离子色谱法测定铬污染土壤中的六价铬

建立了超声辅助提取/离子色谱法测定铬污染场地中铬（Ⅵ）的方法。选用0.3 mol/L的KCl溶液作提取剂,对12组土壤样品中的铬（Ⅵ）进行超声辅助提取20 min。采用Metrosep A Supp 4-250（250 mm×4.0mm）型阴离子分离柱,以4 mmol/L Na₂CO₃-1 mmol/L NaHCO₃混合溶液为淋洗液对样品进行分离分析。铬（Ⅵ）在0.01²0 mg/L浓度范围有较好的线性关系,相关系数（r²）为0.999 8;该方法的检出限为0.003 mg/L,加标回收率为96.4%¹06.8%,相对标准偏差（RSD,n=3）为0.56%。该方法具有简便、快速、准确等优点,适用于铬污染场地的监测与调查。     

Coffee-ring effects in laser desorption/ionization mass spectrometry

This report focuses on the heterogeneous distribution of small molecules (e.g. metabolites) within dry deposits of suspensions and solutions of inorganic and organic compounds with implications for chemical analysis of small molecules by laser desorption/ionization (LDI) mass spectrometry (MS). Taking advantage of the imaging capabilities of a modern mass spectrometer, we have investigated the occurrence of “coffee rings” in matrix-assisted laser desorption/ionization (MALDI) and surface-assisted laser desorption/ionization (SALDI) sample spots. It is seen that the “coffee-ring effect” in MALDI/SALDI samples can be both beneficial and disadvantageous. For example, formation of the coffee rings gives rise to heterogeneous distribution of analytes and matrices, thus compromising analytical performance and reproducibility of the mass spectrometric analysis. On the other hand, the coffee-ring effect can also be advantageous because it enables partial separation of analytes from some of the interfering molecules present in the sample. We report a “hidden coffee-ring effect” where under certain conditions the sample/matrix deposit appears relatively homogeneous when inspected by optical microscopy. Even in such cases, hidden coffee rings can still be found by implementing the MALDI-MS imaging technique. We have also found that to some extent, the coffee-ring effect can be suppressed during SALDI sample preparation.     

Hyphenation of optimized microfluidic sample preparation with nano liquid chromatography for faster and greener alkaloid analysis

A glass liquid–liquid extraction (LLE) microchip with three parallel 3.5 cm long and 100 μm wide interconnecting channels was optimized in terms of more environmentally friendly (greener) solvents and extraction efficiency. In addition, the optimized chip was successfully hyphenated with nano-liquid chromatography with ultraviolet and mass spectrometric detection (nanoLC–UV–MS) for on-line analysis. In this system, sample pretreatment, separation and detection are integrated, which significantly shortens the analysis time, saves labor and drastically reduces solvent consumption. Strychnine was used as model analyte to determine the extraction efficiency of the optimized 3-phase chip. Influence of organic solvent, pH of feed phase, type of alkaloid, and flow rates were investigated. The results demonstrated that the 3-phase chip nanoLC–UV/MS hyphenation combines rapid (∼25 s) and efficient (extraction efficiency >90%) sample prep, with automated alkaloid analyses. The method was applied to real samples including Strychnos nux-vomica seeds, Cephaelis ipecacuanha roots, Atropa belladonna leaves, and Vinca minor leaves.     

Preparation and application of trimethylamine amination polychloromethyl styrene nanolatex coated capillary column for the determination of bromate by field‐amplified sample stacking open‐tubular capillary electrochromatography

A new trimethylamine amination polychloromethyl styrene nanolatex (TMAPL) and TMAPL coated capillary column (ccc‐TMAPL) were successfully prepared. The TMAPL coating was characterized with reversed steady EOF values of ca. ?16.8 × 10^?5 cm² V^?1 s^?1. It was applied to establish open‐tubular (OT) CEC and field‐amplified sample stacking (FASS) OT‐CEC methods for the determination of bromate in tap water. Compared to OT‐CEC, the LOD with FASS‐OT‐CEC was improved from 80 to 8 ng/mL. The developed FASS‐OT‐CEC method was practically used for the analysis of bromate in tap water samples with recoveries ranging from 93.6 to 103.5%.     

A New Organophosphorus Insecticides Removal Process Using Fly ASH

Abstract

Fly ash and soil mixtures with a range of fly ash content from 1 to 100% were used to study adsorption and desorption of four organophosphorus insecticides, ethyl parathion, methyl parathion, fenitrothion and fenthion, in batch experiments. The object of the study was to develop a treatment process using fly ash as sorbent material to isolate/immobilize organic contaminants from aqueous solutions. The adsorption isotherms fit the Freundlich equation x/m=K_dC^1/n. The K_d values increase with the increase of the fly ash content. The isotherms seem to fit the S type, in mixtures of soil with a fly ash content from 0 to 10%, which implies that adsorption becomes easier as the concentration in the liquid phase increases. In mixtures of soil with a fly ash content from 25 to 50% the isotherms become L type and correspond to a decrease of site availability as the solution concentration increases. Finally in mixtures of soil with a fly ash content over 50%, C type adsorption was observed which correspond to a constant partition of the insecticides between the bulk solution and the adsorbent. Mass balance estimations show that the mean percent amounts of insecticides for a range of concentration 0.5–15 mg/l, removed by adsorption in the soil sample are 81.56 % for ethyl parathion, 48.97 % for methyl parathion, 67.06 % for fenitrothion and 86.65 % for fenthion. The adsorption increases as the fly ash content increased and reach the 100% in the “pure” fly ash. The adsorbed amounts of insecticides in mixtures of soils with >50% fly ash content, are up to 99%. In contrast, the amounts of desorption in water decrease as the fly ash content increase.

The results of this research demonstrate that the fly ash shows a significant capacity for adsorption of organophosphorus compounds from aqueous solution and can be used for pesticide removal process.     

Investigation of the solubilization of car-emitted Pt,Pd and Rh in street dust and spiked soil samples

A sequential extraction procedure (three-step), proposed by the Standards, Measurements and Testing Programme (formerly BCR) of the European Union, was applied to street dust and spiked soil samples for the determination of PGEs. Analyses were carried out using inductively coupled plasma-mass spectrometry (ICP-MS). The results indicate that up to 5% from Pt, 70% from Pd and 14% from Rh are in mobile forms in street dust. The results for the soil samples spiked with crushed catalytic converter are significantly lower indicating that PGEs are oxidised more efficiently in natural conditions. Additionally Pt and Pd bound to humic acids were investigated.     

Reflection–absorption infrared sensing device for detection of semivolatile aromatic compounds in soils

In this article, a new IR-sensing device is described for the examination of chlorinated aromatic compounds in soils. To prepare this sensing device, a 20-mL glass vial was modified for use in the analysis of soil samples by conventional Fourier-transform infrared (FT-IR) spectroscopy. In this sampling device, an aluminium plate coated with a hydrophobic film was placed on top of the cap of the sample vial to absorb the analytes that evaporated from the soil matrix. After this absorption process was complete, the cap was placed in an FT-IR spectrometer, and the absorbed analytes were detected in the reflection–absorption (RA) mode. To accelerate the rate of evaporation of the analytes, the soil samples were heated to various temperatures. Meanwhile, other factors, such as the moisture content, sampling time, thickness of the hydrophobic film, and the volatilities and concentrations of the analytes, were also examined to optimize the analytical conditions. The results indicated that the time required to reach equilibrium conditions was short, and evaporation/absorption could be achieved within 10?min. With a water content of 10% (v/w) or less, the intensities of the analytical signals were increased greatly when compared with those of dry samples; when the water content was above 10% (v/w), these intensities decreased, partially as a result of the heating efficiency. After examining the compounds that had different vapour pressures, the analytical results indicated that this method was applicable to the examination of compounds that had vapour pressures below 1.0?Torr. Using the optimal conditions determined in this study, the detection limits for semivolatile aromatic compounds were lower than 100?ng/g, and the regression coefficients of the standard curves for compounds that had a vapour pressure lower than 1.0?Torr were larger than 0.99 in the concentration range of 1–100?µg/g.     

Assessment of mobility of heavy metals in two soil types by use of column leaching experiments and chemometric evaluation of elution curves

The objectives of this study were to evaluate the mobility of heavy metals (HMs) in two types of soils (acidic forest soil and neutral agricultural soil) by leaching with calcium chloride solution in column experiments. The screening properties of neutral agricultural soil towards pollution by heavy metals (Ni, Cu, Zn and Cd) are approximately 10 times higher than those of acid forest soil. The neutral agricultural soil, polluted artificially by one pore volume (PV) of an HMs solution of concentration 200 mg L^?1, can screen the leaching of these metals over several hundreds of years. The higher apparent desorption rate and per cent desorption of HMs (especially Cd) in acid forest soil indicated a higher potential of intensive migration of the metals across the profile and indicated potential risk of Cd pollution for this type of soil. The latest approach of artificial neural networks to describe transport of HMs in soil has been also evaluated. Using a simple three-layer perceptron topology with three hidden neurons, the experimental data could be simulated. The results suggested that the pH of soil is a major factor controlling the retention of the heavy metals in the soils.     

Handling of Environmental and Biological Samples via Pre-Column Technologies

Abstract

Sample handling is still a weak point in chromatography and in analytical chemisty in general. One consideration is the automation potential of new procedures. Solid-liquid extraction techniques in combination with pre-column technology are particularly promising in this regards. The construction and geometry of pre-columns both for conventional and narrow-bore HPLC are of major importance, since band broadening should be kept at a minimum for an optimal functioning of the analytical system. The various operations that can be carried out with such a pre-column are trace-enrichment, clean-up of the sample which depends on the type of adsorbents used in the precolumn, i.e., polar or apolar materials, ion exchangers or metal covered surfaces, etc., protection of the analytical column, field sampling and storage of samples and as a substrate for on-column chemical derivatizations. These various operations are demonstrated with practical examples from the fields of environmental and biological analysis. The selectivity can be further enhanced by coupling precolumn technology with selective detection modes such as diode array UV, electrochemical or fluorescence detection. This enables the construction of optimal and integrated analysis sytems which are fully automated and microprocessor controlled. They can also be made compatible with miniaturized LC-technology.