Thermal and thermoxidative degradations of starch and thermosensitive starch-g-BAM copolymers

Summary Thermal degradation under N₂atmosphere and thermoxidative degradation under air atmosphere of increasingly grafting efficiency values (i.e. GE%=0.0 to 35.5) for starch and starch grafted with N-tert-butylacrylamide thermosensitive copolymers (starch-g-BAM) by Ozawa and Kissinger methods using thermogravimetric analysis (TG) and differential scanning calorimetry techniques (DSC) at 10, 30 and 50% mass losses respectively have been studied. Influence of physical inter and intra molecular interactions on grafting and consequently on activation energy of degradation (E_a,d) was investigated using Ozawa's method, whereas linear dependence of E_a,don GE% by scaling relations using Kissinger's method was determined. Furthermore, the thermoxidative degradation induces the possibility of molecular rearrangement, cyclization and partial crosslinking that is deduced from the activation energy of degradation (E_a,d) and residual mass of TG profile. Thermal stability of starch does not alter as a result of different grafting efficiency percentages.     

Structural Efficiency and Microstructural Modeling of Wet Gels and Aerogels

We present a microstructural model of aerogels that includes the effect of particle necks, tortuosity and dangling ends on the scaling of elastic moduli with density. Relative neck radii can be determined for sintering series of silica aerogels and for Resorcinol Formaldehyde (RF) aerogels produced with different catalyst concentrations. The density of elastically ineffective dangling ends and the tortuosity can be estimated using information from thermal conductivity and elastic modulus measurements in silica aerogels. Typical values for the load bearing mass range from >50% for high density and heat treated aerogels to <10% of the total mass for low density wet-gels.     

Practical limitations of capillary gas chromatography

Glass capillary gas chromatography is a high resolution separation method which allows the qualitative and quantitative analysis of even complex mixtures, which may contain many components–also isomeric–in a wide range of volatilities, polarities and concentrations. The principal limitation of gas chromatographic application is given by an insufficient volatility of the species to be separated. Elevated temperatures have to be applied if the application range is to be extended and to achieve steep peak profiles, i.e. low detection limits at high resolution. The use of elevated temperatures is limited, of course, by the temperature stability of both the solvent (stationary liquid and support) and the solutes. The problems of trace analysis for low volatility compounds at high resolution and its limitational parameters regarding sampling, separation and detection are discussed. The applicability of glass capillary columns in this field is influenced by the following parameters: tailing behaviour; irreversible adsorption of polar and decomposition of unstable solutes; thermal stability of stationary liquid (including the support deactivation); separation efficiency and sample capacity (film thickness). Multidimensional gas chromatography using capillary columns coupled either with a packed or another capilllary column for preseparations may be applied with advantage in the analysis of complex mixtures.     

Orbital correlation effects: The independent pair-potential approximation with application to the ground state and first ionized state of boron hydride

A new method is proposed for calculating correlation effects in atomic and molecular systems. The basis of the method is the formulation of a set of partial configuration expansions which yield directly variational orbital correlation corrections which are appropriately summed in order to obtain an estimate of the total correlation energy. This method is applied to the ground state of boron hydride and its cation at the equilibrium distance of BH. The results of the method are compared in detail with independent electron pair results and second order CI results. It is further shown that multiple substitutions are approximately accounted for in this method and the extent to which they are included is compared with other approximations. Finally, three methods of increasing accuracy, aimed at reducing the necessary computational effort, are given for determining the vertical ionization potential. The most economical method yields an IP of 9.70 eV or 0.03 eV less than the experimental IP. Completion of the basis is estimated to improve this value to 9.77 eV.     

烷烃电离能和生成焓的相关性

根据化合物形成过程中价电子能量变化与生成焓之间的关系, 推导出烷烃的生成焓和电离能之间的关系. 以21个烷烃化合物为模型将实验测定的电离能与标准生成焓进行直接关联, 证实了模型方程的适用性, 所得回归方程的相关系数达到0.9999, 估算值与实验值之间的标准偏差仅为0.03 eV. 同时还利用实验测定的标准生成焓对一系列烷烃的电离能作了预测.     

咪唑类化合物-CuCl络合催化剂在甲醇氧化羰基化反应中的催化性能

研究了咪唑及其衍生物配合CuCl对甲醇液相氧化羰化合成碳酸二甲酯的催化性能。筛选出溶解性好、腐蚀性小且催化活性高的多功能助催剂。实验结果表明，反应体系中加入N-甲基咪唑后，CuCl可以完全溶解。当催化剂的浓度为0.2 mol/L, N-甲基咪唑与CuCl的量为4∶1，反应温度为120 ℃，反应压力为2.40 MPa，CO与O2的进气比2∶1，反应3 h的条件下甲醇的摩尔转化率为15.4%，选择性为98%以上。从腐蚀性试验结果看，50 ℃时，加入N-甲基咪唑化合物后，Q235钢在CuCl/CH3OH/H2O/CO/O2体系中的腐蚀速率为0.22mm/a，缓蚀效率为94.5%。动力学研究表明，反应近似为一级，加入N-甲基咪唑后，反应速率常数为0.15 min－1。     

某些离解能、电子亲合能等的G2计算与评价

PoPle及其合作者创立的Gaussian再简称GZ）理论［‘－’］，以其相对可靠的化学精度和相应较小的计算量已经引起了实验和理论化学家们的广泛关注问．p。ple等人在他们的GZ文章中强调了GZ的理论计算结果在研究离解能等化学问题中与精确实验数据之间的偏差普遍不大于全8．狄J规厂‘．我们近期的研究表明＊’1，＊2和优（＊则在计算一般化学反应能量中，绝大多数情况下，分别都能保证结果与实验偏差在全8．4和士13kJ·mol‘以内．近年来，已有大量的研究工作表明，GZ的理论结果已广泛用于未知实验数据的预测、已有实验数据的评价和修正等…     

Interactions of dicarboxylic porphyrins with membranes in relation to their ionization state

The interactions of dicarboxylic porphyrins with membrane systems are discussed with particular emphasis on the effect of the charge of the porphyrin and the nature of the side-chains. The incorporation of hematoporphyrin or related dicarboxylic porphyrins within small unilamellar vesicles as membrane models is favored by a decrease of the pH in the range of physiological pH values. This effect might play an important role in the retention of porphyrins by tumors, which are more acidic than normal tissues. Kinetics studies also show that the partition of the porphyrin between the lipidic bilayer and the aqueous phase is governed by its release rate rather than by its incorporation rate.     

Complete basis set ab initio computational study of ionization potential, electron affinity and the C-F bond dissociation energy for perfluorinated methane derivatives

A computational study of perfluorinated methane derivatives was performed with complete basis set ab initio methods. The total energies for their neutral, cation, and anionic states were computed. From these values, the energy gaps between different electronic states, ionization potentials, electron affinities, and C-F bond dissociation energies were calculated. The computed values are compared with experimental data and the reliability of complete basis set ab initio methods is discussed. New values for C-F bond dissociation energies are suggested. Received: 12 January 1998 / Accepted: 2 April 1998 / Published online: 29 July 1998     

Ionization of some derivatives of benzamide, oxamide and malonamide in DMF-water mixture

The ionization of six compounds of bis-phenolic amides was studied spectrophotochemically in DMF-water mixture. The compounds showed two pK_a values in the range of 5.97-7.32 for pK_a1 and 7.61-8.44 for pK_a2. The obtained values of K_a were normalized using the distribution diagrams of the different species and found to be in the range of 5.81-7.42 for pK_a1 and 7.48-8.27 for pK_a2.