碳载Pt-P催化剂对氧还原的电催化性能

用NaH2PO2液相还原方法制得碳载Pt-P(Pt-P/C)催化剂(m(Pt)∶m(P)=5∶1)。 X射线衍射谱测量表明,Pt-P/C催化剂的Pt衍射峰的2θ值稍大于Pt/C催化剂的相应值,表明P进入了Pt晶格,形成了Pt-P合金。 电化学测试表明,Pt-P/C催化剂对氧还原的电催化性能要比商品化的E-TEK Pt/C催化剂好,其还原电位正移了40 mV。 由于Pt-P/C催化剂中Pt-P粒子的平均粒径和相对结晶度与Pt/C催化剂相似,推测Pt-P/C催化剂对氧还原的电催化性能好于Pt/C催化剂的原因可能为P的作用。     

弱酸阳离子交换纤维柱富集-电感耦合等离子体原子发射光谱法测定水样中的稀土

提出了聚丙烯基弱酸性阳离子交换纤维柱富集痕量稀土元素,1.0 mol/L HCl溶液作为洗脱剂,电感耦合等离子体原子发射光谱法测定水样中稀土元素的方法。在优化的试验条件下,弱酸性阳离子交换纤维对La、Nd、Eu、Gd、Er和Yb的吸附容量分别为86.5,98.2,98.7,99.2,84.9,91.5 mg/g;La、...     

离子色谱同时测定中草药中磷硫含量

应用离子色谱法同时测定了硫酸根和磷酸根的含量。用茶叶(GBW10016)、柑橘叶(GBW10020)和黄芪(GBW10028)标准物质来验证方法的准确性,测定值与标准值基本吻合。磷在0.01～100.0μg/mL,硫在0.01～60.00μg/mL范围内呈良好的线性关系(R2≥0.9993),磷和硫的检出限分别为0.0...     

Sm-Co/α-Fe/Sm-Co三层膜磁性能的微磁学模拟

以微磁学理论为基础,利用OOMMF软件采用三维动力学模型模拟研究了Sm-Co/α-Fe/Sm-Co交换耦合三层膜体系的磁滞回线,并对其磁性能分别与软、硬磁层厚度的关系进行了系统的分析.研究结果表明:只有当软磁层厚度小于其临界尺寸(5 nm)时,磁滞同线近似为矩形,此时三层膜完全耦合;硬磁层的厚度对体系的磁性能也有着密切的关系,而且硬磁层的厚度对体系软磁相的临界尺寸也有着一定的影响,只有在合适的软、硬磁含量比例的情况下才能得到具有最佳磁性能的三层膜.     

Rapid isolation of plutonium in environmental solid samples using sequential injection anion exchange chromatography followed by detection with inductively coupled plasma mass spectrometry

This paper reports an automated analytical method for rapid determination of plutonium isotopes (²³⁹Pu and ²⁴⁰Pu) in environmental solid extracts. Anion exchange chromatographic columns were incorporated in a sequential injection (SI) system to undertake the automated separation of plutonium from matrix and interfering elements. The analytical results most distinctly demonstrated that the crosslinkage of the anion exchanger is a key parameter controlling the separation efficiency. AG 1-×4 type resin was selected as the most suitable sorbent material for analyte separation. Investigation of column size effect upon the separation efficiency revealed that small-sized (2 mL) columns sufficed to handle up to 50 g of environmental soil samples. Under the optimum conditions, chemical yields of plutonium exceeded 90% and the decontamination factors for uranium, thorium and lead ranged from 10³ to 10⁴. The determination of plutonium isotopes in three standard/certified reference materials (IAEA-375 soil, IAEA-135 sediment and NIST-4359 seaweed) and two reference samples (Irish Sea sediment and Danish soil) revealed a good agreement with reference/certified values. The SI column-separation method is straightforward and less labor intensive as compared with batch-wise anion exchange chromatographic procedures. Besides, the automated method features low consumption of ion-exchanger and reagents for column washing and elution, with the consequent decrease in the generation of acidic waste, thus bearing green chemical credentials.     

Portable formaldehyde monitoring device using porous glass sensor and its applications in indoor air quality studies

We have developed a portable device for formaldehyde monitoring with both high sensitivity and high temporal resolution, and carried out indoor air formaldehyde concentration analysis. The absorbance difference of the sensor element was measured in the monitoring device at regular intervals of, for example, one hour or 30 min, and the result was converted into the formaldehyde concentration. This was possible because we found that the lutidine derivative that was formed as a yellow product of the reaction between 1-phenyl-1,3-butandione and formaldehyde was stable in porous glass for at least six months. We estimated the reaction rate and to be 0.049 min⁻¹ and the reaction occurred quickly enough for us to monitor hourly changes in the formaldehyde concentration. The detection limit was 5 μg m⁻³ h. We achieved hourly formaldehyde monitoring using the developed device under several indoor conditions, and estimated the air exchange rate and formaldehyde adsorption rate, which we adopted as a new term in the mass balance equation for formaldehyde, in one office.     

On-chip pre-concentration and complexation of [¹⁸F]fluoride ions via regenerable anion exchange particles for radiochemical synthesis of Positron Emission Tomography tracers

Microfluidic approaches have demonstrated a relevant impact on radiochemical reactions involving Positron Emission Tomography (PET) nuclides, due to shorter reaction times and smaller precursor quantities. However, little attention has been given to the integration of the initial pre-concentration and drying of radioactive [(18)F]fluoride ions, required for the labeling of radiotracer compounds. In this work we report the design, fabrication and implementation of a glass microfluidic device filled with recyclable anion exchange particles for the repeated recovery of [(18)F] and [(19)F]fluoride ions. The device was first tested with non radioactive [(19)F]fluoride ions and it was shown to repeatedly trap and elute >95% fluoride over 40 successive experimental runs with no decrease in efficiency. The same device was then tested for the trapping and release of [(18)F]fluoride ions over 20 experiments with no measurable decrease in performance. Finally, the [(18)F]fluoride ions were eluted as a K(18)F/K2.2.2 complex, dried by repeated dissolution in acetonitrile and evaporation of residual water, and reacted with ethyl ditosylate (EtDT) leading to the desired product ([(18)F]fluoroethyltosylate) with 96 ± 3% yield (RCY). The overall time needed for conditioning, trapping, elution and regeneration was less than 6 min. This approach will be of great benefit towards an integrated platform able to perform faster and safer radiochemical synthesis on the micro-scale.     

Novel molecularly imprinted polymer using 1-(α-methyl acrylate)-3-methylimidazolium bromide as functional monomer for simultaneous extraction and determination of water-soluble acid dyes in wastewater and soft drink by solid phase extraction and high performance liquid chromatography

Novel water-compatible molecularly imprinted polymers were synthesized in methanol-water systems with Tratarzine as template and 1-(α-methyl acrylate)-3-methylimidazolium bromide (1-MA-3MI-Br) as functional monomer, which has π-π hydrophobic, hydrogen-bonding and electrostatic interactions with template molecule. 1-MA-3MI-Br molecularly imprinted polymers (1-MA-3MI-Br-MIPs) were used as selective sorbents for the solid-phase extraction (SPE) of water-soluble acid dyes from wastewater and soft drink. The good linearity of the method was obtained in a range of 5.0-2000 μg/L with the correlation coefficient of > 0.999. The detection limits were in a range of 0.13-0.51 μg/L for the water-soluble acid dyes in wastewater and 0.095-0.84 μg/L for those in soft drink. The mean recoveries for the acid dyes are from 89.1% to 101.0% in spiked wastewater and 91.0-101.3% in spiked soft drink. Compared with strongly anion exchange solid phase extraction (SAX-SPE), mixture anion exchange solid phase extraction (MAX-SPE), and 1-MA-3MI-Br non-imprinted solid phase extraction (1-MA-3MI-Br-NISPE), almost all of the matrix interferences were removed by 1-MA-3MI-Br-MISPE, exhibiting higher selectivity, recovery and enrichment ability for the acid dyes and better baselines in the results of HPLC analysis.     

液相色谱-串联质谱法快速测定植物源性食品中的百草枯

建立了水果、蔬菜、豆类和粮谷中百草枯残留的高效液相色谱-串联质谱(HPLC-MS/MS)分析方法.用水提取样品中的百草枯,弱阳离子交换(WCX)固相萃取柱(SPE)净化.采用CAPCELL PAK ST色谱柱(150 mm×2.0mm).乙腈-10 mmol/L乙酸铵水溶液(用甲酸调至pH 4.0)为流动相,以电喷雾离...     

锂离子交换体Li1.5Ti1.625O4的研究(Ⅱ)-H1.5Ti1.625O4的交换性能研究

本文就H1.5Ti1.625O4的pH滴定、分配系数Kd、交换容量、交换等温线、交换速度等离子交换性能进行了研究.研究结果表明,H1.5Ti1.62504对锂离子表现出很好的离子交换选择性及记忆性交换功能.