Performance of a CW pumped Nd:YVO4 amplifier with kHz pulses

Until recently, simple and reliable high repetition-rate laser sources with nanosecond pulses much shorter than from conventional A-O Q-switch lasers were not available. However over the past 2 years we have developed such lasers based on proprietary fast E-O switching technology, which allows designs delivering 1 ns pulses and subnanosecond jitter for good synchronisation. The technology provides pulses with multi-kW peak power and repetition-rates to >100 kHz.Most recently, the performance of these short pulse lasers has been developed further by implementing oscillator/amplifier (master oscillator and power amplifier, MOPA) technology which increases the output to >1 W average power. Here we report on a simple model that has been used to predict the performance of the CW pumped Nd:YVO₄ amplifier used in the MOPA laser. The model is based on the well-known expressions for the saturated gain applying to laser pulses, but more usually applied to pulse-excited amplifiers. The model is shown to allow a good interpretation of the amplifier behaviour for kHz pulses and to be a useful tool for predicting the performance of the MOPA laser.     

氩离子激光器输出光功率稳定度与光反馈应用

通过实验观测氩离子激光器工作电流与输出光功率及其稳定性之间的关系，采用光反馈解决了反馈工作点的设置和跟踪调解，使输出光功率稳定性得到明显提高。     

Resonance method for IR sensing

A highly sensitive method for infrared radiation detection based on thermal resonance in an active bolometer is set forth. An active bolometer is a self-oscillating system consisting of an IR-sensitive cell in a feedback circuit of an adjustable proportional controller. The analysis of an active bolometer autonomous (dark) dynamics reveals that with a generalized gain factor A variation the system evolves from relaxation type towards oscillating and self-oscillating type. When A=A_c, where A_c is a critical value of the generalized gain factor A, the steady state loses stability through self-excited thermal oscillations. The resonance in a system weakly perturbed by IR radiation modulated at self-oscillation frequency q₀[1+exp(iω_ct)] is considered. It is shown that in a small precritical vicinity =(A−A_c)/A_c of the gain factor the amplitude of forced thermal oscillations is proportional to q₀/A_c. The D^* calculation reveals that the detection power of a passive (A=0) bolometer increases with feedback introduction by a factor of 1/||. The detection powers of feasible versions of an active bolometer are compared.     

激光相位成像雷达的研究

利用无合作目标漫反射激光相位测距的原理,对关键单元技术进行分析和设计,研制成一种用于自主式车辆视觉导引的激光相位成像雷达的原理样机.     

射流式单重态氧发生器研究

单重态氧O2 (a1Δg)是迄今唯一能用纯化学反应高效产生的具有长寿命的亚稳激发态分子 .为了考察提出的用两个O2 (1Δ)能量汇集反应生成氧第二单重激发态O2 (b1Σ+ g)以实现近可见短波长化学激光方案的现实性 ,设计和实验了一个氯流量为 3～ 10mmol/s的射流式单重态氧发生器 (JSOG) .考察了三种具有不同孔径和孔数目的喷头、氯气流量和脱水冷阱温度等对JSOG出口的O2 (1Δ)浓度、O2 (1Δ)分压、氯利用率及水蒸气含量的影响 .发现用聚氯乙烯管作冷阱时 ,最佳冷阱介质温度为 - 140～ - 15 0℃ ,对此提出了O2 (1Δ)表面脱活与脱水互相竞争的解释 .在最佳条件下 ,可将O2 (1Δ)气中水分压降低至 4Pa ,这一结果是首次报导     

Analysis of far-infrared laser magnetic resonance spectra of CH2Br at 447.3 and 671.1μm

A simple model has been developed to describe the Zeeman patterns of far-infrared laser magnetic resonance spectra of the monobromomethyl radical CH₂Br observed at 447.3 and 671.1μm. A satisfactory agreement between the experimental spectra of the radical and their simulation with this simple model has been achieved. This approach can be used to gain further information about the structure and the spectrum of this interesting radical.     

高功率飞秒脉冲激光器的进展

概述了超短激光脉冲技术发展的历程。详尽的论述了啁啾脉冲放大技术的原理和一些关键技术 ,并对当今飞秒激光器研究发展的状况进行了综述。在分析其应用前景的基础上 ,进一步指出了这一技术领域未来的发展趋势。结果表明 ,脉冲激光放大系统以后的发展方向是 :更短脉冲 ;追求更高峰值功率 ;连续光谱调谐化 ;向小型化乃至全光纤化发展。     

高功率横流CO2激光器脉冲预电离过程研究

本文给出了对高功率横流CO_2激光器脉冲预电离过程的理论和实验研究.表明了预电离过程中光电离的重要作用.实验结果表明,脉冲预电离可增大高功率横流CO_2.激光器的pd值(p为放电气压、d为放电间隔),增大放电区注入功率密度.对于提高此类型激光器的放电稳定性和输出激光功率是一种技术简单而有效的手段.     

New fluorescence probes for monitoring the kinetics of laser-initiated polymerization

Several new fluorescence probes useful for following photopolymerization have been characterized. Among these are probes which can be used in rapidly gelling monomer mixtures and for photochemical polymerization initiated by very high laser powers. Systems which can be used with polyolacrylates and either with visible initiators or with UV initiators are reported. © 1993 John Wiley & Sons, Inc.     

Heat-treatment studies of molybdenum oxide-monohydrate

The dehydration of molybdic acid, MoO₃---H₂O, was studied by thermal analysis, X-ray diffractometry and FTIR spectroscopy. The results show that an intermediate phase, MoO₃-2/3H₂O is formed at 216 °C and the monoclinic form of MoO₃ is grown above 350 °C. The mechanism of dehydration and structural rearrangement were confirmed by the features of the infrared spectra showing formation of corner-shared MoO₆ octahedra.