Protective Properties of Zinc-Rich Coatings: An Impedance Method Estimate

The impedance of zinc-rich polymer coatings on steel in a 3-% NaCl solution is studied. The electrochemical behavior of the electrode is satisfactorily described by an equivalent circuit that contains a constant-phase element, which reflects fractal properties of the zinc surface in the binder. From the results of calculations of the circuit elements for metal-rich electrodes with different zinc contents computed are fractions of the active area of the surface of the coating and its fractal dimensionality.     

CZE separations of basic proteins at low pH in fused silica capillaries with surfaces modified by silane derivatization and/or adsorption of polar polymers

Mixtures of several basic proteins have been used to test CZE capillaries with surfaces modified by new pretreatment procedures; the performance obtained has been compared with that achieved using capillaries treated by procedures described in the literature. It has been shown that addition of non-ionic polyvinylalcohols (PVA) to CZE buffer solutions deactivates even bare, i.e. untreated, fused silica surfaces and renders them suitable for separations of basic proteins. The performance obtained from such surfaces was comparable with that of capillaries modified by the more elaborate procedures of etching, silanol derivatization, and/or adsorptive coating (again with polymers). A home-made device is described which enables derivatization and coating reactions to be performed on fused silica capillaries under an inert atmosphere, i.e. one free from oxygen and water.     

二甲胺修饰戊二醛交联壳聚糖树脂的制备及性能

研究了在均匀水相介质条件下，采用戊二醛稀溶液制备交联壳聚糖树脂的方法，并以三聚氯氰为活化剂，合成了二甲胺修饰戊二醛交联壳聚糖树脂．研究了该树脂的红外光谱及吸附性能．该树脂对铜(Ⅱ)和牛血清白蛋白(BSA)的吸附容量分别为42mg／g(干)和940mg／g(干)，其吸附行为均符合Freundlich等温吸附模型．该树脂制备工艺简单，机械强度较好，可作为金属离子或蛋白质分离纯化的吸附剂和色谱填料．     

环氧丙烯酸酯的紫外光固化

制备了适于配制紫外光固化涂料的环氧丙烯酸酯，研究了反应温度、阻聚剂、催化剂等因素对环氧树脂与丙烯酸反应的影响；讨论了反应机理和动力学；并利用红外光谱观察了产物的紫外光固化行为。季铵盐能有效地催化环氧树脂和丙烯酸的反应，当其用量为０．６％～１．２％时，在９０～１１０℃反应４．５～８小时后，环氧基转化率大于９７％。由此配制的光固化涂料经紫外光辐照能快速固化。     

Carbon film growth on iron substrates by a CVD method

Carbon film coatings have been produced by a hot‐wall chemical vapor deposition (CVD) method under moderate conditions from pyrolysis of a mixture of propane and argon on an Fe(110) substrate at temperatures of 800–900 °C for different deposition times. The effects of temperature and reaction time on the growth of the carbon films were studied. Field‐emission scanning electron microscopy (FESEM), Raman microscopy, Auger electron spectroscopy (AES) and x‐ray diffraction methods have been performed to study the surface morphologies, growth features and microstructures of the carbon film coatings. The FESEM analyses indicated that carbon films on an Fe substrate consisted of flat‐layer and filamentous morphologies. Raman and AES analyses showed that the carbon initially was crystalline but the degree of disorder in the top layer of the carbon film increased with increasing deposition temperature. High‐resolution transmission electron microscopy studies are also in agreement with Raman results. The same trend was observed when the deposition time was increased from 5 to 30 min. Copyright © 2005 John Wiley & Sons, Ltd.     

The IINS, IR and DFT studies of hydrogen bonds in 6-Furfuryl and 6-Benzylaminopurines

FTIR and IINS spectra of 6-Furfurylaminopurine (6-FAP) and 6-Benzylaminopurine (6-BAP) taken at different temperatures have been analysed and compared with the spectra calculated by the ab initio DFT/B3LYP method and the semiempirical PM3 method in the isolated molecule approximation, for the tautomers N3-H, N7-H and N9-H, and dimers with hydrogen bonds. For 6-FAP the best agreement between the calculated and experimental (at 20 K) spectra has been found for the N9-H tautomer, whose structure was established by X-ray diffraction. For 6-BAP the analogous agreement for the N9-H tautomer structure has been poor and much better for the N7-H tautomer. The vibrational spectra calculated for dimers of the molecules studied involved in hydrogen bonds, permitted also an interpretation of the bands whose positions and FWHM in the FTIR spectra changed with temperature.     

Coaxial electrospinning core-shell fibers for self-healing scratch on coatings

Polystyrene (PS) fibers with core-shell structure were prepared by coaxial electrostatic spinning using liquid epoxy or curing agent as the core and PS solution as the shell. Scratch self-healing coatings were realized by using the healant-loaded core-shell fibers in the matrix.     

Preparation and properties of sol-gel coating films

The present state of our knowledge on sol-gel coating films has been reviewed. A qualitative discussion is made on the limit of the film thickness which can be achieved in the sol-gel method and the factors affecting the film thickness. Considering that properties of the film are intimately related to the microstructure, types of microstructures accomplished by the sol-gel coating are introduced with examples.     

固相氯化法合成氯化聚乙烯的红外光谱研究

本文研究在不同条件固相氯化聚乙烯(CPE)的红外光谱,探讨了一步和两步氯化合成的CPE的结构差别,着重讨论了两步氯化的CPE结构特点。从观察表征结晶结构和—(CH_2)_n—链段氯分布的特征频率变化表明,低温固相氯化主要发生在无定形区,并且在CPE中形成高氯化和低氯化链段(或未氯化)的嵌段结构。在两步固相氯化时,晶区受到较大程度的破坏,氯化作用已不局限在无定形区,其结晶结构的破坏主要同第二步氯化程度有关,即使CPE氯含量相同,若前后两步氯化程度不同,结构有很大差异。     

不同交联度的杜仲胶的红外光谱研究

研究了不同交联度的杜仲胶在室温及加热后红外光谱的变化规律．发现在室温下测定的样品红外光谱在低波数内对应链段变形振动的几个特征峰、加热后会消失或弥散，而交联度的改变对其影响不大，即使材料中结晶完全消失而变成高弹态．因此，推测这些特微峰的存在，应该和杜仲胶弹性网络中交联点间链段存在着明显的构象规整性有关．