Microwave Thermolysis VII: Oxidative Coupling of Thiol Acetates and Esters Using “Clayan” in Dry Media

Disulfide bond formation by the oxidative cleavage of thiol acetates and thiol esters using “Clayan”s under microwave irradiation is described. The non-metallic and inexpensive nature of the reagent are the important features of the procedure.     

New measurements and analysis of the far-infrared spectrum of CH2DOH in the lowest torsional vibrational state (e0)

In this work the far infrared (FIR) absorption spectrum has been measured for the asymmetrically mono deuterated Methanol (CH₂DOH) species in the wavenumber range of 15–1200 cm⁻¹ better accuracy and signal/noise ratio than known before. Assignments have been made for b-type transitions in the lowest lying torsional vibrational state trans-(e₀) for a wide range of rotational angular momentum. The assignments have been rigorously confirmed by the residual loop defect methods. The ^rR–branch wavenumbers are analyzed by the usual state dependent expansion parameters and the Q-Branch origins. These origins have been used to calculate the torsional and torsional-rotation interaction contributions. These findings are in good agreement with predicted from the Hamiltonian model described in recent publications. A large number of assignments have also been made in the millimeter wave spectrum recorded earlier and thereby evaluated the asymmetry splitting parameters for 4 different axial rotational angular momentum quantum numbers. The analysis and interpretation of the spectra are reported. New assignments for about 260 transitions are included the text and a catalog of about 1500 transitions belonging to the e₀ species is prepared (Appendix 1) and is made available through the open server in “Research Gate” and will be freely available to others.     

Analysis of Urinary Calculi Containing Triamterene. Presence of A Glucuronic Metabolite.

Abstract

Urinary calculi containing triamterene were described since 1979. We have studied calculi, obtained from an anuric patient, by surgery. This paper describes the advanced techniques that were used, such as infrared spectroscopy, nuclear magnetic resonance, mass spectrometry associated with thin-layer chromatography or gas chromatography, to show the presence of unusual compounds. Six metabolites are found, among them pure triamterene (96%), hydroxy-triamterene, and a particular metabolite containing glucuronic acid.     

Quantitative modeling and mapping of blistering zone of the Magoksa Temple stone pagoda (13th century,Republic of Korea) by graduated heating thermography

Blistering occurring at the stone’s subsurface layer is easily overlooked compared to different deterioration types, so conservation treatments are not applied often. Therefore, non-destructive detection and mapping of blistering zones with the infrared thermography are very important for preservation of the original forms of stone monuments. In this study, the critical temperature and transitional zone of the blistering zone were established by drawing the temperature distribution curve and the mapping for blistering zone was completed by monochrome process and extraction of vector lines. Analysis of the blistering deterioration degree of the Magoksa Temple stone pagoda with the quantitative modeling yielded a total area and average rate of blistering zones of approximately 2.6 m² and 7.4%, respectively. Thus, there is a high probability of scaling on the stone pagoda (area of approximately 2.6 m²) if conservation treatment is not applied to the blistering zones as early as possible. Therefore, the blistering zones require joining and filling, and state changes of the blistering zones should be continuously monitored after completion of the intensive conservation treatments. Modeling will improve the reliability of deterioration maps by mapping for blistering zone; most deterioration maps to date have overlooked blistering zones.     

Evaluation of nano-slot antenna for mid-infrared detectors

To improve the response performance of superconducting infrared detectors, we propose using a photonic antenna with a micro-detector in conjunction with a nano-structure. In this paper, we report evaluation results that show the basic characteristics of a photonic antenna in the mid-infrared region. The antenna consists of a nano-slot antenna and a thin-film load resistance placed in the center of the antenna. The antennas were designed for operation at approximately several tens of THz by using an electromagnetic simulator. Through measurements of the spectral reflectance characteristics, clear absorptions caused by the antenna properties were observed at approximately 50 THz, and high polarization dependencies were also observed. The results of the simulation qualitatively agreed with the results of the experiment. The effective area of the antenna was also evaluated and was found to be approximately 3.5 μm² at 54 THz.     

Infrared ellipsometry of nanometric anisotropic dielectric layers on absorbing materials

An inversion problem of infrared ellipsometry is resolved on the basis of a fresh mathematical approach, which does not use the traditional regression analysis for data handling and has no need of initial guesses for the desired parameters. It is shown that obtained simple analytical equations for ellipsometric quantities open up new possibilities for determining optical parameters of an anisotropic ultrathin layer. The novel method possesses very high sensitivity because it is based on the phase conversion measurements of polarized reflected light. The method is tested using a numerical simulation and the results demonstrate clearly that it is successfully applicable for nanometric layers in the infrared spectral region.     

Proposition of a compensated pixelwise calibration for photonic infrared cameras and comparison to classic calibration procedures: Case of thermoelastic stress analysis

In this paper, we propose a compensated pixelwise calibration that integrates the effects of the camera housing temperature. The results of this calibration are compared on black body images to classic two points Non Uniformity Correction based calibrations, compensated or not. It is shown that the proposed approach leads to a significant improvement in the thermal resolution with a reduction in the mean error as well as the standard deviation. The approach is finally challenged on a real case measurement focusing on thermoelasticity. The gain in terms of accuracy measurement is highlighted by comparing the proposed calibration to classic calibrations and the scope of interest of this new calibration is discussed.     

Probing defect species on real surfaces from the analysis of the spectral profile of admolecules

The analysis of changes in the vibrational spectrum of infrared active molecules adsorbed on a ionic surface containing point or extended defects can be an efficient method to determine the nature and density of surface defects. We study the infrared response of ammonia molecules deposited on a ionic surface of MgO containing charge vacancies and dipolar defects in various concentrations and distributions and show significant changes assigned to the defects signature. A Monte Carlo approach is used to randomly deposit the probe molecules on the surface displaying random or regularly arranged defects at low temperature.     

Line intensities of acetylene: New measurements in the 1.5-μm spectral region and global modelling in the ΔP=10 series

Using the Fourier transform spectra of the acetylene molecule recorded near 1.5-μm, the intensities of 111 lines belonging to seven hot bands of the main isotopologue ¹²C₂H₂ have been retrieved by means of a multispectrum fitting procedure. Considering the density of lines in the spectra, and the fact that the measured bands are the weakest observed, the accuracy of the measurements is around 10%. At first stage, an empirical treatment of these data has been performed, leading to the vibrational transition dipole moment squared and some Herman–Wallis coefficients. Then the measured line intensities of this work and collected ones from the literature have been treated simultaneously within the framework of the effective operator approach.     

Improvement of hydrophilic properties of electrospun polyamide-imide fibrous mats by atmospheric-pressure plasma treatment

Polyamide-imide (PAI) fibrous mats were fabricated through electrospinning and further treated with atmospheric-pressure plasma. The surface characteristics of the PAI fibrous mats were examined to determine the effect of plasma treatment on the hydrophilic properties. FT-IR, X-ray photoelectron spectroscopy, and contact-angle analysis indicated that the hydrophilicity of the PAI fibrous mats increased upon the introduction of hydrophilic groups by plasma treatment. The concentration of functional groups, including oxygen, and the surface roughness of the PAI fibrous mats increased with increasing treatment time. The optimum plasma treatment time for surface modification of the PAI fibrous mats under atmospheric pressure was 120 s.