首页 | 本学科首页   官方微博 | 高级检索  
文章检索
  按 检索   检索词:      
出版年份:   被引次数:   他引次数: 提示:输入*表示无穷大
  收费全文   9476篇
  免费   960篇
  国内免费   1133篇
化学   5362篇
晶体学   82篇
力学   1550篇
综合类   88篇
数学   448篇
物理学   4039篇
  2024年   25篇
  2023年   141篇
  2022年   205篇
  2021年   195篇
  2020年   262篇
  2019年   241篇
  2018年   180篇
  2017年   337篇
  2016年   445篇
  2015年   407篇
  2014年   449篇
  2013年   890篇
  2012年   531篇
  2011年   733篇
  2010年   543篇
  2009年   643篇
  2008年   570篇
  2007年   624篇
  2006年   632篇
  2005年   525篇
  2004年   433篇
  2003年   376篇
  2002年   273篇
  2001年   220篇
  2000年   215篇
  1999年   185篇
  1998年   176篇
  1997年   155篇
  1996年   156篇
  1995年   130篇
  1994年   124篇
  1993年   67篇
  1992年   60篇
  1991年   56篇
  1990年   56篇
  1989年   68篇
  1988年   63篇
  1987年   41篇
  1986年   20篇
  1985年   20篇
  1984年   18篇
  1983年   11篇
  1982年   19篇
  1981年   8篇
  1980年   13篇
  1979年   12篇
  1978年   4篇
  1973年   2篇
  1972年   2篇
  1971年   2篇
排序方式: 共有10000条查询结果,搜索用时 46 毫秒
101.
高效液相色谱法测定细胞分裂素的方法研究   总被引:4,自引:0,他引:4  
利用高效液相色谱法测定水稻愈伤组织和微生物发酵产品中的玉米素,二氢玉米素,核糖基玉米素和核糖基二氢玉米素。样品用抽提液抽提,经Bio-Rex70弱阳离子交换柱和XAD-7/Sep-pakC18复合柱净化和富集后,直接用HPLC分析,方法回收率达94%~84%,相对标准偏差小于3.3%。最低检测限达2.0ng。  相似文献   
102.
Mg-Nd-Zr-Zn合金的制备及钕对合金组织性能的影响   总被引:9,自引:0,他引:9  
在RJ-2溶剂和Be的联合保护下制备了Mg-Nd-Zr-Zn系合金. 通过对合金组织的分析, 以及Nd对组织性能影响的研究, 试制出了Nd添加量合理的Mg-Nd-Zr-Zn合金. 经过测试, 认为Nd添加量的增加提高了合金的250 ℃高温抗拉强度, 当Nd添加量超过2.8%时, 合金的高温强化作用不十分显著. Mg-Nd-Zr-Zn合金在250 ℃时的拉伸断裂方式主要是韧性断裂.  相似文献   
103.
104.
高纯度植酸的制备   总被引:4,自引:0,他引:4  
高纯度植酸的制备孙定光胡佩廖显威(四川师范大学化学系成都610066)关键词植酸制备高纯试剂中图分类号O629.9植酸(PhyticAcid)又名肌醇六磷酸酯,分子式:C6H18O24P6,结构为植酸是中等强度的有机酸,因其结构特殊,具极强的螯合作用...  相似文献   
105.
本文研究了磷钨钼钒四元杂多酸及其还原产物杂多蓝的形成条件、光度性质、组成和在测定高速钢中高钼的应用。试验表明,磷钨钼钒杂多蓝光度法测定钼具有新颖性、高选择性、较高准确性和简便性,适于高速钢中>1%Mo的测定。  相似文献   
106.
用非水滴定法和Hammett系列指示剂测定了COS水解碱改性γ-Al_2O_3催化剂的表面碱强度分布.发现表面碱强度分布不均匀与表面能量分布不均匀相呼应.采用零点酸碱强度(H_(0,max))及碱中心区域分析法,Bronsted催化定律,进一步证实COS水解反应具有明显碱催化特征,较高活性催化剂的H_(0,max)一般为10左右,对COS水解反应起主要作用的碱性中心的碱强度(H_0)为4.8≤H_0≤9.8.对碱金属氧化物改性后的γ-Al_2O_3催化剂,Bronsted规律在每个碱强度分区域内是适用的.  相似文献   
107.
Economic evaluations of the capital costs for anaerobic digestion systems for gas production show that the reactor is a significant cost component. The successful application of high solids digestion of processed MSW (e.g., greater than 10% solids within the digester) would allow a decrease in reactor volume with maintenance of relatively high gas production rates. However, high solids slurries do not mix well in conventional stirred tank reactors. A horizontal shaft, hydraulically driven reactor was designed and fabricated to test the anaerobic digestion of high solids concentrations. Digester performance was evaluated as a function of experimental parameters such as nutrient requirements, feeding rates, pH control, and agitator design/ rotation speed; horsepower of mixing was also evaluated for the reactor. Several startup protocols were examined to obtain a biologically stable anaerobic fermentation at high solids levels.  相似文献   
108.
Standardized mixing procedure was applied to the analysis of flocculation of polystyrene latex (PSL) particles with polyelectrolytes. After confirming the initial enhancement of flocculation rate in the very beginning followed by abrupt stop with excess dosage, attention was shifted to the system of moderate dosage. In the former, effects of ionic strength were further analyzed to find the consistency with adsorption isotherm. In the latter, flocculation started slowly in the beginning, sometime slower than salt-induced rapid coagulation, however, the rate gradually increases in the middle stage. Often, the increased rate exceeds that of salt-induced rapid coagulation. This behavior emerged more clearly in the case of lower ionic strength. This is the indication that the rate of relaxation of polymer on the colloidal surface is a function of surface coverage and ionic strength. The ultimate degree of flocculation is usually higher than that observed for excess dosage. The size distribution of flocs was also examined, however, no clear difference between different experimental conditions was confirmed for the same degree of flocculation.  相似文献   
109.
微合金钢中稀土对沉淀相和性能的影响   总被引:3,自引:5,他引:3  
在Nb(Ti,V)微合金钢中,主要沉淀相分别为Nb(C,N),(Nb,Ti)(C,N)和V(C,N)。稀土降低沉淀相完全溶解的温度,增大奥氏体中沉淀相析出的孕育期,降低析出速率,抑制奥氏体中沉淀相的析出,在铁素体相区,稀土提高沉淀相的析出速率和数量,促进沉淀相的析出,其中稀土对铌沉淀相析出的作用影响最强。锻态钢中,稀土有促进细化球化析出相的作用,随稀土含量增加,沉淀相析出数量增加,但过量稀土,促进作用又减弱,稀土在保持微合金钢强度的情况下,显著改善其冲击韧性,尤其是低温韧性,微合金钢中添加适量稀土可获得更佳的综合性能。  相似文献   
110.
火花激发原子发射光谱法应用于直径小于8mm的不锈钢线材的分析,对此类试样应用了一种特制的夹具,用块状标准样品制作工作曲线。由于线状试样和块状标准样品之间的形状差异所产生的系统不确定度借采用同类型标样作校正,对共存元素的相互干扰也采用了相应的校正方法。其它分析条件,包括严格的制样工序,氩气的纯度要求及其流量控制,以及光源的最佳条件等,作了深入的试验。按所提出的方法测定了不锈钢线材试样中碳、硅、锰、磷、硫、铬、镍及钛等8个元素。经校正后的结果与化学法测得结果相符。  相似文献   
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号