Some thermodynamic aspects of nitrides in materials science

The energies of combustion in fluorine of gallium nitride and indium nitride in wurzite crystalline structure have been measured in a two-compartment calorimetric bomb, and new standard molar enthalpies of formation have been calculated: Δ_fH_m⁰(GaN(cr) 298.15 K)= –(163.7±4.2) kJ mol^–1 and Δ_fH_m⁰(InN(cr) 298.15 K)= –(146.5±4.6) kJ mol^–1 . Comparison with the recommended values of the Δ_fH_m⁰ nitrides from the literature is also presented.     

铁掺杂TiO2纳米管阵列对不锈钢的光生阴极保护

在含FeSO4的HF、H2SO4/HF、NaF/Na2SO4溶液中,通过电化学阳极氧化直接在纯钛表面制备Fe 掺杂的TiO2(Fe-TiO2)纳米管阵列. 应用X射线衍射(XRD)、扫描电子显微镜(SEM)、紫外-可见吸收光谱(UV-Vis)、X 射线光电子能谱(XPS)等手段对纳米管阵列的结构、形貌及化学组成进行表征. 利用光电化学测量研究Fe-TiO2纳米管阵列在不同波长范围内的光电响应特性和光生阴极保护行为. 考察了温度、时间、掺杂含量等参数对TiO2纳米管阵列的几何尺寸、形貌和光电性能的影响. 结果表明, Fe掺杂可有效减缓TiO2纳米管阵列载流子的复合, 窄化TiO2带隙宽度, Fe-TiO2在410-650 nm范围显示强吸收, 并使光谱响应扩展到波长大于400 nm 的可见光区. 实验结果还表明, Fe-TiO2纳米管阵列对316不锈钢(316L)具有良好的光生阴极保护作用, 暗态下阴极保护作用可继续维持.     

Effect of chemical potential on the computer simulation of hydrogen storage in single walled carbon nanotubes

Hydrogen is a kind of clean, sustainable and renewable energy carrier. Of the problems to be solved for the utilization of hydrogen energy, how to store and transport hydrogen has been given high priority on the research agenda. Recently, carbon nanotubes (CNTs) were reported to be very promising candidates for hydrogen uptake[1], which may have possibility to satisfy the benchmark set by the US Department of Energy (DOE) Hydrogen Plan for fuel cell powered vehicles: a gravimetric density …     

Electrochemical Behavior and Determination of Uric Acid at Single-Walled Carbon Nanotube Modified Gold Electrodes

The voltammetric behavior of uric acid was studied at a single-walled carbon nanotube (SWNT) modified gold electrode. Uric acid can effectively accumulate at this electrode and produce an anodic peak at about 0.45 V (vs. SCE) in pH 5.0 sodium acetate buffer solutions (HAc-NaAc). The experimental parameters, such as solution pH, accumulation time, and amount of SWNT, were optimized for determination. Under the optimum conditions, the anodic peak current is linear to the uric acid concentration over the range of 1.0×10⁻⁷ M to 2.5×10⁻⁵ M with a correlation coefficient of 0.998. The detection limit was 5.0×10⁻⁸ M for 60 s accumulation. The electrode could be easily regenerated and exhibited good stability. A 5.0×10⁻⁶ M uric acid solution was measured ten times using the same electrode, and the relative standard deviation of the peak current was 1.3%. This method was successfully applied to the determination of uric acid in human urine samples, and the recovery was 97–99%. The feasibility for simultaneous determination of xanthine, ascorbic acid and uric acid was discussed. These species did not interfere with each other in a certain concentration range. The influence of some surfactants on the anodic peak was also examined.     

Effect of carbon nanotubes on the crystallization and properties of polypropylene

The effect of different concentrations of single‐walled carbon nanotubes (SWNTs) on the nonisothermal crystallization kinetics, morphology, and mechanical properties of polypropylene (PP) matrix composites obtained by melt compounding was investigated by means of X‐ray diffraction, differential scanning calorimetry, optical and scanning electron microscopy, and dynamic mechanical thermal analysis. Microscopy showed well‐dispersed nanotube ropes together with small and large aggregates. The modulus was found to increase by about 75% at a level of 0.5 wt % nanotubes. The SWNTs displayed a clear nucleating effect on the PP crystallization, favoring the α crystalline form rather than the β form. The crystallization kinetics analysis showed a significant increase in activation energy on incorporating nanotubes. © 2005 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 43: 2445–2453, 2005     

碳纳米管/ZnO纳米复合体的制备和表征

通过将不同直径的ZnO纳米颗粒与碳纳米管连接制备了碳纳米管/ZnO纳米复合体. 将团聚的ZnO纳米颗粒分散并用表面活性剂CTAB使纳米颗粒带正电. 化学氧化碳纳米管使其带负电. ZnO/CTAB微团通过碳管表面羧基与CTAB的静电作用与碳纳米管连接形成纳米复合体. 研究了复合体形成的不同实验条件, 表征了碳纳米管/ZnO纳米复合体的结构并研究了纳米复合体的光学特性. 研究表明, 与碳纳米管连接的ZnO纳米颗粒是互不连接的并保持量子点的特性. 光致发光研究表明ZnO纳米颗粒的激发在纳米复合体中有淬灭.     

失效原子力显微镜硅针尖再生

原子力显微镜的传统商品硅针尖在使用过程中极易因磨损而失效，本文研究了一种在实验室条件下简易可行的回收利用失效硅针尖的方法。在原子力显微镜的敲击模式下使用曲率半径大于100 nm的失效硅针尖对生长单壁碳纳米管的样品表面进行扫描，把样品表面的单壁碳纳米管管束粘接到硅针尖上，可制得直径在5～20 nm的碳纳米管针尖。实验对碳纳米管针尖和新的商品硅针尖进行了成像对比，所制备的碳纳米管针尖不仅在成像分辨率而且在成像稳定性上都优于新的商品硅针尖。     

Surface cavities produced by high‐dose nitrogen ion implantation into silicon

Nitrogen ion implantation (24 keV, 4.6 × 10¹⁷ cm^?2) into (100) a p‐type silicon wafer material and a subsequent electron beam annealing at 1100 °C for 15 s under high vacuum conditions leads to the formation of an uneven surface in the implanted region caused by nitrogen bubbles beneath the surface. Annealing at 1200 °C for 300 s results in surface cavities with a mean diameter of 350 nm and a surface coverage of 3–4% and an average depth of ～60 nm. Nuclear reaction analysis reveals that the nitrogen concentration in the as‐implanted state exceeds 57 at%, the value of stoichiometric Si₃N₄. Annealing at 1100 °C for 15 s slightly reduces the nitrogen peak concentration, whereas annealing at 1200 °C for 300 s induces a significant alteration to the shape of the nitrogen depth profile coupled with the lowering of the concentration close to the stoichiometry of Si₃N₄. The results present a new method of producing sub‐micrometre cavities embedded in a thin silicon nitride film on wafer silicon which may lead to novel micro‐electronic and biotechnology applications. Copyright © 2007 John Wiley & Sons, Ltd.     

Ein neues Samariumnitridsulfid: Sm4N2S3

A New Samarium Nitride Sulfide: Sm₄N₂S₃ The oxidation of samarium with sulfur in the presence of SmCl₃ and NaN₃ as nitrogen source (molar ratio: 12:9:4:2, evacuated silica vessel, some NaCl as flux, 850°C, 7 d) yields Sm₄N₂S₃ as lath-shaped, dark red single crystals. The by-products (NaCl and NaSm₂Cl₆) are rinsed with water from the crude product. The crystal structure of Sm₄N₂S₃ (monoclinic, C2/m (no. 12), Z = 2, a = 1 318.04(12), b = 391.57(2), c = 1 031.76(9) pm, β = 130.874(6)°, R = 0.036, R_w = 0.031) contains two crystallographically different Sm³⁺, both in sixfold coordination of the anions. Besides distorted octahedra [(Sm1)N₃S₃] and [(Sm2)NS₅], tetrahedra [(N^3?)(Sm)] connected via two cis-oriented edges to form chains [N(Sm1)_3/3(Sm2)_1/1]³⁺ build up the Mayn structural feature. These are arranged in the fashion of a closest packing of rods and held together by two crystallographically different S^2? anions which take care for charge neutrality and three-dimensional interconnection.     

载氧化钌碳纳米管超级电容器电极

研究了一种采用溶胶-凝胶方法制备超细氧化钌粉末的新方法，该方法制备的氧化钌电极材料在250 ℃热处理后具有570 F•g－1的比电容量并具有典型的多孔特征.通过在碳纳米管表面化学沉积氧化钌的方法制备了不同成分的氧化钌/碳纳米管复合电极,并探讨了其电化学伏安特性和直流充放电特性.该复合电极具有高能量密度特性，同时还具有良好的高功率放电特性.