对MDTA中测样品热容量的准恒温法的评述

对用调制差热分析（ＭＤＴＡ）准恒温法测样品热容量的情形进行了讨论。通过结合最基本的热传导定律和ＭＤＴＡ模型，指出了目前国际上测量样品热容量的准恒温法只能得到在所测温度范围内的物质热容量平均值，调制温度的幅度越大或调制频率越高，所得到的热容量数据越平滑。在所测温度范围内样品热容量基本不变时，用ＭＤＴＡ准恒温法较好；但当样品热容量在所测温度范围内有明显变化时，用传统差热分析法（ＤＴＡ）更好一些。     

Thermal properties of rare earth dodecaborides

We have measured heat capacity and thermal expansion of rare earth dodecaborides REB₁₂ (RE=Y, Tb-Tm, Lu). YB₁₂ and LuB₁₂ are diamagnetics whereas the other dodecaborides are ordered antiferromagnetically. The amplitude of the heat capacity discontinuity at the Néel temperature and the shape of the heat capacity variation in the critical region for all these antiferromagnetics are characteristics for amplitude-modulated magnetic structures. In the ordered state TbB₁₂ reveals two first-order phase transitions, most likely due to magnetic structure changes. The heat capacity of ErB₁₂ just below the Néel point shows an anomaly of unclear origin. From the Schottky contribution to the heat capacity we have determined crystal field parameters. They are completely different than that is estimated from Point Charge Model.     

Ion-exchange selectivity and chromatographic separation of trivalent metals on titanium antimonate

Summary The ion exchange selectivity of trivalent metal ions has been determined on titanium antimonate cation exchanger prepared by coprecipitation of antimony to titanium at different mole ratios. The selectivity sequence Al³⁺<Cr³⁺<Ga³⁺<In³⁺<Fe³⁺ was found for trivalent metal ions at an initial concentration of 10^–4 mol dm^–3 in nitric acid media. A high separation factor ^Ga/Al = Kd^Ga/Kd^Al, 4.8×10³, was observed for the Ga³⁺–Al³⁺ pair on titanium antimonate with an antimony to titanium ratio of 0.34. The effective separation of Ga³⁺ and In³⁺ from Al³⁺ was achieved using a 3 cm×0.5 cm i.d. column containing titanium antimonate with an antimony to titanium ratio of 0.34.     

Theoretical study of the effect of frit quality on chromatography using computational fluid dynamics

Summary Frits at both ends of a chromatographic column, especially for a preparative column, have significant influence on the flow distribution within the column and thus the column efficiency. However, frits have received little attention from chromatographers in the past. Here a theoretical study was conducted with the aid of CFD software FLUENT to investigate the effect of frits on the performance of homogeneous and heterogeneous chromatographic columns. A dimensionless number,FQ, was applied to characterize frit quality. This study visualized how frit quality affects the flow distribution and the concentration band, the shape of eluted pulse at the colum exit and column efficiency. Simulation results show that the development length of the flow distribution is related toFQ but has nothing to do with the packing heterogeneity. The curvature of the concentration band in a column depends onFQ and packing quality. This study shows column efficiency can be improved significantly by increasingFQ and/or frit permeability.     

Novel aromatic polyimides derived from benzofuro[2,3-b]benzofuran-2,3,8,9-tetracarboxylic dianhydride (BBTDA)

Benzofuro[2,3-b]benzofuran-2,3,8,9-tetracarboxylic dianhydride (BBTDA) is introduced as a monomer for the synthesis of a series of novel polyimides with enhanced high thermal stability. Polyimides derived from BBTDA and aromatic diamines showed high glass transition (T_g>296 °C) and degradation (T₅>455 °C) temperatures, and were soluble in organic solvents (i.e. N-methyl pyrrolidone (NMP), N,N^′-dimethylformamide (DMF), N,N^′-dimethylacetamide (DMAc)). The polymerization yielded high-molecular-weight polyimides with inherent viscosities ranging from 1.75 to 2.14 dl/g. The polymers were characterized by IR and elemental analysis.     

Factors affecting physicochemical properties of liposomes prepared with hydrogenated purified egg yolk lecithins by the microencapsulation vesicle method

We examined hydrogenated purified egg yolk lecithins, having practical advantages over non-hydrogenated ones, as liposomal membrane materials. Liposomes were prepared by the microencapsulation vesicle (MCV) method in which liposomes are formed through two-step emulsification and dispersion. Three types of purified egg yolk lecithins with different iodine values were examined after being dissolved in one of three lipid solvents. The liposome size increased as the temperature during the second emulsification increased, being closer to the boiling temperature of the solvent. The preparation temperature in relation to the transition temperature of each lecithin was also a factor affecting liposome sizes. As for the encapsulation efficiencies of the model compound calcein in liposomes, they differed mainly depending on the solubility of each lecithin in a lipid solvent and it was more obvious in hydrogenated lecithins. A high preparation temperature resulted in lower encapsulation efficiencies, suggesting that leakage of encapsulated calcein was facilitated at high temperature in the MCV methods. There was a significant correlation between liposome sizes and encapsulation efficiencies in non-hydrogenated purified egg yolk lecithin but not in hydrogenated ones. When using hydrogenated purified egg yolk lecithins as liposomal membrane materials, it was suggested that a lipid solvent should be chosen so that a lecithin completely dissolves under the preparation condition in order to achieve a higher encapsulation efficiency. Smaller liposome particles were obtained when the second emulsification was performed at a lower temperature compared with the boiling point of the lipid solvent. These findings can be applied to control encapsulation efficiencies and particle sizes in each particular liposome preparation enclosing therapeutic agents.     

Cyclodextrin Solubilization of the Antibacterial Agents Triclosan and Triclocarban: Effect of Ionization and Polymers

The natural β-cyclodextrin (βCD) and its complexes have limited solubility in aqueous solutions. This low aqueous solubility, as well as low aqueous solubility of the guest molecule (i.e. triclosan or triclocarban (TCC)), can result in low complexation efficiency (CE). The purpose of this study was to enhance the apparent intrinsic solubility (S ₀) of the guest molecule and its βCD complexes through ionization and addition of auxiliary compounds such as polymers, amino acids and metal ions. Both triclosan (pK _a 7.9) and TCC (pK _a 12.7) are weak acids. Addition of ethanol to the complexation medium enhanced S ₀ of both triclosan and TCC but at the same time ethanol lowered the stability constant (K _c ) of their βCD complexes resulting in overall lowering of CE. Addition of small amount of water-soluble polymers enhanced the βCD solubilization of both guests, and addition lysine enhanced the solubilization of TCC. Ionization of triclosan resulted in significant enhancement of CE and enhanced triclosan release from tablets containing triclosan/βCD complex. The effect of ionization was not as pronounced in the case of TCC.This revised version was published online in July 2005 with a corrected issue number.     

Polymer-protected palladium nanoparticles. Morphologies and catalytic selectivities

Colloidal palladium nanocatalysts prepared by in situ reductions of palladium chloride were immobilized and protected by either of two water-soluble polymers. The particle sizes and size distributions of the palladium colloids were determined by transmission electron microscopy. Their selectivities as catalysts were determined by comparing the extents of hydrogenation of carefully chosen pairs of small-molecule olefins. There was found to be high hydrogenation selectivity with regard to cyclic vs. noncyclic olefins. Selectivity was relatively low, however, among olefins that differed only in size (such as hexene vs. octene), or olefins differing only with regard to the positions of the double bonds (such as 1-octene vs. 3-octene). Selectivity could be improved by careful choice of the immobilizing polymer, and by its use at relatively high concentrations.     

Modification of silica gel with diethylamino group by novel reaction and its characterization

1,3,5,7-Tetramethylcyclotetrasiloxane (H₄) was deposited on silica gel at 80°C by utilizing a chemical vapor deposition (CVD) method, where it was catalytically polymerized to form a surface coating of polymethylsiloxane (PMS). Treated silica gel (PMS-Si) increased in weight up to a plateau level, and there was no further increase with increasing reaction time. The film of PMS was partially cross linked; typical values of crosslinking ratio and film thickness were 2% and 0.6 nm, respectively. An anionic ion exchanger containing diethylamino groups was synthesized from PMS-Si by hydrosilylation of allyl glycidyl ether followed by treatment with diethylamine. Its structure was confirmed by¹³C and²⁹Si CP/MAS NMR spectroscopy and FT-IR spectrophotometry. Characterization of silica gel (DEA-Si) modified with diethylamino group was evaluated by a packing of the column for liquid chromatography. As a mixture of five nucleotides was completely separated, it was recognized that DEA-Si was operated by ion exchange action. Because the surface of the silica gel was covered with hydrophobic PMS, the peak heights and retention times did not change after washing of the column with alkaline solution.     

High temperature enthalpy and heat capacity of GaN

The heat capacity and the heat content of gallium nitride were measured by calvet calorimetry (320-570 K) and by drop calorimetry (670-1270 K), respectively. The temperature dependence of the heat capacity in the form C_pm=49.552+5.440×10⁻³T−2.190×10⁶T⁻²+2.460×10⁸T⁻³ was derived by the least squares method. Furthermore, thermodynamic functions calculated on the basis of our experimental results and literature data on the molar entropy and the heat of formation of GaN are given.