Structural studies of Cr-doped mullite derived from single-phase precursors

Cr-doped mullites were prepared from single-phase precursors containing up to 9.60 wt% Cr₂O₃ using a sol-gel technique followed by thermal treatment. Particle induced X-ray emission spectroscopy and X-ray powder diffraction were used to characterize the samples. Mullites were orthorhombic, space group Pbam. Cr doping caused the increase of unit-cell parameters. Strongest expansion was noticed along c-axis followed by a and b (Δc/c=0.089, Δa/a=0.061, Δb/b=0.045% per mole Cr₂O₃). A second phase, namely θ-(Al,Cr)₂O₃, was revealed by XRD in the sample containing 9.60 wt% Cr₂O₃. The structure of mullites was refined by the Rietveld method, location of Cr³⁺ was performed by the EPR spectroscopy. At low chromium doping level (Cr₂O₃ content less than ∼5 wt%) Cr³⁺ ions were substituted for Al³⁺ in the AlO₆ octahedra of the mullite structure (M1 site). For higher doping level, Cr³⁺ ions were additionally substituted for Al³⁺ in the AlO₆ octahedra of the second phase [θ-(Al,Cr)₂O₃ at 1400 °C, or α-(Al,Cr)₂O₃ at 1600 °C] which segregated in the system. Substitution of Cr³⁺ for Al³⁺ on M1 site in the mullite structure resulted in increase of average distances in (M1)O₆ octahedron and decrease of average distances in T*O₄ tetrahedron, while average distances in TO₄ tetrahedron stayed almost constant.     

无催化纳米氧化锌的制备及其光学性质研究

本文采用无催化剂直接蒸发高纯Zn粉,在800℃氧气氛条件下,在Si(111)衬底上生长得到以四角状为主的纳米ZnO(T-ZnO)。T-ZnO纳米线每个角约互成110°,长度约为1.5μm,直径100nm左右;Raman分析表明E2(H)普遍存在于各形态的ZnO;光致发光光谱表明,T-ZnO纳米线的光致发光除了与材料性质有关,还与杂质缺陷有关,蓝绿光带是ZnO的缺陷产生的。     

Synthesis and Properties of a Heteronuclear Ag（Ⅰ）/Ni（Ⅱ） Complex

Introduction Itiswell knownthatcyanogroupsincyanometa latessuchas[Ag(CN)2]-unitscanbeusedasbridg ingligandsandapolymericstructurecanbeformed throughsilver silver(argentophilic)interactions.This propertyhasbeenexploredintheconstructionofmany oligomericandp…     

Structural and lithium intercalation studies of Mn(0.5−x)CaxTi2(PO4)3 phases (0≤x≤0.50)

Materials from the Mn_(0.5−x)Ca_xTi₂(PO₄)₃ (0≤x≤0.50) solid solution were obtained by solid-state reaction in air at 1000 °C. Selected compositions were investigated by powder X-ray diffraction analysis, ³¹P nuclear magnetic resonance (NMR) spectroscopy and electrochemical lithium intercalation. The structure of all samples determined by Rietveld analysis is of the Nasicon type with the R space group. Mn²⁺/Ca²⁺ ions occupy only the M1 sites in the Ti₂(PO₄)₃ framework. The divalent cations are ordered in one of two M1 sites, except for the Mn_0.50Ti₂(PO₄)₃ phase, where a small departure from the ideal order is observed by XRD and ³¹P MAS NMR. The electrochemical behaviour of Mn_0.50Ti₂(PO₄)₃ and Mn_(0.5−x)Ca_xTi₂(PO₄)₃ phases was characterised in Li cells. Two Li ions can be inserted without altering the Ti₂(PO₄)₃ framework. In the 0≤y≤2 range, the OCV curves of Li//Li_yMn_0.50Ti₂(PO₄)₃ cells show two main potential plateaus at 2.90 and 2.50–2.30 V. Comparison between the OCV curves of Li//Li_(1+y)Ti₂(PO₄)₃ and Li//Li_yMn_0.50Ti₂(PO₄)₃ shows that the intercalation occurs first in the unoccupied M1 site of Mn_0.50Ti₂(PO₄)₃ at 2.90 V and then, for compositions y>0.50, at the M2 site (2.50–2.30 V voltage range). The effect of calcium substitution in Mn_0.50Ti₂(PO₄)₃ on the lithium intercalation is also discussed from a structural and kinetic viewpoint. In all systems, the lithium intercalation is associated with a redistribution of the divalent cation over all M1 sites. In the case of Mn_0.50Ti₂(PO₄)₃, the stability of Mn²⁺ either in an octahedral or tetrahedral environment facilitates cationic migration.     

Elasticity in nanocrystalline Nd2Fe14B+αFe magnetic composites

The dynamic Young modulus (E) of magnetic Nd₂Fe₁₄B+αFe nanocomposites is investigated with mechanical spectroscopy techniques (vibrating reed configuration, f≈1.5 kHz <10⁻⁶). Reduced values of E are obtained (88–152 GPa) as compared with that predicted by the rule of mixtures for the composite (164 GPa). Three contributions to this reduction are briefly discussed: a large volume fraction of the specimen with grain boundary like structure; internal pores, resulting from the high cooling rate during processing (10⁶ K/min) and magneto-mechanical effects. Even when porosity is identified as the principal cause of modulus reduction, magnetic effects are also detected.     

Vibrational spectra of (NH4)3ZnCl5

IR and Raman spectra of (NH₄)₃ZnCl₅ have been recorded. The observed spectra have been analysed on the basis of the vibrations of ZnCl ₄ ²⁻ and NH ₄ ⁺ ions. The appearance of multiple Raman bands indicates the presence of two different types of ammonium ions. The effect of anisotropic crystalline field over the ZnCl₄ and NH₄ tetrahedra is also discussed. The assignment of internal modes has been verified by the potential energy distribution calculations.     

Effects of UV photon irradiation on SiOx (0 < x < 2) structural properties

Thin films of a-SiO_x (0 < x < 2) were prepared by reactive r.f. magnetron sputtering from a polycrystalline-silicon target in an Ar/O₂ gas mixture. The oxygen partial pressure in the deposition chamber was varied so as to obtain films with different values of x. The plasma was monitored, during depositions, by optical emission spectroscopy (OES) system. Energy dispersive X-ray (EDX) measurements and infra-red (IR) spectroscopy were used to study the compositional and structural properties of the deposited layers.Structural modifications of SiO_x thin films have been induced by UV photons’ bombardment (wavelength of 248 nm) using a pulsed laser. IR spectroscopy and X-ray photoemission spectroscopy (XPS) were used to investigate the structural changes as a function of x value and incident energy. SiO_x phase separation by spinodal decomposition was revealed. The IR peak position shifted towards high wavenumber values when the laser energy is increased. Values corresponding to the SiO₂ material (only Si⁴⁺) have been found for laser irradiated samples, independently on the original x value. The phase separation process has a threshold energy that is in agreement with theoretical values calculated for the dissociation energy of the investigated material.For high values of the laser energy, crystalline silicon embedded in oxygen-rich silicon oxide was revealed by Raman spectroscopy.     

Amorphous Fe–Mg alloy thin films: magnetic properties and atomic vibrational dynamics

Amorphous (a-) Fe _x Mg_1?x alloys are interesting materials for the investigation of non-Debye-like low-energy vibrational excitations. We have prepared a-Fe _x Mg_1?x alloy thin films (0.3 ≤ × ≤0.7) by vapour quenching. The amorphous state was confirmed by conversion electron Mössbauer spectroscopy between 4.2–300 K, and the x- and temperature-dependence of the isomer shift and hyperfine magnetic field was measured. For x= 0.6 and 0.7, magnetic ordering occurs below ~150 K. The atomic vibrational density of states, g(E), was determined by nuclear resonant inelastic scattering, providing clear evidence for the non-Debye-like low-energy vibrational excitations.     

DTA and X-ray diffraction investigations of laser-irradiated CeO2 powders

The TG and DTA curves and diffractograms of powdered CeO₂ samples irradiated with a CO₂ laser beam with powers of 0.41–1.39 kW/cm² are presented. The laser treatment induced structural changes and probably generation of a metastable phase. X-ray diffraction coupled with thermal analysis was used to establish the structural modifications in the irradiated samples after heating.     

New results for virial coefficients of hard spheres inD dimensions

We present new results for the virial coefficientsB _k for κ<- 10 for hard spheres in dimensionsD = 2,..., 8.