Sorption/diffusion behaviour of anionic surfactants in polyacrylamide hydrogels: from experiment to modelling

The sorption and diffusion processes of anionic surfactants with different chain length through polyacrylamide hydrogels with low swelling degree have been studied by electrical conductivity measurements. The multicomponent equilibrium equation has been used to model the sorption isotherms of different anionic surfactant in the hydrogels. Such isotherms show that initial rapid sorption of unimer surfactant into the membranes occurs, suggesting that non-freezing water can be involved in these interactions. In aqueous solution, at concentrations near and above the critical micelle concentration an anti-co-operative region is found. The diffusion coefficients of the anionic surfactants inside the hydrogel matrix show that the mobility of diffusing surfactant entities is dependent on cross-linker concentration and chain length. The Cukier hydrodynamic model and the free volume theory as modified by Peppas and Reinhart were applied to explain the dependence of the diffusion coefficients of surfactant on surfactant concentration inside the hydrogel. The hydrodynamic model was applied with success to the more hydrophilic surfactant, sodium 1-octanesulfonate, showing that the diffusion coefficients, D, increase when the resistance to hydrodynamic medium decreases; when the surfactant chain length increases (sodium dodecyl sulfate and sodium 1-hexadecane sulphonate) the variation of D with the free volume can only be understood considering the sieving effect produced by the surfactant inside gel.     

Rheological properties of the aqueous mixtures of cationic-anionic surfactants

The rheological properties of the aqueous mixtures of cationic-anionic surfactants, both in single-phase systems and in aqueous two-phase systems, have been studied. Bizarre rheological properties —negative thixotropy, viscoelasticity and hihg viscosity of shear rate dependent at relatively low concentration — have been observed. An unusual viscosity change, that is, viscosity lowering with increasing concentration, was obtained. The negative thixotropy might be due to the existence of lamellar or sheet-like micelles, viscoelasticity might be induced by rodlike and lamellar or sheet-like micelles, the high viscosity might be a consequence of the formation of network by long rodlike micelles and the concentration-induced viscosity lowering could be interpreted in terms of the decrease of micellar dimensions with concentration.     

Impact of micelles on the biocidal efficiency in a diesel–water interface

Biodegradation occurs in the diesel/water interface in petroleum product pipelines. The microbial contamination can result in inhibitor/fuel degradation, leading to unacceptable levels of turbidity, filter plugging, storage tank corrosion and stored product souring. Therefore, selection of the biocide/inhibitor plays an important role in the transportation of petroleum products through pipelines. Three biocides (cationic and nonionic) were employed to study the biodegradation in a diesel‐water interface. The biocidal efficiency against degradation of diesel was examined by employing Fourier‐transform infrared (FTIR) spectroscopy, nuclear magnetic resonance (NMR) spectroscopy and gas chromatography mass spectrometry (GC‐MS) techniques. Bronopol (2‐bromo‐2‐nitro‐propane‐1, 3‐diol) was found to have higher bactericidal efficiency than N‐cetyl‐N,N, N‐trimethyl ammonium bromide (CTAB) and cetyl pyridinum bromide (CPB). But the cationic biocides (CTAB and CPB) showed good biocidal efficiency at the interface. The data are explained in terms of a model that postulates the formation of a ‘micelle’ at the diesel‐water interface. Copyright © 2007 John Wiley & Sons, Ltd.     

Efficient synthesis of thioesters and amides from aldehydes by using an intermolecular radical reaction in water

The combination of the water-soluble radical initiator, 2,2'-azobis[2-(2-imidazolin-2-yl)propane] dihydrochloride (VA-044) and the surfactant, cetyltrimethyl-ammonium bromide (CTAB), was found to be the most suitable condition for the effective and direct synthesis of useful active thioesters (pentafluorophenyl thioesters) in water. In addition, the direct amidation of aldehydes was achieved by the addition of the amines to the thioesterification reaction mixture in water.     

Effects of Nonionic, Cationic, and Mixed Nonionic-Cationic Surfactants on the Acid-Base Behavior of Phenyl Salicylate

The effects of Brij 35 micelles, CTABr micelles, and mixed Brij 35–CTABr micelles on the acid–base behavior of phenyl salicylate (PST) have been studied in aqueous solution containing 2% v/v acetonitrile. The apparent pK_b (pK^app_b) of PST is decreased by 1.5 pK units with the increase in [Brij 35] from 0 to 0.02 M which is attributed to micellar medium effect. The values of pK^app_b remain almost independent of [CTABr] within its range 0.01–0.03 M. The increase in [CTABr] from 0 to 0.03 M in aqueous solution containing 0.02 M Brij 35 has not resulted in a change in pK^app_b. This shows that the characeristic structural features of nonionic Brij 35 micelles remain essentially unchanged on addition of CTABr under the present experimental conditions.     

Small angle neutron scattering study of alkyl polyoxyethylene sulfate micelles. Sodium dodecyl-(oxyethylene)2 sulfate in D2O-H2O mixtures at 25°C

SANS data have been obtained for C₁₂H₂₅ (OC₂H₄)₂SO₄ Na. Results have been obtained for i) a series of solutions of variable concentration of the surfactant, ii) an approximately 0.07 M surfactant concentration to which variable amounts of NaCl were added, iii) a series of solutions 0.058M in surfactant but in different D₂O-H₂O mixtures. The SANS data can be described in terms of a model of monodispersed hard spheres interacting via a screened Coulombic potential. The micelles seem to be able to tolerate substantial amounts of salt without changing the internal structure.     

Adsorption of<Emphasis Type="Italic"> N</Emphasis>-dodecyl-<Emphasis Type="Italic">N</Emphasis>,<Emphasis Type="Italic">N</Emphasis>-dimethyl-3-ammonio-1-propanesulfonate (DDAPS), a model zwitterionic surfactant,on the Au(111) electrode surface

Electrochemical measurements including cyclic voltammetry, differential capacity, and chronocoulometry have been used to characterize the adsorption behaviors of the zwitterionic surfactant N-dodecyl-N,N-dimethyl-3-ammonio-1-propanesulfonate (DDAPS) on the Au(111) electrode surface. The thermodynamics of the ideally polarized electrode have been employed to determine the Gibbs excess and the Gibbs energy of adsorption. The results show that the adsorption of DDAPS has a multistate character. The first two states are observed at potentials close to zero charge. At low bulk DDAPS concentrations, it corresponds to the formation of a film of nearly flat adsorbed molecules. At higher concentrations it is converted into a hemimicellar state. The second state is formed at negative potentials and charge densities close to 0 C cm^–2. It corresponds to a film of tilted molecules oriented with the hydrocarbon tail towards the metal and the polar head toward the solution.Dedicated to Professor Zbigniew Galus on the occasion of his 70^th birthday and in recognition of his many contributions to electrochemistry.     

Surfactant polymer interactions between strongly interacting cationic surfactants and anionic polyelectrolytes from conductivity and turbidity measurements

The interactions between oppositely charged surfactant/polymer mixtures have been studied using conductivity and turbidity measurements. The dependence of aggregation phenomenon on the chain length and head group modifications of conventional cationic surfactants, i.e., hexadecyl- (HTAB), tetradecyl- (TTAB), and dodecyltrimethylammonium bromides (DTAB) and dimeric cationic surfactants, i.e., decyl- (DeDGB) and dodecyldimethylgemini bromides (DDGB), is investigated. It was observed that cationic surfactants induce cooperative binding with anionic polyelectrolytes at critical aggregation concentration (cac). The cac values are considerably lower than the critical micelle concentration (cmc) values for the same surfactant. After the complete complexation, free micelles are formed at the apparent critical micelle concentration (acmc), which is slightly higher in aqueous polyelectrolyte than in pure water. Among the conventional and dimeric cationic surfactants, DTAB and DeDGB, respectively, have been found to have least interactions with oppositely charged polyelectrolytes.     

The structure of metallomicelles

The morphology of micelles formed by two novel metallosurfactants has been studied by small-angle neutron scattering (SANS) and small-angle-X-ray scattering (SAXS). The two surfactants both contain a dodecyl chain as the hydrophobic moiety, but differ in the structure of the head group. The surfactants are Cu(II) complexes of monopendant alcohol derivatives of a) the face-capping macrocycle 1,4,7-triazacyclanonane (tacn), and b) an analogue based upon the tetraazamacrocycle 1,4,7,10-tetraazacyclododecane. Here, neutron scattering has been used to study the overall size and shape of the surfactant micelles, in conjunction with X-ray scattering to locate the metal ions. For the 1,4,7,10-tetraazacyclododecane-based surfactant, oblate micelles are observed, which are smaller to the prolate micelles formed by the 1,4,7-triazacyclononane analogue. The X-ray scattering analysis shows that the metal ions are distributed throughout the polar head-group region, rather than at a well-defined radius; this is in good agreement with the SANS-derived dimensions of the micelle. Indeed, the same model for micelle morphology can be used to fit both the SANS and SAXS data.     

Influence of surfactant addition on the stability of concentrated alumina dispersions in water

The goal of this study was to assess the effects of surfactant addition on the stability and viscosity of concentrated alumina dispersions. The stabilizing effects of several candidate surfactants were investigated for concentrated dispersions of two different pseudoboehmite aluminas at pH 4 and 7. The stabilities of concentrated alumina dispersions treated by pH adjustment alone and by pH adjustment combined with surfactant addition were compared to assess the degree to which the surfactant enhanced stability. The initial rate of mass removal from a sedimenting alumina dispersion was used as a measure of stability.

The anionic surfactants Surfine WNT-A and DOWFAX 3B2 were identified as effective in enhancing the stability of concentrated alumina dispersions. The optimal doses of these surfactants for stabilizing 15% by weight VERSAL™ 250 alumina dispersions at pH 4 were determined to be about 4.6 × 10⁻⁵ mol g⁻¹ for both surfactants. On the basis of the initial rate of mass removal, surfactant-stabilized 15 wt.% suspensions were found to be approximately 2.5 and 10.6 times more stable than similar dispersions stabilized electrostatically by pH adjustment alone. These more stable dispersions exhibited lower viscosities than observed for the alumina dispersions not subjected to surfactant addition. The results indicate that the stability of concentrated alumina dispersions can be enhanced by anionic surfactant addition, and that such surfactants may therefore help to control the rheology of concentrated dispersions of alumina in water.