中国高功率固体激光技术发展中的两次突破

高功率固体激光是激光聚变、高能量密度物理与前沿基础科学研究必需的实验手段。上世纪六七十年代,老一辈科学家王淦昌、王大珩、邓锡铭、于敏等人以敏锐的科学洞察力与超前的战略眼光,开创了中国激光聚变研究的宏伟工程,为中国高功率固体激光技术的长远发展注入了强劲的东风。中国工程物理研究院(简称中物院)作为激光聚变研究的总体单位,联合中国科学院等国内优势单位,在国家强有力的支持下,推动与组织了中国高功率固体激光技术与装置研制的快速发展。中物院激光聚变研究中心作为高功率固体激光技术研发的总体单位之一,敢于担当、勇于创新,团结协作,坚持三十余载,实现了中国高功率固体激光技术研发历程中的两次“突破”,即突破新一代高功率钕玻璃激光技术,相继研制成功了亚洲规模最大、技术先进的神光-Ⅲ原型装置和神光-Ⅲ激光装置;突破百太瓦超短超强激光关键技术,建成了国内首台输出能力高达200 TW的SILEX-Ⅰ超短超强脉冲激光装置。两次“突破”,不但有力地支撑了中国激光聚变与相关基础科学研究的高速发展,同时实现了中国高功率固体激光技术发展由“望尘莫及”到“望其项背”的跨越,奠定了由“望其项背”到与美、法先进国家“三足鼎立”的坚实基础。     

乳化液喷雾与微爆现象的激光全息实验研究

本文采用离轴高速多脉冲红宝石激光全息摄影仪研究高温高压环境中乳化液喷雾的雾化和蒸发过程,记录方式为象面全息方式,再现时分别采用激光和白光光源。实验发现:在适当的温度压力条件下,乳化液喷雾可以发生微爆现象,微爆呈团状,又称“团状微爆”,也称为“二次雾化”,微爆能量可以将众多的小液滴及液滴碎片抛出液束区,有效地改善液体与环境气体的混合过程,具有重要的理论意义和实用价值。     

Laser spectroscopic investigation of a new precursor-type polyparaphenylenevinylene

Optical, structural and morphological properties of thin films of polyparaphenylenevinylene (PPV) formed by an alkyl sulfinyl precursor route have been studied. Thin films were fabricated on an optical glass and on quartz glass either by spin-coating of the precursor solution or by layer-by-layer deposition using Langmuir–Blodgett technique. PPV precursor films were also spin-coated on gold-coated glass in order to study thin-film optical parameters by surface plasmon spectroscopy. We have been successful in forming about 40 precursor mono layers on quartz glass by Langmuir–Blodgett technique using optimized surface pressure and dipping conditions. After thermal conversion of the precursor layers good quality fluorescent PPV films of yellow colour have been obtained. Optical characterization of the films was carried out by linear absorption and emission spectroscopy, ellipsometry, and surface plasmon spectroscopy. Structural and morphological studies on the thin films were carried out by using X-ray scattering and atomic force microscopy. Wave-guided travelling-wave laser action has been achieved in a PPV film on quartz glass. The sample was transversally pumped with picosecond laser pulses (wavelength 347.15 nm, duration 35 ps). Laser emission occurred at 550 nm for pump pulse energy densities above .     

Band bending at the Si(1 1 1)–SiO2 interface induced by low-energy ion bombardment

Experiments employing photoreflectance spectroscopy have uncovered band bending due to electrically active defects at the Si(1 1 1)–SiO₂ interface after sub-keV Ar⁺ ion bombardment. The band bending of about 0.5 eV resembles that for Si(1 0 0)–SiO₂, and both interfaces exhibit two kinetic regimes for the evolution of band bending upon annealing due to defects healing. The healing takes place about an order of magnitude more quickly at the (1 1 1) interface, however, probably because of less fully saturated bonding and higher compressive stress.     

固体材料激光冷却的实验研究及其最新进展

近年来，基于反斯托克斯荧光制冷(Anti—Stokes Fluorescent Cooling)的固体材料激光冷却技术得到了快速发展。本文首先简单介绍了固体材料激光冷却的基本原理及其技术；其次，详细介绍了各种固体激光冷却的新材料、新方案和新结果及其最新实验进展；最后，就固体激光冷却技术的应用前景及其未来发展方向等问题进行了简单讨论与展望。     

343 nm飞秒激光制备微孔阵列以增强聚氨酯合成革透湿性

为了提高聚氨酯(PU)合成革透湿性,分别使用343 nm飞秒激光和作为对比的1030 nm飞秒激光及1064 nm纳秒激光制备微孔阵列。采用扫描电镜(SEM)和3D激光扫描显微镜对比研究了微孔形貌。结果表明,343 nm飞秒激光可以制备出效果最佳的微孔。此外,分析了3种激光与PU涂层的作用机理,揭示了343 nm飞秒激光合成革微钻孔过程仅表现为光化学烧蚀,光化学和光热烧蚀同时发生于1030 nm飞秒激光钻孔过程,而1064 nm纳秒激光只显示了光热烧蚀。激光合成革表面钻孔后,测量其透湿性和抗张力。结果显示: 微孔密度越大,皮革透湿性(WVP)越大而抗张力越低,脉冲重叠的增加会导致WVP的增加和抗张力的下降;同时,随着脉冲重叠从91.7%降到50%,微孔直径从45 μm降低到30 μm,而微孔锥度从0.7°增加到12.1°;当脉冲重叠率为91.7%,微孔密度为2550/cm²时,最大的WVP增长率为306%。     

Research on speckle noise of laser Doppler velocimeter for the vehicle self-contained navigation

A novel multipoint layer-type laser Doppler velocimeter (MLLDV) is designed to measure the velocity of a vehicle for the self-contained navigation system. In order to investigate the speckle's influence on the Doppler spectrum, formulas of time-lagged covariance and speckle broadening were derived for our MLLDV. Simulations and experiments are made for detailed analysis. The results show that the time-lagged covariance of photocurrent is directly proportional to the incident angle, and is inversely proportional to the elevation fluctuation of the ground together with the velocity of the vehicle. Speckle broadening is a function of the vehicle's velocity, the 1/e² Gaussian spot radius and the phase correlation length of the ground. For our MLLDV, Doppler frequency and Doppler broadening are both directly proportional to the velocity of the vehicle. Besides, the ratio between Doppler broadening and the corresponding Doppler frequency is about 0.72% when the speed of the vehicle varies from 0 to 9.6 m/s.     

器件效应数值模拟中漂移扩散模型的误差分析

为了确定数值模拟过程中的误差来源,并针对误差来源改进软件,减小计算误差,对半导体器件数值模拟中的采用的漂移扩散模型进行了研究。结合自主开发的半导体器件效应软件GSRES,分析了软件中漂移扩散模型的理论近似,对计算模型中由于温度分布、载流子复合/产生率、载流子迁移率等项采取近似而导致的误差进行了分析。根据误差分析和数值模拟算例,认为误差主要来自于器件内部温度场分布和迁移率模型的近似,给出了软件的适用范围。结合半导体器件的研究热点和发展趋势,对该模型中需要进行改进的近似项进行了分析。     

基于自衍射效应的自参考光谱干涉方法的研究

研究一种基于非线性透明光学介质中的自衍射和自参考光谱干涉的新方法来进行飞秒激光脉冲测量. 实验中, 基于此新方法设计一种简单装置, 对800 nm 中心波长, 约40 fs 近无啁啾飞秒激光脉冲进行测量, 并与自参考光谱相干电场重建法测量结果进行比较, 得到了一致的结果. 此新方法与相应的装置结构简单, 可以对深紫外到中红外光谱范围的飞秒脉冲进行测量. 关键词： 飞秒激光脉冲 自参考光谱干涉 自衍射 脉冲测量     

基于LabVIEW的高分辨率光谱测试系统(英文)

提出了一种基于LabVIEW的无源器件光谱测试方案.通过LabVIEW编程控制可调谐激光器、可编程光滤波器、光功率计和数据采集平台,获得了具有不同传递函数的光谱特性.实验中激光器的扫描速度为10nm/s,扫描范围为10nm,数据采集卡的采样速率为1MS/s,结果表明:单个器件的光谱测试可以在1s内完成,光谱分辨率可达1pm;与利用宽带光源和光谱分析仪的传统光谱测试方法相比,所提方案的测试性能可达到传统方案水平,且能显示更精细的光谱细节.该方案能应用于有高分辨率、快速和高效要求的光谱测试中.