船载特种设备基点轨迹测量的误差分析

对船载特种设备基准点的空间位置进行测量,得到该基准点的运动轨迹并进行测量误差分析,是某项工程数据处理的重要内容.提出了利用三台船载GPS接收机测量船载特种设备基准点的原理和误差分析方法,介绍了该方法的误差源构成,依据测量原理模型,推导出定位精度的估算公式,并叙述了仿真计算与测量实施.     

HL-2M 真空室保温层设计及安装

基于 HL-2M 真空室烘烤保温要求，通过有限元分析和原型件实验确定采用陶瓷纤维与纳米级微孔材 料组合作为 HL-2M 真空室保温材料。在 30℃时，保温层的导热系数小于 0.027W⋅m⁻¹·℃⁻¹；300℃时，导热系数 小于 0.038W⋅m⁻¹·℃⁻¹。在保温层厚度 25mm、热面温度 300℃且达到稳态时，冷面可控制在 85℃以下，线圈侧的 温度低于 60℃，整体热损失小于 12kW，满足 HL-2M 真空室烘烤需求。      

Sodiation as a tool for enhancing the diagnostic value of MALDI‐TOF/TOF‐MS spectra of complex astaxanthin ester mixtures from Haematococcus pluvialis

The microalga Haematococcus pluvialis produces the pigment astaxanthin mainly in esterified form with a multitude of fatty acids, which results in a complex mixture of carotenol mono‐ and diesters. For rapid fingerprinting of these esters, matrix‐assisted laser desorption ionization time of flight mass spectrometry (MALDI‐TOF/TOF‐MS) might be an alternative to traditional chromatographic separation combined with MS. Investigation of ionization and fragmentation of astaxanthin mono‐ and diester palmitate standards in MALDI‐TOF/TOF‐MS showed that sodium adduct parent masses [M + Na]⁺ gave much simpler MS² spectra than radical / protonated [M]^+● / [M + H]⁺ parents. [M + Na]⁺ fragments yielded diagnostic polyene‐specific eliminations and fatty acid neutral losses, whereas [M]^+● / [M + H]⁺ fragmentation resulted in a multitude of non‐diagnostic daughters. For diesters, a benzonium fragment, formed by polyene elimination, was required for identification of the second fatty acid attached to the astaxanthin backbone. Parents were forced into [M + Na]⁺ ionization by addition of sodium acetate, and best signal‐to‐noise ratios were obtained in the 0.1 to 1.0 mM range. This method was applied to fingerprinting astaxanthin esters in a crude H. pluvialis extract. Prior to MALDI‐TOF/TOF‐MS, the extract was fractionated by normal phase Flash chromatography to obtain fractions enriched in mono‐ and diesters and to remove pheophytin a, which compromised monoester signals. All 12 types of all‐trans esterified esters found in LC were identified with MALDI‐TOF/TOF‐MS, with the exception of two minor monoesters. Copyright © 2013 John Wiley & Sons, Ltd.     

基于双天线的高精度GPS定位测向系统及其在无人水面艇上的应用

介绍了一种基于双天线的高精度GPS定位测向系统,该系统可以实现精确定位、测向。分别从硬件和软件两个方面详细介绍了双天线GPS定位测向系统,双天线GPS系统的硬件部分主要由GPS接收机、主天线和从天线组成,GPS接收机内置OEM板和底层通信板,软件部分主要解析GPS数据处理模块的软件工作流程。通过静态实验和动态实验分析系统定位、测向的精度,实验数据表明静态实验的经度的标准偏差为0.3155米,纬度的标准偏差为0.1962米,第一次静态实验的测向标准偏差为0.0981°,第二次静态实验的测向标准偏差为0.0926°。最后,将此系统应用到无人水面艇,进行直线路径跟踪水上试验。     

Cooling-down of thermal thick probes after flash excitation – A measure for the real energy density?

Though flash lamps are one of the most applied heat sources in the field of Thermographic Testing (TT) using active thermography, only little is known about the actually achieved energy input into test objects. In this paper, an easy to realize sensor concept is proposed and experimentally evaluated. The concept is based on the measurement of the surface temperature of a thermal thick probe after flash excitation. After considering the sensor concept with FEM simulations the experimental investigation of four materials (two polymer and two building materials) is described. It will be shown that a suited coating is essential for the realization of the sensor concept. The experimental results prove the suitability of black rigid PVC as the most promising material. Using a coated PVC sample the energy density of short laser pulses, similar to flashes of flash lamps, could be determined exactly with an estimated relative uncertainty of only a few percent.     

Role of nickel and manganese in recovery of resistivity in iron-based alloys after low-temperature proton irradiation

This study investigates the recovery of electric resistivity in pure iron, Fe–0.6Ni and Fe–1.5Mn as related to isochronal annealing following 1 MeV proton irradiation at lower temperature than 70 K, focusing on the relationship between solute atoms and irradiation defects. Both nickel and manganese prevent stage I_D recovery, which corresponds to correlated recombination. Stage II recovery is also changed by the addition of a solute, which corresponds to the migration of small interstitial clusters. In both pure iron and Fe–0.6Ni, no evident difference was observed in the stage III region, which corresponds to the migration of vacancies. In contrast, two substages appeared in the Fe–1.5Mn at a higher temperature than stage III_B appeared in pure iron. These substages are considered to represent the release of irradiation-induced defects, which was trapped by manganese.     

A Facile and Highly Efficient Approach to Obtain a Fluorescent Chromogenic Porous Organic Polymer for Lymphatic Targeting Imaging

Porous organic polymers have an open architecture, excellent stability, and tunable structural components, revealing great application potential in the field of fluorescence imaging, but this part of the research is still in its infancy. In this study, we aimed to tailor the physical and chemical characteristics of indocyanine green using sulfonic acid groups and conjugated fragments, and prepared amino-grafted porous polymers. The resulting material had excellent solvent and thermal stability, and possessed a relatively large pore structure with a size of 3.4 nm. Based on the synergistic effect of electrostatic bonding and π–π interactions, the fluorescent chromogenic agent, indocyanine green, was tightly incorporated into the pore cavity of POP solids through a one-step immersion method. Accordingly, the fluorescent chromogenic POP demonstrated excellent imaging capabilities in biological experiments. This preparation of fluorescent chromogenic porous organic polymer illustrates a promising application of POP-based solids in both fluorescence imaging and biomedicine applications.     

数字散斑相关方法及其在碳纤维复合材料压力容器变形测量中的应用

提出了一种新的基于图像灰度梯度迭代的数字散斑相关方法(DSCM,digital speckle correlation method)。通过使用DSCM测量碳纤维复合材料压力容器在水压下的局部区域的位移场和应变场,分析了复合材料压力容器的轴向和环向的变形特征,为碳纤维复合材料压力容器的优化设计提供了理论和实验依据。     

塞曼效应仿真实验平台

塞曼效应实验是学生了解原子具有磁矩和空间取向量子化现象的重要实验,至今塞曼效应仍是研究能级结构的重要方法之一.为了能够让学生更加清楚地了解塞曼效应实验的基本原理和操作规程,针对教学中的重点和难点,运用flash软件制作出塞曼效应仿真实验.该程序可全程高度仿真实验过程,具有界面友好、易于操作、无需安装等优点.为实验教学提供了一种新的辅助方式.