On the chemistry of pyrrole pigments,XCIV: 1-(Dipyrrinon-9-yl)-3-(dipyrrinon-9-ylidene)-1-propene — a novelb-vinylogous verdin chromophore

Summary 1-(Dipyrrinon-9-yl)-3-(dipyrrinon-9-ylidene)-propene, ab-vinylogous verdin, was synthesized by condensation of 3-(dipyrrinon-9-yl)-propenal with a dipyrrinone unsubstituted in position 9. By condensing the latter with dimedone or squaric acid,b-vinylogous verdin pigments with restricted configurational and conformational degrees of freedom were obtained. The chemical and spectroscopic properties of these novel systems are discussed.

---

Zur Chemie von Pyrrolpigmenten, 94. Mitt.: 1-(Dipyrrinon-9-yl)-3-(dipyrrinon-9-yliden)-1-propen — Ein neuerb-vinyloger Verdinchromophor

Zusammenfassung 1-(Dipyrrinon-9-yl)-3-(dipyrrinon-9-yliden)-propen, einb-vinyloges Verdin, wurde durch Kondensation von 3-(Dipyrrinon-9-yl)-propenal mit einem in Position 9 unsubstituierten Dipyrrinon dargestellt. Kondensation des Letzteren mit Dimedon oder Quadratsäure lieferte vinyloge Pigmente, welche in ihren konfigurationellen und konformationellen Freiheiten eingeschränkt sind. Die chemischen und spektroskopischen Eigenschaften dieser neuen Systeme werden diskutiert.

     

固相氯化法合成氯化聚乙烯的红外光谱研究

本文研究在不同条件固相氯化聚乙烯(CPE)的红外光谱,探讨了一步和两步氯化合成的CPE的结构差别,着重讨论了两步氯化的CPE结构特点。从观察表征结晶结构和—(CH_2)_n—链段氯分布的特征频率变化表明,低温固相氯化主要发生在无定形区,并且在CPE中形成高氯化和低氯化链段(或未氯化)的嵌段结构。在两步固相氯化时,晶区受到较大程度的破坏,氯化作用已不局限在无定形区,其结晶结构的破坏主要同第二步氯化程度有关,即使CPE氯含量相同,若前后两步氯化程度不同,结构有很大差异。     

Photodegradation of polypropylene thermal bonded non-woven fabric

Samples of thermal bonded polypropylene non-woven fabrics were exposed to light from two TUV 30W G30T8 Philips lamps (λ = 253.7 nm) in a covered open-air chamber at room temperature (25 °C and 55% relative humidity) for different periods of time. In order to determine the state of degradation, the samples were examined by optical microscopy, scanning electron microscopy, staining with an isopropanol solution of methylene blue and Sudan III, colourimetry, Fourier transform infrared (FTIR) spectroscopy and density measurements. Although the bonded areas formed under complex thermal and mechanical deformations during the fabric production, no localized staining was observed. The colour of the irradiated and stained fabrics changed uniformly due to the even production of polar groups in the process of irradiation. It was found that the change of redness and blueness of degraded and stained samples can be correlated linearly with the evolution of POOH groups as determined by FTIR spectroscopy. Products containing carbonyl (CO), hydroxyl and/or hydroperoxide (POOH) groups increase with time of degradation with a non-linear relation. It was also observed that the density and 997 cm⁻¹/972 cm⁻¹ FTIR absorbance ratio increases with degradation time. Density fluctuation and the build up of degradation products caused fibre cracks and embrittlement.     

Determination of platinum-group metals and lead in vegetable environmental bio-monitors by voltammetric and spectroscopic techniques: critical comparison

This paper reports voltammetric sequential determination of Pt(II), Pd(II), and Rh(III), by square-wave adsorption stripping voltammetry (SWAdSV), and Pb(II), by square-wave anodic stripping voltammetry (SWASV), in vegetable environmental matrices. Analytical procedures were verified by the analysis of the standard reference materials: Olive Leaves BCR-CRM 062 and Tomato Leaves NIST-SRM 1573a. Precision and accuracy, expressed as relative standard deviation and relative error, respectively, were always less than 6% and the limits of detection (LOD) for each element were below 0.096 g g^–1. Once set up on the standard reference materials, the analytical procedure was transferred and applied to laurel leaves sampled in proximity to a superhighway and in the Po river mouth area. A critical comparison with spectroscopic measurements is discussed.     

Modern Analysis

The important advances being made in modern analytical methods are indicative of the fundamental changes that are occuring in the theory and practice of “analytical chemistry”. “Information optimization” demands a new approach in teaching and research, and calls for the intergration of chemistry with other scientific and technical disciplines.     

Accurate electrical and spectroscopic properties ofX 1Σ+ BeO from coupled-cluster methods

Summary This paper reports a series of coupled-cluster (CC) calculations through CCSDT on the theoretically challenging ground state of the BeO molecule. Along with CC methods, quadratic configuration interaction (QCI) approximations to CC theory have been used (QCISD and QCISD(T)), which show several dramatic failings. Equilibrium electrical properties (, _xx , and _zz ) and basic spectroscopic properties (r _e, _e,D _e, and infrared intensity (I)) have been computed. Basis set and electron correlation effects are analyzed in order to arrive at accurate values of the dipole moment and polarizability, which are not known experimentally. For the dipole moment, we obtain a value of 6.25 D, with an uncertainty of about 0.1 D. For _xx and _zz , we suggest respective values of 32 and 36 atomic units (a.u.) and error bars of about 1 and 2 a.u. With extended basis sets, the spectroscopic propertiesr _e, _e, andD _e are reproduced to high accuracy, which is the first time this has been achieved for this species byab initio methods. At the highest calculation levels,I is predicted to be very small. AlthoughI has not been measured, some support for this prediction comes from a recent infrared study of BeO-rare gas complexes. The QCI methods are shown to be much more sensitive to basis set, and even with large basis sets yield values of _zz andI which differ from CC results by an order of magnitude and three orders of magnitude, respectively. These differences doubtless arise from the importance of single excitations (T ₁) for this molecule, as several terms involvingT ₁ are neglected in the QCISD approximation compared with CCSD. We also report CC calculations with Brueckner orbitals, which yield results similar to those obtained with restricted Hartree-Fock orbitals.     

Study on inclusion complexes of meso-tetrakis(2-thienyl)porphyrin and Cu-meso-tetrakis(2-thienyl)porphyrin with cyclodextrins by spectroscopy method

In phosphate buffer solution of pH5.4, the interaction of meso-tetrakis(2-thienyl)porphyrin(H₂TTP) and Cu-meso-tetrakis(2-thienyl)porphyrin(Cu-TTP) with α-cyclodextrin(α-CD), β-CD, γ-CD, heptakis(2,3,6-tri-O-methyl)-β-CD(TM-β-CD) has been studied by means of UV-vis, fluorescence and ¹HNMR spectroscopy, respectively. The H₂TTP and Cu-TTP can form 1:2 inclusion complexes with TM-β-CD and 1:1 inclusion complexes with the other three cyclodextrins. In this paper, the inclusion constants (K) of H₂TTP and Cu-TTP for the formation of the inclusion complexes have been estimated from the changes of absorbance and fluorescence intensity in phosphate buffer solution. The inclusive capabilities of different kinds of cyclodextrins are compared. The result shows that the inclusion ability of α-CD with H₂TTP and Cu-TTP is the strongest among the three native CDs. The inclusion ability of modified β-CD with H₂TTP and Cu-TTP is stronger, compared to the native β-CD, which indicates that the capacity matching plays a crucial role in the inclusion procedure except for the hydrophobic effect. In addition ¹HNMR spectra supports the inclusion conformation of the TM-β-CD-Cu-TTP inclusion complex, indicating the interaction mechanism of inclusion processes.     

Surface chemical analysis of raw cotton fibres and associated materials

The surface chemical composition of raw unscoured cotton was successfully investigated by the surface analytical techniques X-ray Photoelectron Spectroscopy (XPS) and Time of Flight Secondary Ion Mass Spectrometry (ToF-SIMS). The presence of non-cellulosic material at the fibre surface was established and determined to be a complex mixture of fatty acids, alcohols, alkanes, esters and glycerides. The effect of scouring and bleaching was to reduce the surface concentration of these materials but even after aqueous processing some non-cellulosic material residue was still detected at the fibre surface.     

Can magnetic circular dichroism tackle the problem of site symmetry in solutions?

A new approach to unravel the site symmetry of lanthanides in solutions is presented. The magnetic circular dichroism spectra of Eu³⁺ in the symmetries D_3h, C_4v and D_2d are simulated. In these simulations, the main idea is to introduce the magnetic field along a 3-fold axis, being the resultant of the three equivalent X-, Y- and Z-direction of a cube. This implies that the parallel and perpendicular Zeeman effects are taken into account simultaneously.