Low temperature Si homo-epitaxy by reduced pressure chemical vapor deposition using dichlorosilane,silane and trisilane

Dichlorosilane (DCS), silane and trisilane have been investigated as Si precursors for low temperature (<700 °C) Si reduced pressure chemical vapor deposition. DCS and silane are limited to growth temperatures higher than 600–650 and 500 °C, respectively. At lower temperatures, absence of either Cl or H desorption from the surface impedes Si growth with acceptable growth rate (>5 Å/min). Trisilane permits the growth of Si at lower temperatures below 350 °C due to a specific growth mechanism enhancing H desorption. Layers grown at temperatures lower than 500 °C are defective, irrespective of the carrier gas, pressure and precursor flow used.     

Field emission characteristics of screen-printed carbon nanotubes cold cathode by hydrogen plasma treatment

Selective plasma etching and hydrogen plasma treatment were introduced in turn to improve field emission characteristics of screen-printed carbon nanotubes (CNTs) cold cathode, which was prepared by using slurry of mixture of multi-wall CNTs, organic vehicles and inorganic binder, i.e. silicon dioxide sol. The results show that selective plasma etching process could effectively remove parts of surface inorganic vehicle (SiO₂) layer and expose more smooth and clean CNTs on cathode surface, which could significantly decrease the operating field of CNTs cathode. There are some nanoparticles emerging on the out of CNTs wall after hydrogen plasma treatment, which are equivalent to increase field emission point of cathode. At the same time, these nanoparticles can increase the local electric field of CNTs, which can decrease operating voltage of CNTs cathode and improve uniformity field emission.     

Lattice simulation of a center symmetric three-dimensional effective theory for SU(2) Yang-Mills

We perform simulations of an effective theory of SU(2) Wilson lines in three dimensions. Our action includes a kinetic term, the one-loop perturbative potential for the Wilson line, a non-perturbative “fuzzy-bag” contribution and spatial gauge fields. We determine the phase diagram of the theory and confirm that, at moderately weak coupling, the non-perturbative term leads to eigenvalue repulsion in a finite region above the deconfining phase transition.     

Stress Inhomogeneity in Powder Specimens Tested in the Jenike Shear Cell: Myth or Fact?

In the mechanical characterization of powders using the direct shear testers such as the Jenike shear cell, the existence of a uniform or well‐defined stress field in a powder specimen is assumed. This assumption has not been subjected to any serious scrutiny in the literature. In this study, the normal stress variation in a silica powder was locally determined by locating a pressure‐sensitive TekScan pad at the bottom section of a Jenike shear cell. A computer simulation of the consolidation and pre‐shearing stages of the Jenike test procedure was performed using the Discrete Element Method (DEM). The paper presents both experimental and computational evidence for the existence of a complex stress field in the powder specimen, thus clearly invalidating the long‐standing stress homogeneity assumption in the direct shear testing of powders. The implications of the stress inhomogeneity in terms of the accuracy of the material properties extracted from the Jenike test are also presented.     

A multidirectional shear rheometer for polymer melts

A parallel plate shear rheometer for polymer melts was built for superposed shear tests in two orthogonal directions. To examine its performance, a standard test was developed, including a change of the shear direction by angles between 0° and 180°. The results were analyzed to obtain preliminary information on the multidirectional shear behavior of a low-density polyethylene melt. The measured orthogonal components of the shear force were added and then split again into components of the original and of the changed shear direction. It was found, within the range of error, that these components depend only on time and on the shear rate, but not on the angle by which the shear direction is changed. The total shear rate was 0.56 s^–1.Dedicated to Prof. Dr. Joachim Meissner on the occasion of his 60th birthday.     

Differential pulse cathodic stripping voltammetric determination of nanomolar levels of dissolved sulfide applicable to field analysis of groundwater

Conventional batch mode analysis of dissolved sulfide by cathodic stripping voltammetry (CSV) is known to suffer from loss of sulfide in the cell to the waste mercury pool, compromising quantification of sulfide. Here we report a simple alternative approach to batch-mode differential pulse CSV (DPCSV). A fresh aliquot of sample is used for each voltammetric scan to minimize loss of sulfide through reaction with the mercury by limiting the time for sulfide-mercury contact, which is found to be more important in suppressing the sulfide signal than the amount of free mercury in the cell. Our improved batch-mode method exhibited a limit of detection of 1.3 nM, a relative standard deviation of 2.5% in NaOH supporting electrolyte and a linear response to as high a concentration as 1600 nM in a supporting electrolyte composed of Na₂CO₃/NaHCO₃ (pH 8.3) mixed with an equal volume of oxic groundwater. A relative standard deviation of 4.5% was obtained for a groundwater sample in Na₂CO₃/NaHCO₃ (pH 8.3) supporting electrolyte. These values are comparable to previously published results. Compared to other sensitive sulfide analytical techniques such as gas chromatography or high performance liquid chromatography (HPLC), DPCSV is preferred for sulfide analysis in the field due to its simple and portable instrumentation, lack of complex sample preparation, and short analysis time. The method was applied on site to analyze Fe-rich, reducing groundwater samples collected at a landfill site in Winthrop, Maine. Sulfide concentrations ranged from undetectable (<4 nM) to 7340 nM, generally increasing as the oxidation/reduction potential (ORP) of the water became more negative. We also demonstrate, for the first time, that the onset of sulfate reduction as indicated by the presence of small amounts of sulfide (tens to hundreds of nM) occurs in groundwater systems when the ORP value reaches −130 mV.     

Field Patterns of the TE Modes in Ridge-Trough Waveguide

A single-ridge waveguide with a symmetrical longitudinal trough, designated as a ridge-trough waveguide has been used as a transition in a V-band (50-75 GHz) wafer probe recently. In this paper, the field patterns for the dominant TE mode and the first higher TE mode in ridge-trough waveguide with different configurations are presented by finite element method. The field patterns in this paper have important values for us to understand the transmission characteristics of ridge-trough waveguide, and will be of practical significance in designing ridge-trough waveguide components in microwave and millimeter wave engineering.     

A model for single heterostructure field effect transistors

Single heterostructure field effect transistors are studied within a proposed analytical model for the heterostructure conduction band potential profile. An expression for the bias potential closing the conduction channel between drain and source is derived as a function of growth parameters and bias. In particular we study a field effect transistor based on Al_xGa_1−xN/GaN. The quantum well potential is modelled along the lines of the local density Thomas-Fermi approximation with the inclusion of exchange effects. Recent experimental results on two-dimensional electron gas density in this kind of systems are explained.     

Radiation damping in closed expanding universes

The dynamics of a coupled model (harmonic oscillator-relativistic scalar field) in Conformal Robertson-Walker (k = +1) spacetimes is investigated. The exact radiation-reaction equation of the source-including the retarded radiation terms due to the closed space geometry – is obtained and analyzed. A suitable family of Lyapunov functions is constructed to show that, if the spacetime expands monotonely, then the source's energy damps. A numerical simulation of this equation for expanding Universes, with and without Future Event Horizon, is performed.