光纤松耦合型传感器特性研究

本文介绍一种实用的光纤传感器,它由二根光纤或多根光纤紧靠一起,并在同一位置除去局部包层,成为松耦合状态,在这种状态下,研究了它的特性和应用。 当耦合间隙中充满某种液体介质时,耦合效率明显增大,因此可以方便地判别该介质是否存在。并且实验证明了一种光纤只能有一种相近于光纤芯子折射率的介质具有最大的灵敏度。当间隙内的介质不变时,耦合功率的大小决定于耦合距离d和耦合长度l,l一旦决定以后,d的调节精度为0.1mm量级,易于在机械结构上实现线性检测。     

The MPE/UCB far-infrared imaging Fabry-Perot interferometer (FIFI)

FIFI is an imaging spectrometer with two or three Fabry-Perot interferometers (FPI) in series for airborne astronomical observations in the far-infrared range (=40...200m). It employs 5×5 arrays of photoconducting detectors and offers spectral resolutions as small as 2km/s. Resolution and bandwidth can be set over a wide range to match a variety of astronomical sources. Cryogenic optics minimizes thermal background radiation and provides for in-flight step tunable spatial resolution. At 158 m wavelength the background-limited NEP is 3 × 10^-15W/Hz at 40 km/s resolution and with two FPI's; with three FPI's the expected NEP is 10^-15WHz at 5 km/s resolution.The frequency-chopping mode of the high-resolution Fabry-Perot allows for line detection in extended objects. Absolute internal flux calibration ensures adequate flat fielding of the array elements.     

A simple optimization strategy based on Rs-minimum and information theory of chromatography

Summary A simple optimization method based on the well-known Rs-minimum method and on the information theory of FUMI Φ is proposed. Resolution (Rs), peak area and height (or width) are the only parameters necessary for the calculation of the information Φ and information flow ϑ. The most precise analysis can be selected as the chromatogram having maximal ϑ. Mobile phase composition, column length, flow rate, detection wavelength, amount of internal standard, etc. can be optimized by this method.     

Synchrotron X-ray structures of cellulose I<Subscript>β</Subscript> and regenerated cellulose II at ambient temperature and 100 K

Synchrotron X-ray data have been collected to 1.4 Å resolution at the NE-CAT beam-line at the Advanced Photon Source from fibers of cellulose I_β and regenerated cellulose II (Fortisan) at ambient temperature and at 100 K in order to understand the effects of low temperature on cellulose more thoroughly. Crystal structures have been determined at each temperature. The unit cell of regenerated cellulose II contracted, with decreasing temperature, by 0.25%, 0.22% and 0.1% along the a, b, and c axes, respectively, whereas that of cellulose I_β contracted only in the direction of the a axis, by 0.9%. The value of 4.6×10^?5 K^?1 for the thermal expansion coefficient of cellulose I_β in the a axis direction can be explained by simple harmonic molecular oscillations and the lack of hydrogen-bonding in this direction. The molecular conformations of each allomorph are essential unchanged by cooling to 100 K. The room temperature crystal structure of regenerated cellulose II is essentially identical to the crystal structure of mercerized cellulose II.     

Influence of Light Scattering by Residual Alumina Nanoparticles on the Analysis of Surfactants Adsorption Using Spectroscopy

The adsorption of a surfactant mixture, based on an anionic surfactant, sodium dodecyl benzenesulfonate (SDBS) and a nonionic surfactant (Triton X-100, or TX100), on alumina nanoparticles was determined by solution depletion method combined with spectrometric measurement. It is shown that the light scattering, originated from the residual adsorbent alumina particles in the supernatant after centrifugation separation, interferes with the measurements of absorbance of the surfactant molecules, and therefore constitutes an error source for determination of the surfactant concentration in the supernatant by spectrometric means. The intensity of this light scattering, namely the influence of the residual alumina nanoparticles upon the surfactant adsorption, was related to the surfactant adsorption and its equilibrium concentration and varied among a batch. In this paper we report a Kalman filter method in order to eliminate the variational scattering background caused by non-separated residual alumina nanoparticles in each supernatant. This method is of interest as it is simple, easy to carry out and of high precision.     

Fast-cycle trace analysis of dioxin in flue gas. Monitoring of the incineration of dioxin-containing waste from seveso

The fast trace analysis method used to monitor 2,3,7,8-TCDD in stack gas during the incineration of the waste from Seveso is described. The sampling of volatile organic compounds from flue gases, distributed between all three aggregation states, is based on a micromethod developed for the trace analysis of water using a specially dimensioned adsorptive charcoal filter (1.5 mg charcoal). In conjunction with subsequent GC/MS measurements the rapid “fast cycle trace analysis” ensured specific 2,3,7,8-TCDD detection down to 100 pg per m³ flue gas in cycle times of about 1–2 hours.     

炉前煤低温干馏工艺中的挥发分除尘

为了寻求优化的炉前煤低温干馏工艺中的挥发分除尘方案，在使用400目金属滤网对间歇式粉煤固体热载体热解装置挥发分除尘研究的基础上，将颗粒床过滤器用于该过程的除尘研究。热态除尘实验表明，颗粒床的使用有效地降低了滤网的过滤负荷。选用2mm石英砂和φ5mm×2mm瓷环作为滤料，通过对比实验发现，两种滤料除尘效率均在90％以上；随着过滤操作的进行，由于颗粒床内粉尘的沉积使其过滤效率有所提高，而对气、液收率的影响很小。结果表明，颗粒床与滤网结合可作为粉煤炉前低温干馏工艺中可供选择的挥发分除尘方案。     

Designing a plano-convex aspheric lens for fiber optics collimator

A plano-convex aspheric lens is designed to collimate the emitted light of the fiber optics. In this paper even orders of general aspheres are used to describe the aspheric surfaces sag. To determine the aspheric coefficient, the even asphere polynomial are fitted on the computed sag data. The surface sag data is determined using genetic algorithm method. The surface sag was analyzed by the commercial optical software package ZEMAX. For typical fiber optics, the numerical aperture (NA) of 0.22 was assumed. With this specification, the expected output spot diagram of 20 mm and the maximum aperture of 25.4 mm have been obtained. A comparison between here presented lens and the similar type of conventional lens has been carried out; the proposed aspheric lens corrected the spherical aberration, which led to increase in the collimated distance.     

In vitro metabolism study of Strychnos alkaloids using high‐performance liquid chromatography combined with hybrid ion trap/time‐of‐flight mass spectrometry

In this report, the in vitro metabolism of Strychnos alkaloids was investigated using liquid chromatography/high‐resolution mass spectrometry for the first time. Strychnine and brucine were selected as model compounds to determine the universal biotransformations of the Strychnos alkaloids in rat liver microsomes. The incubation mixtures were separated by a bidentate‐C₁₈ column, and then analyzed by on‐line ion trap/time‐of‐flight mass spectrometry. With the assistance of mass defect filtering technique, full‐scan accurate mass datasets were processed for the discovery of the related metabolites. The structural elucidations of these metabolites were achieved by comparing the changes in accurate molecular masses, calculating chemical component using Formula Predictor software and defining sites of biotransformation based upon accurate MSⁿ spectral information. As a result, 31 metabolites were identified, of which 26 metabolites were reported for the first time. These biotransformations included hydroxylation, N‐oxidation, epoxidation, methylation, dehydrogenation, de‐methoxylation, O‐demethylation, as well as hydrolysis reactions. Copyright © 2013 John Wiley & Sons, Ltd.     

A central limit theorem in nonlinear filtering

It is shown that the probability law of a diffusion process conditioned on weakly corrupted observations is asymptotically Gaussian when properly scaled. The method of proof involves Fisher information matrices and a Cramér-Rao inequality.