Conductivity anomalies in Y–Ba–Cu–O at 40K and 100K under high quasihydrostatic pressures

Electrical resistance measurements at low temperatures and high quasihydrostatic pressures on superconducting and non-superconducting varieties of Y_0.8Ba_1.2Cu₂O₅ (obtained by annealing in oxygen and air respectively) show striking anomalies in the vicinity of 100K and 40K. Arguments are presented to show that these anomalies as also the occurrence of T 's in the oxide superconductors either in the vicinity of 100K or of 40K are connected with their layered structure containing planes of Cu-O otahedral complexes.     

激光束散角复合控制技术

为了降低部分相干光光学系统设计的复杂度及成本,增加部分相干光应用的便捷性,提出了一种液晶空间光调制器的激光相干度及束散角复合控制方法。首先介绍了对激光光束进行相干度和束散角复合控制的基本理论和方法;然后分别设置了相干度和束散角检测实验,检测了本方法所调制激光光束的相干度和束散角的准确性。实验结果表明,采用液晶空间光调制器生成相干度为0.9 mm、束散角为7.5 mrad,以及相干度为1.5 mm、束散角为3.8 mrad的部分相干光束,其相干度与理论值相比误差在5%以内,其相干度均方根误差分别为0.027386和0.031314,峰谷值分别为0.084 658和0.089 103;其束散角与理论值相比误差在5%以内,其束散角均方根误差分别为0.022 478和0.023 186,峰谷值分别为0.081 201和0.092 130。可见,该方法可以实现高精度的相干度及束散角复合控制。     

角锥棱镜谐振腔激光模式模拟研究

为了探究角锥棱镜谐振腔激光模式,以角锥-平面镜腔为例,将角锥棱镜等效为衍射光栅,考虑角锥镜棱宽在谐振腔中的衍射效应以及二面角误差引起的附加相位分布对谐振腔激光模式的影响,在光学谐振腔理论的基础上,建立了求解本征模式的理论分析模型.采用快速傅里叶法数值模拟不同腔长、角锥镜棱宽和二面角误差情况下该无源谐振腔激光输出模式分布情况.结果表明,在腔长30 cm、角锥镜棱宽小于75μm、二面角误差在-10′~5′之间时,可实现光斑完整的圆形分布输出模式,且有较好的光束质量;棱宽不小于0.4 mm,二面角误差在-40′~10′之间时,光斑为TEM 03阶横模,光场呈六瓣分布;当角锥镜棱宽为0.4 mm、二面角误差为3′,腔长从30~90 cm范围内增加时,该谐振腔输出的激光模式从TEM 03转换成TEM 10.     

Wettability and surface energy of parylene F deposited on PDMS

For the first time, the wettability and surface energy of parylene F were investigated. The results showed that parylene F had a hydrophobic surface with an eigen water contact angle of 104.7 ± 0.6°. We found that 3.5 μl probe liquid was an optimal value for the contact angle measurement of parylene F. Moreover, we found that the Lifshitz–van der Waals/acid–base approach was unsuitable for determining the surface energy of parylene F, whereas the Owens–Wendt–Kaelble approach and the limitless liquid–solid interface wetting system were compatible. The surface energy of parylene F was estimated to be 27.06 mJ/m² (Owens–Wendt–Kaelble) and 40.41 mJ/m² (Limitless liquid-solid interface wetting system). Furthermore, this investigation also provided a reference for the applications of empirical and physics-based semi-empirical approaches for the estimation of surface energy.     

水下对转螺旋桨流致辐射噪声机理与预报方法*

水下对转螺旋桨流致辐射噪声的预报对于水下目标的特征提取和分类识别具有重要意义。由桨叶的旋转引起的湍流场是水下对转螺旋桨流致辐射噪声的源场。分述了水下对转螺旋桨湍流边界层脉动、旋转干涉效应和空化效应引发的水动力噪声机制和研究进展,比较了目前工程应用中的3种对转螺旋桨流致辐射噪声预报方法的特点。在分析对转螺旋桨流致辐射噪声数值预报难点的基础上,综述了对转螺旋桨流致辐射噪声计算方法的研究进展,指出间接数值模拟方法是工程中进行对转螺旋桨流致辐射噪声预报的有效方法。     

光栅衍射实验中测量光栅常数的两种辅助方法

衍射光栅可以将不同波长的光在空间上分离开,在光谱分析领域中有广泛应用.利用光栅的衍射来测量光栅常数是大学物理实验中的一个典型实验,而本文介绍的正是光栅衍射实验中的两个有趣现象:一是旋转光栅时,谱线的偏转角存在一个最小值;二是光栅旋转到一定角度时,衍射光斑会逐渐消失在视野中.论文从理论上分析解释这两种现象,并设计出两种测量光栅常数的方法,在实验上进行验证.与传统的用最小偏转角测光栅常数的方法相比,本文重点分析了由判定最小偏转角位置偏差所带来的影响,并提出了对称旋转测量的方法来进一步减小误差.     

基于横向莫尔条纹的自准直测角方法

本文提出了基于横向莫尔条纹的自准直测角方法,用遮光原理分析了莫尔条纹的位移放大作用.并基于该方法搭建了原理光路,得到的莫尔条纹信号稳定且能够满足测量需求.在此基础上对系统进行了定量标定,简化了数据处理步骤,实现了动态测量,系统分辨率达到10″,进一步明确将该方法应用到自准直仪中可以有效提高仪器分辨率.     

915 nm宽条形半导体激光器输出特性

为了研究温升对915 nm宽条形应变量子阱半导体激光器输出特性的影响,搭建了基于半导体制冷片(TEC)的双向温控平台对其进行了测试。首先,改变激光器的外表面温度,测量其在不同注入电流时的光功率和波长,并利用CCD相机测量其慢轴发散角。然后,利用计算机仿真软件对激光器的工作状态进行稳态模拟,从而获得了其对应的热分布情况,通过将模拟得到的数据与实验测量的结果进行比较,获得了两者趋于一致的结论:当热功率从2.1 W升高至20.0 W时,慢轴发散角从2.6°增大至5.0°,同时波长发生红移,热透镜焦距减小;激光器波长随温度变化关系的系数约为0.4 nm/℃,器件热阻为1.5 K/W。因此,为了同时获得高的输出功率和稳定的输出波长,有必要将激光器外表面温度精确控制在某一数值,否则波长将会发生漂移;此外,在设计制作高功率半导体激光器时,通过适当增加条宽并采用散热良好的封装结构,可以减小对慢轴发散角的影响。     

Thomas rotation and the parametrization of the Lorentz transformation group

Two successive pure Lorentz transformations are equivalent to a pure Lorentz transformation preceded by a 3×3 space rotation, called a Thomas rotation. When applied to the gyration of the rotation axis of a spinning mass, Thomas rotation gives rise to the well-knownThomas precession. A 3×3 parametric, unimodular, orthogonal matrix that represents the Thomas rotation is presented and studied. This matrix representation enables the Lorentz transformation group to be parametrized by two physical observables: the (3-dimensional) relative velocity and orientation between inertial frames. The resulting parametrization of the Lorentz group, in turn, enables the composition of successive Lorentz transformations to be given by parameter composition. This composition is continuously deformed into a corresponding, well-known Galilean transformation composition by letting the speed of light approach infinity. Finally, as an application the Lorentz transformation with given orientation parameter is uniquely expressed in terms of an initial and a final time-like 4-vector.     

Scaling properties of ℤ k- 1 actions on the circle

We derive universal scaling properties for ^k–1 actions on the circle whose generators have rotation numbers algebraic of degreek. As fork=2 these properties can be explained for arbitraryk in terms of a renormalization group transformation. It has at least one trivial fixed point corresponding to an action whose generators are pure rotations. The spectrum of the linearized transformation in this fixed point is analyzed completely. The fixed point is hyperbolic with a (k–1)-dimensional unstable manifold. In the casek=2 the known results are therefore recovered.