Mid-infrared generation based on a periodically poled LiNbO3 optical parametric oscillator

We report a nanosecond Nd:YVO_4-pumped optical parametric oscillator (OPO) based on periodically poled LiNbO_3 (PPLN). Tuning is achieved in this experiment by varying the temperature and period of the PPLN. The design of double-pass singly resonant oscillator (DSRO) and confocal cavity enables the OPO threshold to be lowered considerably, resulting in a simple, compact, all-solid-state configuration with the mid-infrared idler powers of up to 466mW at 3.41μm.     

具有可调紫外滤光性能的富勒烯胺/壳聚糖共混膜的研究

通过溶液共混及流涎成膜法制备了一系列不同C60乙醇胺含量的壳聚糖共混膜。以及含Cu（Ⅱ）的C60乙醇胺/壳聚糖共混膜。研究表明，C60乙醇胺/壳聚糖共混膜具有优异的可调紫外滤光性能，随着C60乙醇胺含量的增加，其紫外滤光波长从200nm红移至400nm左右。在该复合体系中引入Cu（Ⅱ）能有效改善膜的紫外光学性能，同时还初步探讨了这类复合材料的紫外滤光机制。     

γ-辐照对纯Y_2SiO_5和Eu~(3+)∶Y_2SiO_5晶体光谱性能的影响

研究了γ-辐照前后纯Y2SiO5和Eu3+掺杂的Y2SiO5晶体吸收光谱的变化,辐照后,未退火和氢气退火的纯Y2SiO5晶体在260~270 nm和320 nm波段产生了附加吸收峰,分别是由F心和O-心的吸收引起的;经过空气退火的纯YSO晶体中,由于消除了氧空位,因此辐照后没有出现色心吸收峰。在Eu3+∶Y2SiO5晶体中,不但有相同的F心和O-心吸收峰,而且还有Eu2+离子在300 nm和390 nm的吸收峰。随着辐照剂量的增加,色心附加吸收峰增强。空气退火能减少Eu3+∶Y2SiO5晶体中的色心,而氢气退火能增加色心。     

Survivability in IP-over-WDM Networks: WDM Lightpath Protection versus IP LSP Protection

This article compares the performance of WDM lightpath protection and IP LSP protection schemes for IP-over-WDM networks. A mathematical formulation of the maximum throughput problem is presented and analytical expressions for recovery time are derived for both schemes. The throughputs and recovery times are analyzed and compared. Results show that the IP LSP protection scheme presents higher throughputs then WDM lightpath protection. The IP LSP protection scheme, providing individual IP LSP protection has, however, scalability problems. This scheme presents high recovery times when a failure affects many lightpaths and many hops are allowed for the primary routes of IP LSPs.     

机载海洋激光测深系统参量设计与最大探测深度能力分析

详细讨论了机载海洋激光测深系统最大测量深度与相关因子之间的关系，并利用最小可探测信噪比为判据，对机载海洋激光测深系统在白天和晚上工作进行了数值模拟，通过比较最大测量深度与激光脉冲峰值功率、接收视场角、接收口径和光谱接收带宽等关系，确定了系统的主要参量。以确定的参量建立的系统具有白天49m和晚上65m的最大测深能力，可完全满足在沿岸带以及岛礁的测量要求。     

Photorefractive Four-Wave Mixing Switches Utilizing Pockels Effect -Longitudinal and Lateral Switches-

We carried out detailed calculations for photorefractive wave-mixing switches based on one of three crystals with high electro-optic coefficients, namely, BaTiO₃, Strontium Barium Niobate (SBN (0.75)), and Potasium Sodium Strontium Barium Niobate (KNSBN). A comparison of results for the three crystals shows that a 0_-cut BaTiO³ crystal is suitable for a longitudinal switch and requires a voltage of about 80 for a 2-mm-thick crystal to induce sufficient phase mismatch. The electrodes must be transparent for the incident and diffracted beams. A 45_-cut SBN (0.75) crystal, however, is suitable for a lateral switch and requires a voltage of about 150 for a 1-mm-wide crystal. The electrodes do not need to be transparent.     

Measurements of Time-Varying Characteristics of Optical Signals and Inhomogeneities of Tested Substances with Additional Phase Modulation

The problem of investigation of the amplitude and phase structure of a time-varying probing optical signal and the structure of time-varying inhomogeneities of a substance tested by this signal is considered. The analysis is concerned, in particular, with determination of the structure of signals and processes with resolution in the pico- and femtosecond range. The scheme used for the analysis is based on registration of four spatially separated spectra of the studied radiation. The spectra are formed in a four-channel scheme with a twin-wave Michelson interferometer and a spectral device. Modulators based on electrooptical crystals (perovskites) are placed in the channels. The sum spectra are formed: without modulators, with the effect of either of the modulators, and with both of them affecting the radiation. The effect of the studied substance implies either modulating the radiation (in this case it is described by multiplication) or redistributing the radiation (then it is described by convolution).     

Φ520mmF/1.6椭球面反射镜加工

介绍了一块Φ520mm大相对孔径(F/1.6)轻量化椭球面反射镜的加工与检测方法。镜面的有效口径为Φ502mm,顶点曲率半径为1600mm,非球面系数k=-0.9663,面形精度要求优于0.025λ(RMS)。镜子背面有54个大小深浅不一的不通孔,用于减轻镜子的重量。采用WYKO干涉仪检测得到镜面面形误差达RMS0.02λ,λ=632.8nm。     

基于成像机理的小波包变换多聚焦图像融合

由于可见光成像系统的聚焦范围有限,因而在成像过程中,除聚焦良好的物体能生成清晰的图像外,该物体前后一定距离外的所有物体都将呈现不同程度的模糊.为了获得场景内所有物体均清晰的图像,在分析了多聚焦图像成像机理的基础上,提出了一种基于小波包变换的融合方法.它是将成像系统先聚焦在一部分对象上,得到其清晰的图像;然后再将其聚焦在另一部分对象上,得到另一清晰的图像;最后把这两幅实验图像加以融合,从而获得场景内所有物体均清晰的图像.实验结果表明,基于小波包变换的融合方法能够将信号的频带进行多层次划分,对高频成分也能进一步地分解,可有效综合多聚焦图像.     

三维光晶格中玻色凝聚气体基态波函数及干涉演化

基于Gross-Pitaevskii方程，运用有效化学势概念，研究了囚禁在组合势(由磁阱和三维光 晶格组成)中玻色凝聚气体在三维光晶格中的分布规律，并由此得到玻色凝聚气体的归 一化基态波函数.在取消组合势和仅取消光晶格而保留磁阱的两种情况下，运用传播子方 法求解出玻色凝聚气体密度分布的解析表达式.取消组合势后，理论计算所得到的玻色凝聚 气体聚随时间的演化规律与Greiner等的实验结果相一致.仅取消光晶格而保留磁阱时，研 究表明玻色凝聚气体的干涉模式呈现周期性的振荡行为.此外，在磁阱为各向异性的情况下 ， 关键词： 玻色凝聚气体 磁阱 光晶格 干涉模式