Flow and Sequential Injection Manifolds for the Spectrophotometric Determination of Captopril Based on its Oxidation by Fe(III)

 Two new simple and rapid methods are reported for the accurate and precise spectrophotometric determination of captopril (CPL) using flow (FI) and sequential injection (SI) analysis. The methods are based on the fast oxidation of CPL by Fe(III). The produced Fe(II) reacts with 2,2′-dipyridyl-2-pyridylhydrazone (DPPH) in acidic medium to form a colored complex which is monitored spectrophotometrically at 535 nm. Both methods allow the determination of the analyte up to 1000 mg L⁻¹ at a sampling rate of 120 and 60 injections per hour for FI and SI, respectively. The methods are very precise [s _r=0.8 and 1.2% at 500 mg L⁻¹ CPL (n=12) for FI and SI, respectively] and the 3σ detection limits (c _L=4.0 and 7.0 mg L¹, respectively) are quite satisfactory. Their application to a variety of anti-hypertensive commercial pharmaceutical formulations showed excellent results (relative errors, e _r, < ± 1.6% in all cases compared to an official HPLC method), while common pharmaceutical excipients were found not to interfere. Recovery experiments further verified the accuracy of the developed methods, as the percent recoveries were in the range of 98.1–102.5%. Author for correspondence. E-mail: themelis@chem.auth.gr Received May 9, 2002; accepted January 8, 2003 Published online May 5, 2003     

Analysis of the disaccharides derived from hyaluronic acid and chondroitin sulfate by capillary electrophoresis with sample stacking

CE conditions for monitoring the unsaturated disaccharides of hyaluronic acid (di-HA) and chondroitin sulfate (di-CS) using an alkaline tetraborate buffer, electrokinetic sample injection, and UV absorption detection at 232 nm are reported. Separations were performed in an uncoated fused-silica capillary having reversed polarity and reversed electroosmosis generated with the addition of CTAB to the buffer. The influence of various separation parameters, including the concentration of CTAB, buffer pH, concentration of tetraborate, and applied voltage, on the resolution of the two disaccharides was investigated. Baseline separation was obtained with 25 mM tetraborate at pH 10.0 and having 0.05 mM CTAB. Chloride and phosphate in the sample are beneficial for the stacking of the disaccharides, with di-HA forming a much sharper peak than di-CS. Using samples prepared in 25 mM Tris-HCl (pH 7.5) and electrokinetic injection at the cathode at -10 kV for 40 s, linear relationships between the corrected peak area and the concentration of the disaccharides have been found in the ranges of 1.0-400.0 and 0.1-1.0 microg/mL (0.2-1.0 microg/mL for di-CS), with correlation coefficients being >0.9933 in all cases. The RSDs of detection times and corrected peak areas were between 1.13-1.24 and 1.57-2.13%, respectively. Applied to human serum samples that were prepared by ethanol precipitation and depolymerization of the two polysaccharides with chondroitinase ABC reveals comigration of endogenous compounds with di-HA and a sample-dependent detection time. The di-HA content in the serum sample can be estimated via subtraction of the blank peak that is obtained without enzymatic hydrolysis.     

Determination of Gossypol in Trace Level by Flow Injection Analysis with Chemiluminescence Detection

Gossypol, [1, 1′, 6, 6′, 7,7′-hexahydroxyl-5,5′-diisopropyl-3,3′-dimethyl-(2,2′-binaphtha- lene)-8,8′-dicarboxaldehyde] is a polyphenolic yellow compound naturally occurring in various parts of cotton plants1. The compound has been associated with     

尿中肌酐的流动注射分析

本文提出了一种简便快速的尿中肌酐的测定方法。采用空气整段间隔试样带的流动注射分析体系,在非化学反应平衡的条件下测定,尿样不经手工稀释可直接用于测定。测样频率每小时为90次,相对标准偏差为1.5%。     

铁(Ⅲ)-邻菲啰啉体系流动注射-分光光度法测定药品中的抗坏血酸

本文基于抗坏血酸还原铁(Ⅲ)-邻菲啰啉为红色铁(Ⅱ)-邻菲啰啉,建立了流动注射分光光度法测定药品中抗坏血酸的方法。本法体系简单,操作方便、快速,标准加入试验的回收率为92～103％。     

Homogeneous chemiluminescence system in neutral and near neutral aqueous solution with ClO2 as oxidant and its analytical application

Using ClO₂ as chemiluminescence (CL) oxidant, a novel homogeneous CL system in neutral and near neutral aqueous solution is proposed in this paper. ClO₂ could oxidize sulfite in pH 5.0–8.5 acetate buffer to produce CL emission, and pipemidic acid could sensitize the CL system. The ClO₂–SO₃²⁻–pipemidic acid reaction was used as a model CL system and explored the possibility of highly active and eco-friendly ClO₂ being used as CL oxidant in neutral and near neutral aqueous solution. Combined with flow-injection analysis, the proposed CL system was applied to the automated dissolution testing of pipemidic acid tablet. Compared with the common strong acidic or strong basic CL system, this proposed CL owns its advantages.     

流动注射分析中样品分散与反应管长度的关系

根据串联釜模型给出样品分散度与通过管长的关系式，应用此式可以满意地解释分散度随管长的变化。     

痕量铜的合并带法流动注射分析——Fe~(3+)-S_2 O_3~(2-)-Cu~(2+)催化体系

本文基于 Cu~(2+)对三价铁离子与硫代硫酸盐反应生成深紫蓝色物质的褪色反应的催化作用采用流动注射合并带技术,建立了痕量铜(Ⅱ)的快速分析方法。方法的线性范围在0～350μg/L 检出限为10μg/L,相对标准偏差为1.68％,进样频率可达100样次/小时,具有很高的选择性。     

毛细管色谱直接进样法测定白酒中高碳脂肪酸乙酯的研究

介绍了采用ＦＦＡＰ键合毛细管柱直接进样测定白酒中５种高碳脂肪酸乙酯的方法，操作简捷，定量准确，检测限低达０４ｍｇ／Ｌ。用该法测定了各种香型近９０个白酒样品。改变色谱条件后，在一次直接进样分析中除能测定高碳脂肪酸乙酯外，而且还能对白酒中醇、酯、醛、酮以及有机酸等５２种香味组分进行定量测定，结果重现性良好。