Green ultra‐fast high‐performance liquid chromatographic method using a short narrow‐bore column packed with fully porous sub‐2 μm particles for the simultaneous determination of selected pharmaceuticals as surface water and wastewater pollutants

Fast separations are very desirable in laboratories that analyze large numbers of samples per day or those needing short turn‐around times. Traditional HPLC methods using conventional stationary phases and standard column dimensions require significant amounts of organic solvents and generate large volumes of waste. With growing awareness about the environment, the development of green technologies has been receiving increasing attention. In this work, a very fast green analytical method based on LC‐UV using a short narrow bore column packed with fully porous sub‐2 μm particles has been developed for simultaneous determination of nine pharmaceuticals in wastewater and surface water. The chromatographic separation was optimized in order to achieve short analysis time and good resolution for all analytes in a single run. All analytes could be separated in 1 min with good resolution. Sample preparation was executed by solid phase extraction using Oasis HLB cartridges. The method developed was validated based on parameters such as linearity, precision, accuracy, detection, and quantification limits. The recovery ranged from 70.9 to 92.5% with SDs not higher than 5.4%, except for acetaminophen and sulphanilamide. LODs ranged from 0.6–2.5 μg/L, while the LOQs were in the range 2–8 μg/L.     

Low‐density extraction solvent based solvent‐terminated dispersive liquid–liquid microextraction for quantitative determination of ionizable pesticides in environmental waters

A rapid, efficient, and new solvent terminated dispersive liquid–liquid microextraction technique coupled with HPLC was developed for selective extraction and analysis of s‐triazine herbicides from environmental water samples. Important parameters influencing the extraction process including type and volume of extraction and disperser solvent, extraction time, sample pH, ionic strength, and extraction temperature were successfully optimized. Under the optimal conditions, there are excellent linear relationships between the analytical results and concentration in the range of 10–400 mg/L for atrazine, propazine, prometryn, and terbutryn. LOD and LOQ ranged from 0.60 to 2.33 μg/L and 2.0 to 7.7 μg/L, respectively. Performance of the analytical technique was evaluated by carrying out the repeatability and reproducibility analyses that were ranged from 2.86 to 5.66% and 4.64 to 5.89% for 100 μg/L of each target analyte, respectively. The proposed method has been successfully applied to the analysis of real water samples and acceptable relative recoveries over the range of 65.93–101.46%, with RSDs ≤ 8.80%, were obtained. The overall results have been compared with the literature values. Thus, the method developed could efficiently be used for selective extraction of the target analytes from complex matrices, particularly environmental waters.     

Comparison of two types of vertically aligned ZnO NRs for highly efficient polymer solar cells

Vertically aligned ZnO nanorods (NR) are prepared by two different syntheses methods and applied on polymer solar cells (PSCs). The ZnO electrodes work as the electron transport layer with the P3HT:PCBM blend acting as the active material. Several organic blend solution conditions are optimized: concentration, solvent, and deposition speed. The effect of different NR electrode morphologies is analyzed on the solar cell performance and characterized by current–voltage curves and IPCE analyses. The photovoltaic performance of the solar cells was observed to be influenced by many factors, among them infiltration of the organic P3HT:PCBM blend within the ZnO NR layer. The infiltration of the active layer was monitored by cross section SEM and energy dispersive X-ray spectroscopy analyses. Our results show that higher power conversion efficiencies are achieved when shorter NRs lengths are applied. The best power conversion efficiency obtained was 2.0% for a 400 nm ZnO NR electrode. © 2012 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys, 2013     

Structure of polynuclear palladium(ii) hydroxocomplexes formed upon alkaline hydrolysis of palladium(ii) chloride complexes

The structure of polynuclear Pd^II hydroxocomplexes (PHC) formed as a result of alkaline hydrolysis of Pd^II chloride complexes was studied by EXAFS, SAXS, and TEM methods. It is established that in aqueous solutions a hydroxocomplex particle is a filament curled into a ball containing about 100 Pd atoms. The filament consists of planar coordination squares of PdO₄ units linkedvia one or two oxygen bridges of different geometry. Aging of samples results in an increase in the number of single bridging ligands and a decrease in the diameter of particles. Interatomic distances around palladium atoms were determined.Translated fromIzvestiya Akademii Nauk. Seriya Khimlcheskaya, No. 10, pp. 1901–1905, October, 1995.     

Novel properties of molecular assemblies of isoprenoid surfactants

Unlike micelles of straight hydrocarbon chain-surfactants, isoprenoid surfactants, CH₃ [CH(CH₃)CH₂CH₂CH₂]₃ CH(CH₃)CH₂–R (R=CH₂N⁺ (CH₃)₃ Br^–, CH₂OPO₃H^– Na⁺, CH₂OSO ₃ ^– Na⁺, CO ₂ ^– Na⁺), gave large globular and cellular assemblies in water which could be observed directly by transmission electron microscopy; critical micelle concentration of 0.31.4×10^–3 M at 20°C, aggregation number of 215×10⁴, and diameter of 200–2000 Å. A basic structure of the assemblies was a thin layer with a thickness (about 30 Å) which was close to the molecular length of the surfactants. The assemblies were decomposed during gel column chromatography; viz., they were not as stable as the liposomes of lecithins. The morphology was discussed in conjunction with a steric effect of the isoprenoid chain.     

硫化镉钠米微粒在聚合物网络中的组装

硫化镉钠米微粒在聚合物网络中的组装黄金满，杨毅，杨柏，刘式墉，沈家骢（吉林大学分子光谱与分子结构重点实验室、集成光电子国家重点实验室，长春，１３００２３）关键词组装，纳米微粒，离子交换，透射电子显微镜，电子衍射由于纳米半导体微粒的物理和化学性质介于分...     

PS／LDPE共混体系相结构的TEM研究

ＰＳ／ＬＤＰＥ共混体系相结构的ＴＥＭ研究徐世爱，江明，沈静姝（复旦大学高分子科学系和聚合物分子工程实验室，上海，２００４３３）（中国科学院化学研究所高分子物理开放实验室）关键词相结构，透射电镜，共混体系聚苯乙烯（ＰＳ）和低密度聚乙烯（ＬＤＰＥ）共混体...     

PS／LDPE共混体系形变机理的TEM研究

ＰＳ／ＬＤＰＥ共混体系形变机理的ＴＥＭ研究徐世爱，江明（复旦大学高分子科学系、聚合物分子工程实验室，上海，２００４３３）沈静姝（中国科学院北京化学所高分子物理开放实验室）关键词形变机理，银纹，透射电镜，共混物在ＰＳ／ＬＤＰＥ共混体系中加入接枝或嵌段共...     

Dicholorbenzyl alkyl ether homologs as retention index markers and internal standards for the analysis of environmental samples using capillary gas chromatography

A homologous series of 2,4-dichlorobenzyl alkyl ethers (DCBEs) have been synthesized and purified for use as retention index calibrants and internal standards. They are stable, sensitive to ECD and FID and ideal for GC-MS, with base peaks at m/z 159/161. The retention index calibration against the n-alkanes for a linear temperature program (LTP) series is given and recommendations made for the most suitable members of the DCBE series for use as internal standards in organochlorine (OC) residue analysis.     

悬浮床加氢裂化水溶性催化剂的筛选与表征

催化加氢作用, 当金属组分A和组分B浓度分别为 15 μg/g ～ 25 μg/g 和 1100 μg/g～1300 μg/g时催化剂具有较好的催化加氢活性。两元水溶性催化剂硫化后的XPS、XRD和TEM分析结果表明：活性组分经硫化反应后生成了金属硫化物,但组分A硫化率不足50％;组分B易硫化结晶,其晶粒成为组分A的硫化物晶粒或颗粒分散的“载体”,使组分A的硫化物具有较高的分散度,提高了催化剂的加氢活性;A-B双金属水溶性催化剂经硫化反应后所形成的颗粒尺寸在100 nm左右,说明两元金属催化剂在硫化结晶过程中确实存在相互分散和抑制晶粒增长的作用。