欧洲空调SCOP实验研究

在大力提倡节能降耗的新形势下,欧洲空调能效判别也由COP转向SCOP。文中分析了标准EN14825中房间空调器季节能效比(SCOP)的概念以及计算方法。通过变频空调在不同温度下的实验数据,计算出变频空调的SCOP。还研究了室外风扇转速、压缩机频率与制热量、COP的关系,这为2013年欧洲新产品的开发提供了参考依据。     

Very Low-Efficiency Droop in 293 nm AlGaN-Based Light-Emitting Diodes Featuring a Subtly Designed p-Type Layer

This paper reports an AlGaN-based ultraviolet-B light-emitting diode (UVB-LED) with a peak wavelength at 293 nm that was almost free of efficiency droop in the temperature range from 298 to 358 K. Its maximum external quantum efficiencies (EQEs), which were measured at a current density of 88.6 A cm^–2, when operated at 298, 318, and 338 K were 2.93, 2.84, and 2.76%, respectively; notably, however, the current droop (J-droop) in each of these cases was less than 1%. When the temperature was 358 K, the maximum EQE of 2.61% occurred at a current density of 63.3 A cm^–2, and the J-droop was 1.52%. We believe that the main mechanism responsible for overcoming the J-droop was the uniform distribution of the concentrations of injected electrons and holes within the multiple quantum wells. Through the subtle design of the p-type AlGaN layer, with the optimization of the composition and doping level, the hole injection efficiency was enhanced, and the Auger recombination mechanism was inhibited in an experimental setting.     

Optimization of ultrasonic-assisted extraction of astaxanthin from green tiger (Penaeus semisulcatus) shrimp shell

This study was aimed at optimizing the astaxanthin extraction efficiency from shrimp shell (green tiger, Penaeus semisulcatus). Astaxanthin was extracted using selected nonpolar/polar solvents (petroleum ether, n-hexane, ethanol, acetone) individually and in ternary mixtures of petroleum ether, acetone, and water in ratios of 15:50:35, 50:45:5, and 15:75:10 for different times (2,4 and 6 h). The results showed that solvents with higher polarity were more suitable for the extraction of astaxanthin, and increasing the extraction time from 2 to 6 h improved the extraction yield. The conditions of extraction of astaxanthin with the desirable solvent were then optimized with the ultrasonic method using the Box-Behnken design [variables included: extraction temperature (25 to 45 °C), extraction time (5 to 15 min), and ultrasound amplitude (20 to 100%)]. Optimal extraction conditions were determined as the ultrasonic amplitude of 23.6%, extraction time of 13.9 min, and extraction temperature of 26.3 °C. Under this optimum condition, the amount of astaxanthin, ferric reducing antioxidant power, and free radical scavenging capacity of the extract were obtained as 51.5%, 1705 μmol of Fe²⁺/g, and 73.9%, respectively. Extraction and analysis of the extract at the optimum point were used to validate the results.     

Phosphine-Manipulated p-π and π-π Synergy Enables Efficient Ultralong Organic Room-Temperature Phosphorescence

Organic room temperature phosphorescence (RTP) attracts extensive attentions, but still faces the challenge of achieving both high RTP efficiencies (η_RTP) and long lifetimes (τ_RTP), due to the intrinsic contradiction between triplet radiation and stabilization. In this work, we developed three carbazole-triphenylphosphine hybrids named xCzTPP, in which phosphine groups provide nonbonding electrons and steric hindrance to modulate intermolecular p-π and π-π interactions. With the rational orientations and spatial positions of functional groups, para-substituted pCzTPP achieves high η_RTP over 10 % and more than twofold increased τ_RTP (>600 ms), compared to ortho- and meta- isomers. Theoretical simulation and photophysical investigation indicate that the strongest intermolecular p-π and π-π electronic interplays of pCzTPP harmonize high transition probability of ³pπ state and triplet stability of ³ππ state, reflecting the p-π and π-π synergy in RTP process.     

Preparation of carbon-aerogel polypyrrole composite for desalination by hybrid capacitive desalination method

Capacitive Deionization (CDI) is an emerging technology with great potential applications. Most researchers view it as a viable water treatment alternative to reverse osmosis. This research reports the preparation and application of a carbon aerogel polypyrrole (CA-PPy) composite for the desalination of NaCl solution by the hybrid CDI method. The carbon aerogel (CA) was prepared from a Resorcinol / Formaldehyde precursor by the sol–gel method. The aerogel obtained from the sol–gel was then pyrolysed in a tube furnace to form CA. Polypyrrole (PPy) was prepared by the Oxidative chemical polymerisation of pyrrole, ferric chloride hexahydrate (oxidant), and sodium dodecyl sulfate (dopant). A composite of CA and PPy was then prepared and used to modify carbon electrodes. The CA-PPy composite was characterised to verify its composition, morphology, thermal properties, and functional groups. The electrochemical properties of the material were determined by Cyclic voltammetry (CV) and Electrochemical impedance spectroscopy (EIS) tests. The electrochemical tests were done using a GAMRY potentiostat electrochemical workstation, a 1.0 M KCl was used as the electrolyte, and the applied potential window was (-0.2 to + 0.6) V for the CV test. The EIS test was done with the same concentration of KCl electrolyte at an applied potential of 0.22 V and at a frequency range of (0.1 – 100, 000) Hz. The optimal specific capacitance of the CA is 115F/g, and that of the composite is 360.1F/g, they were both obtained at a scan rate of 5 mV/s. The CDI desalination study of the CA-PPy composite showed a salt adsorption capacity (SAC) of 10.10 mg/g (300 mg/L NaCl solution) – 15.7 mg/g (800 mg/L NaCl solution) at 1.2 V applied voltage. The salt recovery efficiency of the electrode material in the 300 mg/L solution is 27 %, in the 500 mg/L solution, it is 20.12 %, and in the 800 mg/L solution, it is 15.41 %. The electrode material also showed good electrochemical stability after nine cycles of ion adsorption/desorption study.     

Morphology Optimization of the Photoactive Layer through Crystallinity and Miscibility Regulation for High-performance Polymer Solar Cells

On the premise of strongly crystalline materials involved, it is a challenge to control the phase separation of bulk-heterojunction donor/acceptor active layer to fabricate high-performance polymer solar cells (PSCs). Herein, we develop a molecular design strategy of the third component to synthesize three guest materials (namely BTPT, BTP-Th, and BTP-2Th) to address this issue. We investigate and reveal the effect of crystallinity and miscibility of the third component in controlling the phase separation of Y6-derivatives-based blend film. As a result, a remarkable power-conversion efficiency of 18.53 % is obtained in the ternary PSC based on PTQ10 : m-BTP-PhC6 with BTP-Th as the third component, which is a significant improvement with regard to the efficiency of 17.22 % for the control binary device. Our study offers a molecular design strategy to develop a third component for building ternary PSCs in terms of crystallinity and miscibility regulation.     

Effect of inlet volute wrap angle on the flow field and performance of double inlet gas cyclones

In response to the divergent understanding of double inlet cyclone performance in the literature, the effect of inlet volute wrap angle on the performance and flow field of double inlet cyclone separator was studied by Computational Fluid Dynamic (CFD) method. The results showed that the inlet volute wrap angle can affect the comparison results of the single and double inlet gas cyclones with the same total inlet cross-sectional area and velocity. 0° and 90° volute double inlet improved the efficiency mainly by separating particles below 10 μm, while 180° volute double inlet had no separation advantage for any particles, so the symmetrical double inlet does not always improve the efficiency, and the appropriate inlet volute wrap angle should be selected according to the actual situation, otherwise, the expected performance requirements of the symmetrical double inlet cyclone cannot be achieved. Compared with the flow field, it is found that the inlet volute wrap angle changed the tangential velocity of the symmetrical double inlet cyclone separator, thus changing the performance.     

Efficient Multiple Domain Ligation for Proteins Using Asparaginyl Endopeptidase by Selection of Appropriate Ligation Sites Based on Steric Hindrance

Three domain fragments of a multi-domain protein, ER-60, were ligated in two short linker regions using asparaginyl endopeptidase not involving denaturation. To identify appropriate ligation sites, by selecting several potential ligation sites with fewer mutations around two short linker regions, their ligation efficiencies and the functions of the ligated ER-60s were examined experimentally. To evaluate the dependence of ligation efficiencies on the ligation sites computationally, steric hinderances around the sites for the ligation were calculated through molecular dynamics simulations. Utilizing the steric hindrance, a site-dependent ligation potential index was introduced as reproducing the experimental ligation efficiency. Referring to this index, the reconstruction of ER-60 was succeeded by the ligation of the three domains for the first time. In addition, the new ligation potential index well-worked for application to other domain ligations. Therefore, the index may serve as a more time-effective tool for multi-site ligations.