用于机械振动实时监测的光纤光栅有源传感装置

把一对中心反射波长分别为1562.11nm和1562.71nm的光纤光栅粘贴在均质、等厚、等腰三角形悬臂梁上下表面作为环形腔光纤激光器端镜，当机械振动激励自由端时，通过观测激光输出脉冲，地施加于自由端的机械振动的频率进行了实时监测；观察两光栅波长漂移量差值的变化，可在0～6.1mm的范围内判断所测振动的振幅。低于100Hz时，实验结果与实际值基本吻合。     

连续激光诱导Zn/InP掺杂过程中温度分布的解析计算

在实验的基础上，分析表面蒸发Zn的InP样品在连续激光诱导下掺杂Zn过程.在一维热传导问题的第三类边界条件下，给出激光辐照有限厚双层材料Zn/InP温度分布的一种直观简洁的解析形式. 关键词： 激光诱导掺杂 Zn/InP 温度分布     

偏振分束器对光学电流传感器稳定性的影响

采用偏振光学理论,详细分析了光学电流传感器中偏振分束器消光比的变化对传感器性能的影响,得到了偏振分束器消光比与传感器输出的关系式,并用系统实验进行了验证.理论及实验结果的吻合证明了光学电流传感器稳定性直接受偏振分束器两路消光比影响的结论.     

Fiber-Optic Chemical Sensor for Detection of NO2 Using Poly (3-Octylthiophene)

A fiber-optic chemical sensor (FOCS) for detection of nitrogen dioxide (NO₂) molecules is reported. The FOCS presents an optropode structure because of the transmission properties of the sensitive material. The NO₂ FOCS is activated by using the semiconductor polymer: regioregular head-to-tail poly(3-octylthiophene-2,5-diyl). The operation wavelength of the sensor is 543.5 nm such that a simple LED and detector can be used for the design of this device. The sensor response decreases after each exposure, demonstrating the reduction in sensitivity as well as irreversibility lower than 5%. However, its properties such as rapid response, high selectivity, high sensitivity (0.43 ± 0.01 muW/ppm), hygroscopic properties, and its operation at room temperature make this kind of FOCS a good alternative for NO₂ toxic gas detection.     

Analysis on Shack–Hartmann wave-front sensor with Fourier optics

In Shack–Hartmann wavefront sensor (SHWS), the behavior of the irradiance pattern produced by the micro-lens array is important for an accurate centroid estimation. In this paper, the behavior of a micro-lens array in SHWS is analyzed using Fourier optics, and reveals that in addition to the main, expected spots, secondary spots with smaller intensities also appeared as a result of diffraction by the small dimensions of the micro-lens and interference from the different micro-lenses. This result is confirmed by comparing with a irradiance pattern taken from an actual SHWS. The additional error in centroid estimation caused by these secondary spots is discussed and relationship to the parameters of the micro-lens of SHWS is analyzed.     

Synthesis and refractive‐index control of fluoropolymers by the polyaddition of bis(epoxide)s and triazine di(aryl ether)s

The polyaddition of fluorine‐containing bis(epoxide)s and fluorine‐containing triazine di(aryl ether)s were examined to give the corresponding fluorine‐containing poly(cyanurate)s. It was observed that the synthesized fluoropolymers had good thermal stabilities and good film‐forming properties. The glass transition temperatures (T_g's) and refractive‐indices (n_D's) of synthesized polymers were determined by differential scanning calorimetry and ellipsometry, respectively, and it was found that the values of T_g's and n_D's were supported by their fluorine containing ratios and skeletons. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 4421–4429, 2007     

Evidences of phase separation in moisture‐cured poly(urethane urea)s by means of temperature modulated differential scanning calorimetry

The degree of phase separation in several moisture‐cured poly(urethane urea)s (PUUs) was studied by FTIR spectroscopy, wide angle X‐ray diffraction (WAXD), and temperature‐modulated differential scanning calorimetry (TMDSC). This latter technique was shown to be particularly useful in analysing the degree of phase separation in PUU polymers. Both phase mixing and phase segregation coexisted in the PUUs and the degree of phase separation increased as the urea hard segment (HS) content in the PUU increased. The maximum solubility of urea HSs into the polyol soft segments (SSs) was achieved for 50 wt % urea HS content in diol‐based PUUs, whereas for triol‐based PUUs the highest solubility between HS and SS was reached for lower urea HS amount. Finally, the higher the urea HS content the higher the extent of phase separation in the PUU. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 3034–3045, 2007     

碳纳米管阵列、捆束的三步升温工艺制备及其形貌与结构

使用结构简单的单温炉设备，通过三步升温热解二茂铁、三聚氰氨混合物方法，在二氧化硅、多晶陶瓷基底上分别合成了碳纳米管阵列、碳纳米管捆束.使用扫描电子显微镜、透射电子显微镜、电子能量损失谱和x射线光电子能谱对合成样品进行了结构和成分分析.结果显示：两种基底上合成的纳米管均为多壁纯碳管；生长于光滑二氧化硅表面的碳纳米管具有高度取向性和一致的外径，长度为10—40μm.碳纳米管采取催化剂顶端生长模式并展示出类杯状形貌；生长于粗糙多晶陶瓷表面的碳纳米管捆束随机取向，碳纳米管直径为15—80nm，长度在几百微米，展示 关键词： 碳纳米管 热解法 三步升温工艺     

数码相机CMOS图像传感器的特性参数与选择

介绍了数码相机的核心器件———CMOS图像传感器的特性参数和在数码相机设计过程中CMOS图像传感器的选择。选择CMOS图像传感器,不仅需要考虑包括传感器的尺寸、像素总数和有效像素数、最小照度、动态范围、灵敏度、分辨力、光电响应不均匀性以及光谱响应等在内的特性参数,而且还要考虑电源管理和功耗、模数转换位数、开发的简便性以及成本等因素。     

Temperature coefficient of NH chemical shifts of thioamides and amides in relation to structure

NH chemical shift temperature coefficients have been measured in a large series of N-substituted-3-piperidinethiopropionamides in which the NN distances are short but of varied length, as well as in a couple of the corresponding amides and in some simpler amides and thioamides. Geometries are calculated by means of ab initio DFT methods. The N-substituted-3-piperidinethiopropionamides show in most cases strong intramolecular N–HN hydrogen bonds according to IR spectra and ab initio calculations. For compounds with rather short NN distances the S=C–N–H moiety is non-planar. Dihedral angles as small as 160° are found. The NH chemical shift coefficients measured in non-polar solvents in all the N-substituted-3-piperidinethiopropionamides are more negative (−8 to −17 ppb/K) than in non-hydrogen bonded thioamides. For the latter in non-polar solvents like CDCl₃ and toluene the temperature coefficients are as small as −1 to −4 ppb/K. The large negative effects can be related not only to the non-planarity of the thioamide group in a way that the more pronounced the non-planarity the more negative the temperature coefficients, but also to strong hydrogen bonding and the fact that the acceptor is a nitrogen. For similar amides with non-planar amide groups and nitrogen acceptor large negative temperature coefficients are likewise seen. In polar solvents like DMF the effects in simple thioamides are uniform and close to −6 ppb/K, whereas in the more complex compound like 4p(t) the temperature coefficient is close to 0. An essential feature of measuring temperature coefficients of compounds without strong intramolecular hydrogen bonds in non-polar solvents and at low temperatures is to keep the concentration low enough to avoid dimerisation.