垃圾在流化床中焚烧NO排放特性研究

在Ф150 mm流化床上，研究了六类典型组分垃圾NO转化率与床温和过量空气系数(excess air简称EA)的关系。研究发现，纸渣与木块NO转化率最高，橡胶与塑料最低;织物、纸张、厨余、木块、塑料NO均具有中温生成特性，一般在800 ℃～850 ℃时即接近最大值，之后温度升高对NO的生成影响不大;橡胶与无烟煤由于含N化合物结构稳定，其NO转化率随床温升高而增大;由于挥发分析出的相互影响，较低的火焰温度，混合垃圾NO转化率一般低于单组分垃圾的线性叠加;少量水分不会对垃圾NO转化率造成很大影响，相反还会促进NO的转化，但过量水分会抑制NO的生成。     

An NMR study of methanol diffusion in polymer electrolyte fuel cell membranes

Methanol diffusion in two polymer electrolyte membranes, Nafion 117 and BPSH 40 (a 40% disulfonated wholly aromatic polyarylene ether sulfone), was measured using a modified pulsed field gradient NMR method. This method allowed for the diffusion coefficient of methanol within the membrane to be determined while immersed in a methanol solution of known concentration. A second set of gradient pulses suppressed the signal from the solvent in solution, thus allowing the methanol within the membrane to be monitored unambiguously. Over a methanol concentration range of 0.5–8 M, methanol diffusion coefficients in Nafion 117 were found to increase from 2.9 × 10⁻⁶ to 4.0 × 10⁻⁶ cm² s⁻¹. For BPSH 40, the diffusion coefficient dropped significantly over the same concentration range, from 7.7 × 10⁻⁶ to 2.5 × 10⁻⁶cm² s⁻¹. The difference in diffusion behavior is largely related to the amount of solvent sorbed by the membranes. Increasing the methanol concentration results in an increase in solvent uptake for Nafion 117, while BPSH 40 actually excludes the solvent at higher concentrations. In contrast, diffusion of methanol measured via permeability measurements (assuming a partition coefficient of 1) was lower (1.3 × 10⁻⁶ and 6.4 × 10⁻⁷ cm² s⁻¹ for Nafion 117 and BPSH 40 respectively) and showed no concentration dependence. The differences observed between the two techniques are related to the length scale over which diffusion is monitored and the partition coefficient, or solubility, of methanol in the membranes as a function of concentration. For the permeability measurements, this length is equal to the thickness of the membrane (178 and 132 μm for Nafion 117 and BPSH 40 respectively) whereas the NMR method observes diffusion over a length of approximately 4–8 μm. Regardless of the measurement technique, BPSH 40 is a greater barrier to methanol permeability at high methanol concentrations.     

Characterization of Heterogeneous Catalysts by use of Test Reactions

The following report gives an overview on work done in the Catalysis Laboratory of the Department of Chemistry, National University of Singapore over the last 15 years (1989–2004). Much of this work can be described as “characterization of catalytically active surfaces through test reactions”. The methods, systems studied and the reactions that we evaluated will be described. The review will mostly concentrate on work from the authors’ laboratory, but other relevant work will also be cited.     

熔融反应合成2,2′-联吡啶桥联二（4,4′-联吡啶）类哑铃型化合物

无溶剂反应;联吡啶;固相熔融;哑铃型化合物     

Room Temperature Solid State Reaction Involving Structural Transformation of Covalent Oxide Network

An interesting structural transformation from a two dimensional (2d) covalent oxide network with a layered structure to a three-dimensional (3d) network with a tunnel structure was found at room temperature in the mixture of hydrated alkali-metal molybdenum bronze and amorphous alkali-metal molybdate. From various experimental results it was concluded that the transformation was due to a room temperature solid state reaction.     

From solution-phase to solid-phase enyne metathesis: crossover in the relative performance of two commonly used ruthenium pre-catalysts

A crossover in the ability of two distinct ruthenium-based metathesis pre-catalysts to effect the synthesis of dialkenylboronic esters in solution and on the solid-phase was observed. Specifically, while the Grubbs 2nd generation pre-catalyst 3 affords a greater degree of conversion to product than the Hoveyda-Grubbs pre-catalyst 2 in a solution-phase enyne-metathesis reaction, this trend is reversed in the solid-phase variant. Systematic investigation showed this trend to be general, regardless of variations in the homoallylic alcohol and alkynylboronic ester components of the reaction, as well as in the type of solid support employed. Experiments to determine a mechanistic hypothesis for this trend highlighted the significance of the ruthenium remaining bound to the substrate after metathetic rearrangement and found the presence of phosphine ligand to be detrimental to the success of the solid-phase reaction. Therefore, these results suggest an expanded role for phosphine-free pre-catalysts, such as 2, in challenging solid-phase metathesis reactions.     

Volumetric properties of the boldine + alcohol mixtures at atmospheric pressure from 283.15 to 333.15 K: A new method for the determination of the density of pure boldine

Densities of boldine + alcohol binary mixtures were measured over the whole accessible range of boldine compositions at temperatures from 283.15 to 333.15 K using an Anton-Paar digital vibrating glass tube densimeter. The binary systems studied include, as a solvent, seven normal alcohols from n-C₁ to n-C₆, n-C₈, and isopropanol. The density of these systems has been found an increasing function of the boldine composition. A new methodology based on density data of solutions of solid solutes with normal alcohols is described in order to determine solid molar volume of pure solutes. This methodology was validated with pure solid naphthalene molar volumes data at 298.15 K, with an average uncertainty of 6%.     

Stability of workroom air volatile organic compounds on solid adsorbents for thermal desorption gas chromatography

The storage stability of the occupationally frequently occurring compounds, methylethylketone, methylisobutylketone, benzene, toluene, tetrachloroethylene, n-butylacetate, -pinene, β-pinene, limonene and n-decane, has been investigated on the adsorbents Tenax TA, Chromosorb 106 and Carbotrap using thermally desorbable tube type samplers, commonly utilized in ambient and workroom atmospheric measurements. Fifty and 500 ng of each compound were loaded on the various adsorbents tubes, stored at both ambient (20 °C) and refrigerated (4 °C) temperatures and analysed by means of thermal gas chromatography with mass spectrometric detection on days 0, 7, 14 and 28 after exposure. A 90% storage recovery was chosen as acceptance criteria for storage stability, and statistical testing by Student's t-test, analysis of variance and Bonferroni post hoc tests were employed to investigate the effect of the categorical variables storage time, storage temperature and analyte loading on the different adsorbents. Chromosorb 106 showed the overall best behaviour with recoveries of 90% or better for all analytes during the 28-day test period. Tenax TA and Carbotrap yielded lower recoveries and were more influenced by variations in storage time, storage temperature and analyte loading. Refrigerated temperatures were best avoided for storage on Tenax TA, but may increase the recovery of some compounds on Carbotrap (e.g. n-butylacetate). The blank build-up on the adsorbents was also investigated, and Carbotrap and Tenax TA showed no signs of artefact development over time. Chromosorb 106, however, contained inherently more artefacts that build up over time, which in spite of the excellent storage capability, may limit its use in field studies where long storage times are normal.     

The Many Measures of Molecular Dimensions

In contrast to the high precision with which masses of atoms and molecules can be specified, their external dimensions remain intrinsically fuzzy. Attention is directed to the difference between measurements of interatomic separations within molecules, that in many instances are cited with error bars of +/– 0.002 Å, and the available approximate magnitudes of over-all sizes, needed for estimating packing densities (in solids or liquids). The following account, is a critical examination of the underlying concepts and of the diversity of data in the literature, regarding internal dimensions (bond lengths), overall extensions, cross-sectional areas, and volumes of molecules that may be derived from a variety of experiments. Historical markers of the evolution of the underlying theories and experiments are included.     

Two-dimensional double-quantum 2H NMR spectroscopy in the solid state under OMAS conditions: correlating 2H chemical shifts with quasistatic line shapes.

Solid-state 2H NMR spectroscopy is a well-established and versatile method to study molecular orientation and dynamics in selectively deuterated samples. Herein, we introduce a 2D 2H double-quantum (DQ) NMR experiment performed under fast magic-angle spinning with a slight offset of the magic angle (OMAS). The experiment combines 2H chemical-shift resolution with DQ-filtered quasistatic 2H line shapes. In this way, it is possible to separate 2H resonances and to independently determine 2H quadrupole couplings at multiple sites. While 2H chemical shifts are resolved in the 2H DQ dimension, the quadrupole parameters can be obtained from characteristic line shapes which are reintroduced in the second dimension by the magic-angle offset. The 2D 2H DQ OMAS experiment is demonstrated on L-histidine which was deuterated at multiple sites by recrystallisation from D2O.