Characterization of the solid phases of paracetamol and fenamates at equilibrium in saturated solutions

Differential scanning calorimetry (DSC), supported by hot stage microscopy, IR spectroscopy and X-ray powder diffractometry, was used to investigate the characteristics of the solid phases of mefenamic, niflumic, and flufenamic acids and of paracetamol, before and after equilibration with saturated solutions in different solvents. Mixtures of Lewis base (dioxane and ethyl acetate) and amphiprotic solvents (ethanol and water) were prepared for evaluating the influence of both nature and polarity of the solvents. Solid-state analysis performed on the original samples (commercial products) made it possible to establish that paracetamol, mefenamic acid and flufenamic acid were in their respective Form I. No polymorphic modifications are known for niflumic acid. Paracetamol, niflumic and mefenamic acids did not show any change after equilibration with the various solvents or solvent mixtures, regardless of their different chemical nature. In contrast, DSC, IR and X-ray analyses revealed the partial recrystallization of flufenamic acid into its polymorphic Form III in solid phases at equilibrium with ethanol, ethyl acetate and their blends, as well as in dioxane-water mixtures containing 30 to 100% dioxane and in ethanol-water mixtures with a water content less than 50%. This revised version was published online in July 2006 with corrections to the Cover Date.     

Identification of micro-scale calorimetric devices

Micro-calorimetric devices using Si-based sensors are very useful for the study of gas–solid reactions, in which very low mass of reactants are necessary. But in fact the consequence of using flat detectors is an increase of the uncertainty in the measured energy. In this work a calorimetric gas sensor based on Xensor chip is analysed studying the local x–y contributions of dissipation to the sensitivity related to the value in the centre. We study also the effects of the gas-flow on the sensitivity, comparing the results obtained with two Xensor type chips. Finally we carry out a deeper analysis of the x–y effects on the calorimetric detector for dissipations in the reactant shell extremely close to the detector surface to visualize the link between the power density distribution and the output signal.     

Synthesis of functionalized rab GTPases by a combination of solution- or solid-phase lipopeptide synthesis with expressed protein ligation

Prenylated proteins with non-native functionalities are generally very difficult to obtain by recombinant or enzymatic means. The semisynthesis of preparative amounts of prenylated Rab guanosine triphosphatases (GTPases) from recombinant proteins and synthetic prenylated peptides depends largely on the availability of functionalised prenylated peptides corresponding to the proteins' native structure or modifications thereof. Here, we describe and compare solution-phase and solid-phase strategies for the generation of peptides corresponding to the prenylated C terminus of Rab7 GTPase. The solid-phase with utilisation of a hydrazide linker emerges as the more favourable approach. It allows a fast and practical synthesis of pure peptides and gives a high degree of flexibility in their modification. To facilitate the analysis of semisynthetic proteins, the synthesised peptides were equipped with a fluorescent group. Using the described approach, we introduced fluorophores at several different positions of the Rab7 C terminus. The position of the incorporated fluorescent groups in the peptides did not influence the protein-ligation reaction, as the generated peptides could be ligated onto thioester-tagged Rab7. However, it was found that the positioning of the fluorescent group had an influence on the functionality of the Rab7 proteins; analysis of the interaction of the semisynthetic Rab7 proteins with REP (Rab escort protein) and GDI (guanosine diphosphate dissociation inhibitor) molecules revealed that modification of the peptide side chains or of the C-terminal isoprenoid did not significantly interfere with complex formation. However, functionalisation of the C terminus was found to have an adverse effect on complex formation and stability, possibly reflecting low structural flexibility of the Rab GDI/REP molecules in the vicinity of the lipid-binding site.     

Reactivity in the solid state between CoWO4 and RE2WO6 where RE = Sm, Eu, Gd

Reactivity in the solid state between CoWO₄ and some rare-earth metal tungstates RE₂WO₆ (RE = Sm, Eu, Gd) was investigated by the XRD method. Two families of new isostructural cobalt and rare-earth metal tungstates, Co₂RE₂W₃O₁₄ and CoRE₄W₃O₁₆, were synthesized. The Co₂RE₂W₃O₁₄ phases are formed by heating in air the CoWO₄ and RE₂WO₆ compounds mixed at the molar ratio 2:1, while the CoRE₄W₃O₁₆ phases are synthesized at the molar ratio of CoWO₄/RE₂WO₆ equals to 1:2. The Co₂RE₂W₃O₁₄ phases as well as the CoRE₄W₃O₁₆ compounds crystallize in the orthorhombic system. The Co₂RE₂W₃O₁₄ and CoRE₄W₃O₁₆ compound melt above 1150 °C. A melting manner of the Co₂RE₂W₃O₁₄ and CoRE₄W₃O₁₆ compounds was determined in an inert atmosphere. The formation of CoWO_4−x phase was observed during heating in an inert atmosphere.     

Dependence of Elution Curve and Adsorption Isotherms of Insulin on composition of Mobile Phase of Frontal Analysis in Reversed Phase Liquid Chromatography

With frontal analysis(FA),the dependence of adsorption isotherms of insulin on the composition of mobile phase in reversed phase liquid chromatography (RPLC) has been investigated,This is also a good example to employ the stoichiometric displacement theory (SDT) for ivestigating solute adsorption in physical chemistry.Six kinds of mobile phase in RPLC were employed to study the effects on the elution curves and adsorption isotherms of insulin.the key points of this paper are:(1) the stability of insulin due to delay time after preparing,the organic solvent concentration,the kind and the concentration of ion-pairing agent in mobile phase were found to affect both elution curve and adsorption isotherm very seriously.(2)To obtain a valid and comparable result,the composition of the mobile phase employed in FA must be as same as possible to that in usual RPLC of either analytical scale or preparative purpose.(3)Langmuir Equation and the SDT were employed to imitate these obtained adsorption isotherms.The expression for solute adsorption from solution of the SDT was found to have a better elucidation to the insulin adsorption from mobile phase in RPLC.     

A new approach for fluorine determination by solid sampling graphite furnace molecular absorption spectrometry

This work deals with the determination of fluorine by solid sampling graphite furnace molecular absorption spectrometry. The molecular absorbance of aluminum monofluoride (AlF), which is produced in the vapor phase in the presence of Al³⁺, is measured at 227.5 nm, a non-resonant platinum line. A conventional graphite furnace program has been used with pyrolysis and vaporization temperatures of 800 and 2300 °C, respectively. Solutions of Ba²⁺ and Al³⁺ have been used to avoid fluorine losses during the pyrolysis stage and to produce AlF in the vaporization stage, respectively. Certified coal and alumina samples were analyzed using aqueous standards for calibration. The agreement between the found concentration and the certified value, or the value obtained by another method ranged from 92 to 105%, with a relative standard deviation less than 8.5%. The limit of detection and the characteristic mass was 0.17 μg g^− 1 and 205 pg, respectively.     

分散固相萃取结合气相色谱-高分辨质谱快速筛查酱油中多种氯丙醇

建立了酱油中1，3-二氯-2-丙醇、2，3-二氯-1-丙醇、3-氯-1，2-丙二醇和2-氯-1，3-丙二醇的分散固相萃取-气相色谱-高分辨质谱快速筛查检测方法。样品采用乙酸乙酯提取，提取液浓缩后经N-丙基乙二胺净化，气相色谱-高分辨质谱测定，内标法定量。结果表明，该方法对于酱油中4种氯丙醇的定量限为0.5~10 μg/kg。在3个浓度水平下的加标回收率为78%~103%；相对标准偏差均不大于8.8%。该方法快速、简便、准确、灵敏，可作为酱油中4种氯丙醇的有效检测方法。     

Composting of urban solid residues (USR) by different dispositions

The thermal behavior and non-isothermal kinetics of thermal decomposition of three different kinds of composting of the USR like: stack with drilled PVC tubes (ST), revolved stack (SR) and stack with material of structure (SM), from the usine of composing of Araraquara city, Săo Paulo state, Brazil, within a period of 132 days of composting were studied. Results from TG, DTG and DSC curves obtained on inert atmosphere indicated that the cellulosic fraction present, despite the slow degradation during the composting process, is thermally less stable than other substances originated from that process. Due to that behavior, the cellulosic fraction decomposition could be kinetically evaluated through non-isothermal methods of analysis. The values obtained were: average activation energy, Ea=248, 257 and 259 kJ mol^-1 and pre- exponential factor, logA=21.4, 22.5, 22.7 min^-1, to the ST, SR and SM, respectively. From Ea and logA values and DSC curves, Málek procedure could be applied, suggesting that the SB (Šesták-Berggren) kinetic model is the appropriated one to the first thermal decomposition step. This revised version was published online in July 2006 with corrections to the Cover Date.     

偏钛酸型锂离子交换剂固相合成反应动力学

偏钛酸型锂离子交换剂固相合成反应动力学钟辉＊郭灵虹（成都理工学院应用化学系成都６１００５９）（四川联合大学分析测试中心成都）关键词偏钛酸锂，离子交换剂，合成，固相反应动力学１９９７－０８－２５收稿，１９９７－１２－１０修回四川省应用基础研究基金资助项...     

NdOx作为助催化剂对PtRu/C电催化氧化甲醇活性的影响

采用沉积-还原法制备了PtRu-NdOx/C催化剂, 借助TEM、EDS和XRD等测试手段对其进行了微结构和组成的表征. 结果表明, 催化剂中Pt与Ru以合金形式存在, 而Nd的氧化物则以无定形形态存在. 催化剂粒子的平均粒径在2 nm左右, 晶胞参数为0.3896 nm, Nd氧化物的加入对PtRu合金的晶体结构影响不明显. 采用循环伏安法和计时电流法, 比较了PtRu-NdOx/C催化剂和PtRu /C催化剂对甲醇氧化的电催化活性, 结果表明, 加入Nd的氧化物作为助催化剂能明显提高PtRu /C催化剂对甲醇氧化的电催化性能.