A Three-Dimensional Two-Phase Model for Thermal Plasma Chemical Vapor Deposition with Liquid Feedstock Injection

In this paper, a comprehensive model for thermal plasma chemical vapor deposition (TPCVD) with liquid feedstock injection is documented. The gas flow is assumed to be steady, of a single temperature. Radiation and charged species contributions are excluded, but extensive homogeneous and heterogeneous chemistry is included. The liquid phase is traced by considering individual droplets. Discussion on the model's application to diamond production from acetone in a hydrogen–argon plasma is included. The major conclusions are: (1) Liquid injection possesses a capability to deliver the hydrocarbon precursor directly onto the deposition target. (2) For the case of complete evaporation of the droplet before reaching the substrate, the deposition rate is similar to that obtained with gaseous precursors. (3) The computational results compare well with experimental data. The modeling results can be used to optimize the injection parameters with regard to the deposition rate.     

Neutral oxygen atom density in the MESOX air plasma solar furnace facility

The density of neutral oxygen atoms in the MESOX set-up, one device of the PROMES-CNRS solar facilities, was determined by a fiber-optics catalytic probe (FOCP). Plasma was created in a flowing air within a quartz tube with the outer diameter of 5 cm by a 2.45 GHz microwave generator with the output power up to 1000 W. The flow of air was varied between 4 and 20 l/h. The O-atom density was found to increase monotonously with the increasing discharge power, and it decreased with the increasing flow rate. The degree of dissociation of oxygen molecules in the plasma column depended largely on the flow rate. At the air flow of 4 l/h it was about 80% but it decreased to about 20% at the flow of 20 l/h.     

Direct analysis of fly ash materials by inductively coupled plasma atomic emission spectrometry using slurry nebulization

Fly ash samples of cement works were analysed using slurry nebulization inductively coupled plasma atomic emission spectrometric (ICP-AES). Because of the influence of the experimental factors on the signal intensity, the optimal conditions of the analysis circumstances were determined. Control analyses (wet digestion followed by ICP-AES, and XRF of dry powders (pressed pellets)) were also carried out to compare the results. Based on the result, it was concluded that the slurry nebulization method using slurry standard of same type reference material for calibration can be applied for rapid but less precise (RSD 5–10%) determination of the elements in fly ash.     

毛细管电泳-电感耦合等离子体原子发射光谱法对田七提取液中Fe、Cu和Mg存在状态的研究

提出了以水作溶剂微波萃取提取,并以毛细管电泳电感耦合等离子体原子发射光谱(CE-ICP-AES)法测定田七提取液中Mg、Cu和Fe的形态的分析方法。实验结果表明:Mg仅以游离态存在;而Cu和Fe除了游离态以外,还存在其它三种未知的形态。此外,还测定了田七中20个微量元素的总含量,并得到了上述待测元素在水提取液中的提取率。     

Solid-phase microextraction–capillary gas chromatography combined with microwave-induced plasma atomic-emission spectrometry for selenite determination

The use of solid-phase microextraction (SPME) with gas chromatography coupled to microwave-induced plasma atomic-emission detection (GC–MIP-AED) is described for selenite [Se(IV)] speciation. Aqueous standards were derivatised with sodium tetraethyl- or tetrapropylborate and extracted by SPME. Headspace extraction of the ethyl and propyl derivatives was studied. Relevant experimental conditions were optimised, including conditions for derivatisation and extraction and those of gas chromatographic analysis. The limits of detection achieved for headspace sampling of derivatised Se(IV) were in the low ng mL^–1 range for both ethylation and propylation. When the method was applied to analysis of selenite in selenised yeast reference material results were in good agreement with the indicated values.     

Metabolomic-based investigation of Yinlan alleviating hyperlipidemia by inhibiting blood stasis and phlegm turbidity through the PXR-CYP3A4-ABCB1-FXR pathway

Yinlan lipid regulatory capsule (YL) is a composite traditional Chinese medicine (TCM) new drug to alleviate hyperlipidemia, while its therapeutic mechanism in vivo was not clarified with nontargeted metabolomics investigation. An animal model was established in rats fed a high-fat diet, and their body weights, body mass index (BMI) and blood cholesterol levels were measured. Serum, liver and kidney tissue samples were also extracted for PXR-CYP3A4-ABCB1-FXR signaling pathway research using PCR and UHPLC–MS. The obtained plasma samples were analyzed by UHPLC-Q-TOF-MS metabolomic investigation, which revealed PXR-CYP3A4-related metabolites and changes induced by YL. Finally, the key metabolites were chosen as index components, and their levels in the serum, liver, small intestine and bile were used for simultaneous UHPLC–MS-MS determination. The results indicated that YL was effective in rebalancing blood TG and TC levels (compared to controls). With respect to the PXR-CYP3A4-ABCB1 pathway, as a result of YL’s effect, gene expression or activity of the two targets decreased significantly in both the liver and kidney. The same trend was observed in the serum samples mentioned above. Metabolomics screening and data revealed that 44 metabolites can be regarded as biomarkers related to hyperlipidemia, fatty acids synthesis, and body energy consumption, as well as synthesis, transportation and exertion of cholesterol. YL’s treatment focused on 26 of them, primarily bile acids, indicating that the antihyperlipidemic effect of this drug lies in its inhibitory activity of cholesterol metabolism. Subsequent analysis of those in vivo components revealed that significant increases (compared to the model group) occurred in the blood, liver, small intestine and bile in groups that received medium and high doses of YL (while the low dose was relatively unchanged). Those target components exhibit a close relationship with PXR and/or CYP3A4. The use of YL repressed PXR expression and subsequently decreased CYP3A4 activity. As a result, synthesis of related bile acids increased, while cholesterol levels decreased, consequently leading to the attenuation of hyperlipidemia. This study comprehensively investigated the antihyperlipidemia mechanism of YL based on its repression of PXR-CYP3A4 activity and related metabolite yield, establishing an accurate method for evaluating the therapeutic effect of YL.     

拟多维高效液相色谱法分离纯化双峰驼精清中的活性蛋白

利用一种新的高效液相色谱洗脱技术，建立了 ｐＨ缓冲液／离子对二元洗脱模式，对双峰驼精清的两种提取物的反相柱上进行了分离，得到了较纯的活性蛋白组分。该法操作简单、快速、比常规ＨＰＬＣ有更高的选择性及峰容量，并可减少活性蛋白的失活。     

Synthesis of ultrafine SiC from rice hulls (husks): A plasma process

Heat-treated rice hulls have been used as precursor material for synthesis of ultrafne SiC in a RF plasma reactor. Rice hulls containing finely distributed silica and active carbon act as a source for SiC formation. The plasma-synthesized powder contained ultrafnc -SiC with excess carbon and some unreacted silica. Post-treatment processes such as oxidation and acid (HF) treatment appear to be effective in removing the excess carbon and silica.     

Diffusion current on a nonuniform electrode: Calculation with integral equations

Identity of mathematical problems concerning calculation of the distribution of reactants’ concentrations and the current near the surface of a nonuniform (strip) electrode and distribution of displacements and forces in the case of an elastic layer “antiplane” deformation caused by the punch action. Formulas for calculating the current at a strip electrode are derived for various ratios between the electrode width and the diffusion layer thickness by means of asymptotic methods designed for calculating problems of mechanical contact interactions. It is noted that calculations of the diffusion current for involved activity distributions at the electrode surface may benefit from asymptotic methods of mechanics of contact interactions.