邻苯二甲酸二烯丙酯和甲基丙烯酸甲酯共聚物梯度折射率棒制备过程的研究

<正> 梯度折射率棒是折射率沿径向或轴向连续变化的透明圆棒,具有光自聚焦性能。可用于制作自聚焦型光纤维和自焦聚透镜。用玻璃制得的梯度棒直径和折射率差都很小。近年来,开始研究高分子梯度棒,据估计其直径可望达到100mm,折射率差也可达0.1。本文采用二元掖体扩散共聚法,制得梯度棒,其径向折射率分布接近于抛物线型。     

Heat conduction, convection and radiolysis of the

Thermal oxidation of sulfur vulcanized polyisoprene samples was studied by gravimetry and IR mapping of carbonyl groups (to determine the oxidized layer thickness (TOL)) at temperatures ranging from 60 to 150 °C in air. Oxidation appears noticeably lower than that for the starting non-vulcanized polyisoprene, revealing a stabilizing effect of sulfur-containing species. After a short period where mass loss presumably due to water evaporation predominates, the sample mass increases until a plateau corresponding to 6.3% (at 60 °C) to 0.5% (at 140 °C) mass gain. Practically no weight gain (∼0.1%) was observed at 150 °C. The mass uptake is due to oxygen grafting to the chains. TOL varies from about 4.6 mm (70 °C) to about 1 mm (150 °C).A kinetic model, derived from a mechanistic scheme of radical chain oxidation including stabilizing events due to hydroperoxide reduction by sulfur-containing groups and taking into account the diffusion-reaction coupling, was established and numerically resolved. The model predictions for mass changes and TOL values are in good agreement with experimental data.     

Kinetic modelling of the thermal oxidation of polyisoprene elastomers. Part 2: Effect of sulfur vulcanization on mass changes and thickness distribution of oxidation products during thermal oxidation

Thermal oxidation of sulfur vulcanized polyisoprene samples was studied by gravimetry and IR mapping of carbonyl groups (to determine the oxidized layer thickness (TOL)) at temperatures ranging from 60 to 150 °C in air. Oxidation appears noticeably lower than that for the starting non-vulcanized polyisoprene, revealing a stabilizing effect of sulfur-containing species. After a short period where mass loss presumably due to water evaporation predominates, the sample mass increases until a plateau corresponding to 6.3% (at 60 °C) to 0.5% (at 140 °C) mass gain. Practically no weight gain (∼0.1%) was observed at 150 °C. The mass uptake is due to oxygen grafting to the chains. TOL varies from about 4.6 mm (70 °C) to about 1 mm (150 °C).A kinetic model, derived from a mechanistic scheme of radical chain oxidation including stabilizing events due to hydroperoxide reduction by sulfur-containing groups and taking into account the diffusion-reaction coupling, was established and numerically resolved. The model predictions for mass changes and TOL values are in good agreement with experimental data.     

Fractals in physics: Squig clusters,diffusions, fractal measures,and the unicity of fractal dimensionality

The three topics discussed in this paper are largely independent. Part 1: Fractal squig clusters are introduced, and it is shown that their properties can match to a remarkable extent those of percolation clusters at criticality. Physics on these new geometric shapes should prove tractable. As background, the author's theories of squig intervals and squig trees are reviewed, and restated in more versatile form. Part 2: The notion of latent fractal dimensionality is introduced and motivated by the desire to simplify the algebra of dimensionality. Scaling noises are touched upon. A common formalism is presented for three forms of anomalous diffusion: the ant in the fractal labyrinth, fractional Brownian motion, and Lévy stable motion. The fractal dimensionalities common to diverse shapes generated by diffusion are given, in Table I, as functions of the latent dimensionalities of the support of the motion and of the diffusion itself. Part 3: It is argued that every fractal point set has a unique fractal dimensionality, but it is pointed out that many fractals involve diverse combinations of many fractal point sets. Such is, in particular, the case for fractal measures and for fractal graphs, often called hierarchical lattices. The fractal measures that the author had introduced in the early 1970s are described, including new developments.     

Sorption/diffusion behaviour of anionic surfactants in polyacrylamide hydrogels: from experiment to modelling

The sorption and diffusion processes of anionic surfactants with different chain length through polyacrylamide hydrogels with low swelling degree have been studied by electrical conductivity measurements. The multicomponent equilibrium equation has been used to model the sorption isotherms of different anionic surfactant in the hydrogels. Such isotherms show that initial rapid sorption of unimer surfactant into the membranes occurs, suggesting that non-freezing water can be involved in these interactions. In aqueous solution, at concentrations near and above the critical micelle concentration an anti-co-operative region is found. The diffusion coefficients of the anionic surfactants inside the hydrogel matrix show that the mobility of diffusing surfactant entities is dependent on cross-linker concentration and chain length. The Cukier hydrodynamic model and the free volume theory as modified by Peppas and Reinhart were applied to explain the dependence of the diffusion coefficients of surfactant on surfactant concentration inside the hydrogel. The hydrodynamic model was applied with success to the more hydrophilic surfactant, sodium 1-octanesulfonate, showing that the diffusion coefficients, D, increase when the resistance to hydrodynamic medium decreases; when the surfactant chain length increases (sodium dodecyl sulfate and sodium 1-hexadecane sulphonate) the variation of D with the free volume can only be understood considering the sieving effect produced by the surfactant inside gel.     

ELASTIC BEHAVIOR OF PROTEIN-LIKE SINGLE CHAIN

The conformational properties and elastic behaviors of protein-like single chains in the process of tensile elongation were investigated by means of Monte Carlo method. The sequences of protein-like single chains contain two types of residues: hydrophobic (H) and hydrophilic (P). The average conformations and thermodynamics statistical properties of protein-like single chains with various elongation ratio λ were calculated. It was found that the mean-square end-to-end distance r increases with elongation ratio,λ. The tensor eigenvalues ratio of : decreases with elongation ratio λ for short (HP)x protein-like polymers, however, the ratio of : increases with elongation ratioλ,especially for long (H)x sequence. Average energy per bond increases with elongation ratioλ, especially for(H)x protein-like single chains. Helmholtz free energy per bond also increases with elongation ratioλ. Elastic force (f), energy contribution to force (fU) and entropy contribution to force (fs) for different protein-like single chains were also calculated.These investigations may provide some insights into elastic behaviors of proteins.     

Diffusion layer titration of dipyrone in pharmaceuticals at a dual-band electrochemical cell

This paper describes the use of a thin-layered dual-band electrochemical cell operating at flow conditions to determine dipyrone (sodium salt of 1-phenil-2,3-dimethyl-4-methylaminomethanesulfonate-5-pyrazolone) by reaction with electrogenerated iodine. The electrolytic cell consisted of two closely spaced gold electrodes, the upper stream electrode serving as the generator electrode and the downstream electrode working as the collector electrode. A linear dynamic range from 2 to 15 μmol l⁻¹ dipyrone was obtained by using a sample volume of 100 μl, with a detection limit of 1.1 μmol l⁻¹. Standard deviation (S.D.) of 3.4% for 20 repetitive injections of a 40 μmol l⁻¹ dipyrone solution and sampling frequency of 90 h⁻¹ were achieved. The results obtained with the thin-layered dual-band electrochemical cell for dipyrone determination in three different pharmaceutical samples compared well with those found by iodimetry with coulometrically generated iodine.     

Investigation of the Electrochemical Reduction of Benzophenone in Aprotic Solvents Using the Method of Cyclic Voltammetry

The reduction of benzophenone (Bzph) in 3-pentanone (PEN), acetone (ACE), N,N-dimethylacetamide (DMA), N,N-dimethylformamide (DMF), tetrahydrofuran (THF), acetonitrile (ACN) and dimethyl sulfoxide (DMSO) with n-tetrabutylammonium hexafluorophosphate (TBAPF₆) as background electrolyte was studied using the technique of cyclic voltammetry at the temperature of 263.15 K. The half-wave potentials (E _1/2) were extracted. The reduction of Bzph occurs in two successive one-electron steps to produce first the free radical anion Bzph⁻ and then the dianion Bzph²⁻. The results indicated that the radical anion Bzph⁻ is reoxidized to Bzph in all investigated solvent media whereas the dianion Bzph²⁻ is reoxidized to Bzph⁻ only in THF. The heterogeneous electron-transfer rate constants (k _s ) were evaluated by employing the electrochemical rate equation proposed by Nicholson. The rate of electron transfer for the Bzph/Bzph⁻ couple was found to be relatively slow in all investigated solvent media. Consequently, the electron-transfer processes can be recognized as quasi-reversible. The diffusion coefficients (D) of Bzph in the investigated solvent media have been calculated using the modified Randles-Sevcik equation. The effect of the physical and chemical properties of the solvent medium on the electrochemical behavior of Bzph has been examined.     

Molecular volume calculation using AM1 semi-empirical method toward diffusion coefficients and electrophoretic mobility estimates in aqueous solution

Diffusion coefficients and electrophoretic mobility are two important physicochemical parameters used in mass transport phenomenon studies. The volume of the solute is required to determine or estimate these parameters. Classical methods, such as the LeBas method are commonly used. However, although valid, this method may represent a boring and time-consuming task, depending on the nature and number of compounds to be calculated. In this study, the volumes of a series of neutral and charged substances of the main functional groups present in organic molecules, amino acids, drugs and diverse compounds, such as cytosine and glucose, were calculated according to the LeBas method (V_M) and the AM1 semi-empirical method, V_W(AM1). The latter showed to be statistically coincident with the former. Employed as a pure value or corrected by the LeBas molar volume, the AM1 molecular volume was also demonstrated to estimate the diffusion coefficients in infinite aqueous dilution within an acceptable average error, according to the Othmer–Thakar, Wilke–Chang and Hayduk–Laudie methods, as well as the electrophoretic mobility of charged substances, such as carboxylates and protonated amines. According to these results, the AM1 method was seen to be statistically valid to calculate molecular volume. Many advantages in the construction of most diverse structures were noted, as well as a reduction in time and an increase in the quality of the information, when run on molecular modeling software.     

Application of kinetic investigations for interpretation ofn-hexane and benzene adsorption on active carbon

Differencies between the mechanism ofn-hexane and benzene adsorption on active carbon were investigated on the ground of kinetic measurements. As it has been stated, the kinetic measurements show fundamental differencies between the mechanism of adsorption in spite of analogy existing in the state of adsorption equilibrium. Within the range investigated, only the adsorption ofn-hexane follows the model of volume filling of micropores. Existence of those differencies is also confirmed by measurements of effective diffusion coefficient values as well as changes of activation energy of the diffusion—adsorption process.

---

Anwendung kinetischer Untersuchungen zur Interpretation des Adsorptionsverhaltens vonn-Hexan und Benzol an Aktivkohle

Zusammenfassung Mittels kinetischer Messungen untersuchte man die Unterschiede im Mechanismus des Adsorptionsverlaufes vonn-Hexan und Benzol an Aktivkohle. Man stellte fest, daß trotz der Analogie im Adsorptionsgleichgewichtszustand die kinetischen Messungen auf prinzipielle Unterschiede im Adsorptionsmechanismus hinweisen. Im untersuchten Bereich verläuft nur die Adsorption vonn-Hexane nach dem Modell der Mikroporenvolumenausfüllung. Die auftretenden Unterschiede wurden auch durch die Berechnungen der Werte der effektiven Diffusionskoeffizienten sowie Änderungen der Aktivierungsenergie des Diffusions-Adsorptionsprozesses bestätigt.