Electronic structure of Sc2AC (A=Al, Ga, In, Tl)

Using ab initio calculations, we have studied Sc₂AC with A=Al, Ga, In and Tl. We show that C 2p and Sc 3d as well as A p and Sc 3d states are hybridized, but the antibonding states in the vicinity of the Fermi level weaken the overall bonding. In terms of the chemical bonding, the influence of the size of the A element is minute. Furthermore, the bulk modulus of the corresponding binary transition metal carbide is not conserved in these phases. Therefore, Sc₂AC can be classified as weakly coupled MAX phases according to Sun and co-workers [Z. Sun, D. Music, R. Ahuja, S. Li, J.M. Schneider, Phys. Rev. B 70 (2004) 092102]. It is our ambition that these calculations will stimulate experimental research on these compounds.     

Ultrasonic investigation of amorphous carbon in various frequencies at low temperatures from 2.1 to 300 K

Using pulse echo overlap measurement, the elastic behavior of amorphous carbon has been studied at ambient and low temperatures. The smaller ratio B/G of the bulk modulus to shear modulus and smaller Poisson's ratio σ at room temperature indicate that there is an intrinsic stiffening of transverse acoustic phonons in the amorphous carbon. The acoustic velocity and attenuation for longitudinal modes have been measured between 2.1 and 300 K at three frequencies of 7, 21 and 35 MHz, respectively. Their frequency and temperature dependence are observed. The elastic constant C₁₁ increases with decreasing temperature and show enhanced stiffening at low temperatures. In the 130-220 K region, the abnormal change and effect of longitudinal velocity and attenuation with temperature and frequency, and a phase transition associated with structure relaxations are discussed.     

劳动力供给带弹性的Solow模型

本文给出了在劳动力供给带弹性条件下的Ｓｏ１ｏｗ增长模型，给出了经济增长的黄金律和均衡处资本稳定性的证明，并且与不带弹性的Ｓｏｌｏｗ模型作了比较．     

芳香族热致液晶聚（对羟基苯甲酸－对苯二甲酸双酚A酯）的流变性能

用Ｉｎｓｔｒｏｎ３２１１型毛细管流变仪研究了以对羟基苯甲酸（ＰＨＢ）、对苯二甲酸（ＴＰＡ）和双酚Ａ（ＢＰＡ）为单体合成的共聚芳酯液晶熔体的流变性能。结果表明，切变速率、熔体温度及ＰＨＢ链节含量对切粘度和结构粘度有很大的影响。切变速率在１０～１０３／Ｓ、温度２９５～３３０℃范围内，共聚酯粘流活化能△Ｅη为７４．５～２０５．１（ｋＪ／ｍｏｌ）。液晶熔体在剪切流中存在屈服应力τｏ，随温度升高τｏ值降低。在低温、低切变速率下，共聚酯熔体的弹性很小，甚至呈现挤出收缩现象。     

Study of structural,electromagnetic and dielectric properties of cadmium substituted Ni–Zn nanosized ferrites

Sol-gel auto-combustion method was adopted to prepare Cd²⁺ ions substituted Ni–Zn nanosized ferrites having a chemical formula Ni_0.5Zn_0.5-xCd_xFe₂O₄ (0.0 $\le x\le 0.4)$. Their structural, electromagnetic, and dielectric properties were investigated by using XRD, FE-SEM, EDS, FTIR, VSM, and IS. The XRD analysis revealed a single-phase cubic structure of all samples. The addition of cadmium increased the lattice constant and cell volume of Ni–Zn ferrite due to the difference in the ionic radii between Cadmium (0.97 ?Å) and Zinc (0.74 ?Å). FESEM images showed irregularly shaped grain sizes in the range of 40 to 73 ?nm with random orientations and some agglomeration. The FTIR analysis also confirmed the presence of spinal ferrite phase functional groups in all samples. The saturation magnetization decreased (from 89.51 to 71.32 emu/g) with increasing cadmium content. However, the remanent magnetization and coercivity parameters increased with an increase in cadmium content. The dc resistivity as a function of the temperature of all samples was investigated, and the activation energies were found to be in the range of 0.48 to 0.51 ?eV. The dielectric loss decreased with increasing cadmium content. However, the dielectric constant and dielectric loss tangent (tan) varied non-monotonically with increased cadmium content.     

Influence of high pressure treatment on rheological and other properties of egg white

Abstract

The paper deals with the influence of high pressure treatment of fresh egg white on its properties and protein composition (individual amino-acids predicted as a function of pressure and time levels). The rheological properties are changed by high pressure from Newtonian to non-Newtonian behaviour, with increasing apparent viscosity as the pressure and time increased. The pH, whipping ability, foam stability, gel strength of heat induced gels after treatment and the whole protein content, were also predicted.

The results showed that the foam stability is increased with increasing pressure and time of processing. The foam volume is also increased with pressure. The pH did not change with pressure or time of processing. Composition of proteins as indicated by individual amino-acids did not exhibit statistically important changes. Gel strength of heat induced gels prepared from previously pressured liquid whites showed no important change of values with pressure or time of treatment. The modulus of elasticity showed a decrease for samples pressured to 400 MPa for 5 up to 15 minutes.     

Uniaxial deformation and orientation of ethylene–tetrafluoroethylene films

This study concerns the thermal and mechanical response of several commercial grades of ethylene – tetrafluoroethylene copolymer films. Differential scanning calorimetry was used to show that, although films have similar degrees of crystallinity and melting temperature, the melting endotherms and crystallisation exotherms differ between materials, suggesting small changes in composition between manufacturers. Films were deformed in tension at a range of temperatures and rates. Selected films were unloaded immediately after stretching, and measurement of the elastic recovery highlighted further differences between materials. Batches of films were pre-drawn uniaxially above the glass transition and immediately quenched. When these materials were subsequently re-drawn below the glass transition temperature, most of them exhibited much improved yield stress, modulus and tensile strength (improving by factors of 5, 5 and 4, respectively at a draw ratio of 3), but a reduced strain to failure. In most of the films, the pre-drawing, as well as the initial orientation of the films, is accounted for by a simple shift in the true strain axis. This is indicative of a material response dominated by entropic network stretch. It also suggests that, in the cases where strain superposition does not work, a different arrangement of crystalline lamellae may be present, limiting the extent to which improved properties can be achieved in some materials.     

Analysis of the geometrical dependence of auxetic behavior in reentrant structures by finite elements

Materials with a negative Poisson's ratio(PR)are called auxetics;they are characterized by expansion/contraction when tensioned/compressed.Given this counterintuitive behavior,they present very particular characteristics and mechanical behavior.Geometrical models have been developed to justify and artificiall reproduce such materials' auxetic behavior.The focus of this study is the exploration of a reentrant model by analyzing the variation in the PR of reentrant structures as a function of geometrical and base material parameters.It is shown that,even in the presence of protruding ribs,there may not be auxetic behavior,and this depends on the geometry of each reentrant structure.Values determined for these parameters can be helpful as approximate reference data in the design and fabrication of auxetic lattices using reentrant geometries.     

Dc conductance of ordered and disordered silicene superlattices

This paper studies the conductance of charge carriers through silicene-based superlattices consisting of monolayer silicene by means of transfer matrix method. At first, we consider the ordered superlattices and drive analytically the transmission probability of Dirac fermions. We show that the number of resonance picks increases with increasing the number of superlattice barriers. In order to the best understand of the appearance of the picks, we exactly studied transmission properties of the silicene superlattice. Also, the effect of disorder on the probability of transmission through the system of various sizes is studied. The short-range correlated disorder is applied on the thickness of electron doped silicene strips as quantum barriers which fluctuates around their mean values. We show that the oscillating conductance as a function of barriers hight suppresses with imposing the disorder in the silicene superlattice. Also, the effect of structural parameters on the conductance of the system is studied.     

DC conductivity of new single and mixed alkali oxyfluorovanadate glasses

New glasses have been prepared according to these formulas (70-x)V₂O₅-30BaF₂-xAF, where AF=LiF or NaF and (60-x)V₂O₅-30BaF₂-10LiF-xAF, where AF=NaF and x=10, 15, 20, 25 and 30 mol%. Density of the glasses was measured and molar volume calculated and they correlated with the AF content. The dc conductivity has been measured in the temperature range from 302 to 453 K. The dc conductivity increases with temperature and V₂O₅ content, while it decreases with the alkali fluoride content. Conductivity has been correlated with the calculated polaron distance, R, and glass transition temperature, T_g. The activation energy, W, increases with the increase in the alkali fluoride, while it decreases with the V₂O₅ content. Some parameters like polaron distance, R, polaron radius, r_p, ion concentrations, n(V), n(Li) or n(Na), hopping energy, W_H, density of localized states at Fermi level, N(E_F), polaron coupling constant, γ_p, polaron band width, J, hopping mobility, μ, and carrier density for electronic conduction, N_c, were calculated to explain the conduction mechanism and behavior of the present glasses.