Flume testing of passively adaptive composite tidal turbine blades under combined wave and current loading

The tidal energy industry is progressing rapidly, but there are still barriers to overcome to realise the commercial potential of this sector. Large magnitude and highly variable loads caused by waves acting on the turbine are of particular concern. Composite blades with in-built bend-twist elastic response may reduce these peak loads, by passively feathering with increasing thrust. This could decrease capital costs by lowering the design loads, and improve robustness through the mitigation of pitch mechanisms. In this study, the previous research is extended to examine the performance of bend-twist blades in combined wave–current flow, which will frequently be encountered in the field. A scaled 3 bladed turbine was tested in the flume at IFREMER with bend-twist composite blades and equivalent rigid blades, sequentially under current and co-directional wave–current cases. In agreement with previous research, when the turbine was operating in current alone at higher tip speed ratios the bend-twist blades reduced the mean thrust and power compared to the rigid blades. Under the specific wave–current condition tested the average loads were similar on both blade sets. Nevertheless, the bend-twist blades substantially reduced the magnitudes of the average thrust and torque fluctuations per wave cycle, by up to 10% and 14% respectively.     

Interface trap-induced negative differential resistance in nMOSFET with floating source

Interface trap can act as the generation center in device to induce a very weak generation current. We observed the negative differential resistance NDR of this generation current I_D in nMOSFET with the floating source. It originates from that the generation function of interface trap is enabled and then is shut down in turn as increasing the drain voltage. This change relies on the interaction among the interface trap energy-level and the electron's Fermi-levels of drain and source under the floating source condition. It is found that the peak-to-valley ratio of I_D is beyond 30.     

基于工作电流分析的回转副摩擦状态识别实验研究

回转副摩擦状态的变化对机械设备的运行有着重要影响. 针对回转副摩擦状态的识别问题, 设计了以回转副工作电流为摩擦特征来源的实验方案. 通过采集摩擦过程的回转副驱动电机工作电流信号, 分析实验信号的频域和时频域特征, 建立工作电流的摩擦特征库, 用于训练多分类支持向量机分类器, 并在分类器上完成摩擦状态的识别. 实验结果表明, 经特征提取与降维处理后建立的多分类支持向量机分类器具有近90%的识别正确率, 所提出的实验方案有利于实现远距离信号的采集, 适用实际生产加工.     

交错跃迁Hofstadter梯子的量子流相

为玻色Hofstadter梯子模型引入交错跃迁,来扩展模型支持的量子流相.基于精确对角化和密度矩阵重整化群计算发现,无相互作用时,系统中包含横流相、涡旋相和纵流相;横流相来自均匀跃迁时Hofstadter梯子模型的Meissner相,纵流相是交错跃迁时才可见的流相.强相互作用极限下系统的超流区也包含横流相、纵流相和涡旋相,但存在更多的相变级数;超流区的横流相、纵流相之间存在相变但Mott区的不存在,把Mott区的"横、纵流相"称为Mott-均匀相,在Mott区只存在均匀相和涡旋相.跃迁的交错会压缩涡旋相存在的区域,使Mott区最终只剩下均匀相;跃迁的交错不仅能驱动Mott-超流相变,还使磁通的改变也能够驱动系统的Mott-超流相变.对这一系统的研究丰富了磁通系统中的量子流相,同时为研究拓扑流特性提供了模型支持.     

多路Marx并联高压脉冲电源研究

脉冲功率技术在工业和生物医学领域有着广泛的应用,很多应用场合要求输出数百安培的高压脉冲。固态Marx发生器虽已研究多年,但是被广泛采用直插封装的IGBT和MOSFET功率半导体开关管的额定电流通常都低于100 A,无法满足低阻抗负载的应用需求。为提高输出脉冲电流幅值,提出两种多路Marx发生器并联的脉冲电源的拓扑结构,第一种方案采用多路Marx发生器直接并联,第二种是共用一组充电开关管的多路Marx发生器并联。由FPGA提供充放电控制信号,采用串芯磁环隔离驱动方案实现带负压偏置的同步驱动,主电路选用开通速度快、通流能力强的IGBT为主开关的半桥式固态方波Marx电路。实验结果表明,6路16级Marx直接并联的脉冲发生器能输出重频100 Hz高压方波脉冲幅值可达10 kV,在30Ω负载侧输出峰值电流可达300 A,上升时间230 ns。共用充电开关管的6路4级Marx并联发生器在5Ω电阻负载上的输出电流峰值可达300 A,最大输出电流可达460 A,上升时间272 ns。表明多路Marx发生器并联可以有效地减小系统内阻,提高系统带载能力;改进后的并联方案实现大电流脉冲输出的同时,所采用的开关管数量减小近一半,提高了系统的抗干扰能力的同时,降低了脉冲电源的成本;且增加级间并联导线可进一步改善均流效果。     

一种超导重力仪磁悬浮力的等效计算

为实现超导重力仪磁悬浮力的精确计算,以GWR型超导重力仪为模型基础,采用有限元的思想,将超导球表面电流理想化为多个等高共轴电流环,计算出各个电流环与超导线圈的作用力,求和得到线圈与超导球间的磁悬浮力。利用MATLAB完成计算程序实现,通过改变下线圈电流和上、下线圈电流比,获得满足一定条件的磁悬浮力及其梯度。选取合适的模型参数,计算出线圈对质量为m=4.069 g超导球的磁悬浮力大小为:Ftotal=3.988×10^-2N,磁悬浮力梯度为:-9.699×10^-3N/m,此时悬浮力梯度合适,满足系统稳定性和灵敏度的要求。     

暗怪波的相互作用

以耦合非线性薛定谔方程为理论模型,数值研究了两个一阶暗怪波在正常色散单模光纤中的相互作用.基于一阶暗怪波精确解,采用分步傅里叶数值模拟法,从间距、相位差和振幅系数比方面讨论相邻两个一阶暗怪波之间的相互作用.基于二阶暗怪波精确解,讨论了两个一阶暗怪波的非线性相互作用.研究结果表明:同相位情况下,间距参数T1为0、5、20时,相邻两个一阶暗怪波相互作用激发产生“扭结型”暗怪波.相比较于单个暗怪波发生能量的弥散,“扭结型”暗怪波分裂形成多个次暗怪波.反相位情况下,间距参数T1为2、7、12时,相邻两个一阶暗怪波相互作用也可以激发产生“扭结型”暗怪波.并且“扭结型”暗怪波初始激发的空间位置偏离原始单个暗怪波的位置5.振幅系数比越大,该空间位置越接近5.二阶暗怪波可以看作是两个一阶暗怪波的非线性叠加,复合型和三组分型二阶暗怪波与相邻两个一阶暗怪波的相互作用略有相似.     

A systematical study of the chiral magnetic effects at the RHIC and LHC energies

Considering the magnetic field response of the QGP medium,we perform a systematical study of the chiral magnetic effect(CME),and make a comparison with the experimental results for the background-subtracted correlator H at the energies of the RHIC Beam Energy Scan(BES)and the LHC energy.The CME signals from our computations show a centrality trend and beam energy dependence that are qualitatively consistent with the experimental measurements of the charge dependent correlations.The time evolution of the chiral electromagnetic current at the RHIC and LHC energies is systematically studied.The dependence of the time-integrated current signal on the beam energy√s with different centralities is investigated.Our phenomenological analysis shows that the time-integrated electromagnetic current is maximal near the collision energy√s≈39 GeV.The qualitative trend of the induced electromagnetic current is in agreement with the CME experimental results at the RHIC and LHC energies.     

质子交换膜燃料电池电流密度分布特性和研究展望

质子交换膜燃料电池具有无污染、噪声低、能量密度高、燃料转换效率高、响应速度快的显著优点,得到了迅速发展,但寿命仍然是制约其大规模商业化的重要原因。局部电流密度作为质子交换膜燃料电池运行过程中的重要参数,既能作为电池运行过程中的故障诊断和定位工具,提升电池运行的稳定性和和耐久性;又能提供电池运行期间其内部现象的有关信息,为深入理解电池反应机理以及优化电池设计提供有力指导,因此研究局部电流密度具有非常重要的意义。本文介绍并分析了实时原位测量局部电流密度的方法,比较了前人实验所得结果与模拟所得结果,阐述了相关参数对局部电流密度分布的影响机制,回顾并评析了局部电流密度用于燃料电池分析中的实际工作。最后,立足于局部电流密度的研究现状,给出了局部电流密度下一步的研究方向。     

Application of an efficient strategy based on liquid–liquid extraction,high‐speed counter‐current chromatography,and preparative HPLC for the rapid enrichment,separation, and purification of four anthraquinones from Rheum tanguticum

This study presents an efficient strategy based on liquid–liquid extraction, high‐speed counter‐current chromatography, and preparative HPLC for the rapid enrichment, separation, and purification of four anthraquinones from Rheum tanguticum. A new solvent system composed of petroleum ether/ethyl acetate/water (4:2:1, v/v/v) was developed for the liquid–liquid extraction of the crude extract from R. tanguticum. As a result, emodin, aloe‐emodin, physcion, and chrysophanol were greatly enriched in the organic layer. In addition, an efficient method was successfully established to separate and purify the above anthraquinones by high‐speed counter‐current chromatography and preparative HPLC. This study supplies a new alternative method for the rapid enrichment, separation, and purification of emodin, aloe‐emodin, physcione, and chrysophanol.