[Na(18-C-6)]2[Cu(i-mnt)2]的合成与结构分析

研究了18-冠-6与Na2[Cu(i-mnt)2][i-mnt=异丁二腈烯二硫醇阴离子,S2CC(CN)2-2]的反应,得到的配合物[Na(18-C-6)]2[Cu(i-mnt)2](1)通过元素分析、红外光谱、X射线单晶衍射进行了结构分析.配合物为单斜晶系,空间群P2(1)/c.晶体学结构数据a=1.2819(11),b=1.1793(10),c=1.4928(13)nm,β=99.121(16)°,V=2.228(3)nm3,Z=2,Dcaled.=1.369g/cm3,F(000)=958,R1=0.0521,wR2=0.1003.1中的[Cu(i-mnt)2]基团通过配体i-mnt的氮原子与两个[Na(18-C-6)]基团中的钠原子成键,形成稳定的中性配合物.     

萃取—火焰原子吸收法测定骨骼中的微量元素Cu,Zn,Cd和Fe

本文研究了以邻菲罗啉为金属螯合剂，高氯酸钠为配体，在一定酸度下用１，２－二氯乙烷萃取－火焰原子吸收法测定动物骨骼中微量Ｃｕ，Ｚｎ，Ｃｄ和Ｆｅ的条件，并确定了测定方法，方法简单，准确，可靠，元素的检测限分别为：Ｃｕ：０．０３８μｇ／ｍｌ，Ｚｎ：０．００４２μｇ／ｍｌ，Ｃｄ：０．００１９μｇ／ｍｌ，Ｆｅ：０．０２μｇ／ｍｌ，回收率在９２．８％～１０５％之间。     

ICP-AES同时测定混合矿物素中的磷、钙、铁、铜、锌、锰、镁、钴

采用ICP－AES法测定混合矿物素中的磷、钙、铁、铜、锌、锰、镁、钴元素含量，并对样品的溶解酸和酸用量、元素分析线的选择以及共存元素间的干扰进行了研究。该法简便、快速，精密度和准确度较好。     

水杨醛缩二乙基三胺铜配合物的合成与结构分析

合成了水杨醛缩二乙基三胺 (配体 L,2 - [(N- Salicylideneamino) ethyl]amine)与 Cu( )形成的配合物[Cu L(H2 O) ]Cl,通过元素分析、红外光谱、X射线单晶衍射进行了结构分析。配合物为单斜晶系 ,空间群P2 (1) / c,晶体学结构数据 ,a=0 .912 3(5 ) nm,b=1.382 1(7) nm,c=1.0 82 9(5 ) nm,β=10 1.712 (7)°,V=1.336 9(11) nm3 ,Z=4 ,Dcalcd=1.6 0 6 mg/ m3 ,F(0 0 0 ) =6 6 8,R1=0 .0 377,w R2 =0 .10 18。结构分析表明 ,配合物通过氢键形成二聚结构     

基体改进-石墨炉原子吸收光谱法测定海水样品中痕量的铜

用石墨炉原子吸收光谱法测定海水中痕量铜.对基体改进剂进行了筛选,采用HNO3-酒石酸体系,克服了海水基体的干扰,并对试剂进行了空白对照实验.在确定了升温程序的基础上,用标准加入法测定样品.使用国家标准溶液作为质控样,对方法的精密度和准确性做了验证.     

Application of the ISO 13472-1 in situ technique for measuring the acoustic absorption coefficient of grass and artificial turf surfaces

This paper presents the applicability of an in situ technique based on ISO 13472-1 standard for measuring the acoustic absorption coefficient of grass and artificial turf surfaces for normal incidence from a sound source. The in situ method is based on acoustic impulse response measurement of the material surface. A maximum length sequence (MLS) signal is played through a loudspeaker and the acoustic response from the surface is recorded using a single microphone. The fast Hadamard transform and fast Fourier transform based digital signal post-processing algorithm provides the acoustic absorption coefficient of the surface under test. The normal incidence acoustic absorption coefficient of a commercial artificial quash surface of Dow Co. obtained from this method was compared with the results from the ASTM E1050 impedance tube method for the same surface. The acoustic absorption coefficients of a test-site grass surfaces were measured for 30 mm and 100 mm length of grass blades in wet and dry soil conditions. Substantial difference in the acoustic absorption coefficient was observed for a similar grass-like artificial surface used for estimating sound power of commercial garden equipments and lawnmowers. The advantage of the in situ method lies in its ability to measure the normal incident acoustic absorption coefficient of any planar surface as installed or in situ. Additionally a quick testing time of less than a minute with the use of a laptop sound card based inexpensive data acquisition system is the main feature of this robust method.     

Co与Cu掺杂ZnO薄膜的制备与光致发光研究

采用溶胶-凝胶旋涂法在玻璃衬底上制备了Co, Cu单掺杂及Co,Cu共掺杂ZnO薄膜.用金相显微镜观察了Co与Cu掺杂对ZnO薄膜形貌的影响.X射线衍射（XRD）研究揭示所有ZnO薄膜样品都存在（002）择优取向,在Cu单掺的ZnO薄膜中晶粒尺寸最大.对所有样品的室温光致发光测量都观察到较强的蓝光双峰发射和较弱的绿光发射,其中长波长的蓝光峰和绿光峰都能够通过掺杂进行控制.对不同掺杂源的ZnO薄膜发光性能进行了分析,认为蓝光峰来源于电子由导带底到锌空位能级的跃迁及锌填隙到价带顶的跃迁,绿光峰是由于掺杂造成的 关键词： ZnO薄膜 溶胶-凝胶 Co Cu掺杂 光致发光     

转移基板材质对Si衬底GaN基LED芯片性能的影响

在Si衬底上生长了GaN基LED外延材料,分别转移到新的硅基板和铜基板上,制备了垂直结构蓝光LED芯片。研究了这两种基板GaN基LED芯片的光电性能。在切割成单个芯片之前,对大量尺寸为(300μm×300μm)的这两种芯片分别通高达1 A的大电流在测试台上加速老化1 h。结果显示,铜基板Si衬底GaN基LED芯片有更大的饱和电流,光输出效率更高,工作电压随驱动电流的变化不大,光输出在老化过程中衰减更小。铜基板芯片比硅基板芯片可靠性更高,在大功率半导体照明器件中前景诱人。     

Engineering and characterization of mesoporous silica-coated magnetic particles for mercury removal from industrial effluents

Mesoporous silica coatings were synthesized on dense liquid silica-coated magnetite particles using cetyl-trimethyl-ammonium chloride (CTAC) as molecular templates, followed by sol-gel process. A specific surface area of the synthesized particles as high as 150 m²/g was obtained. After functionalization with mercapto-propyl-trimethoxy-silane (MPTS) through silanation reaction, the particles exhibited high affinity of mercury in aqueous solutions. Atomic force microscopy (AFM), zeta potential measurement, thermal gravimetric analysis (TGA), analytical transmission electron microscopy (TEM), X-ray photoelectron spectroscopy (XPS) and atomic absorption spectroscopy (AAS) were used to characterize the synthesis processes, surface functionalization, and mercury adsorption on the synthesized magnetite particles. The loading capacity of the particles for mercury was determined to be as high as 14 mg/g at pH 2. A unique feature of strong magnetism of the synthesized nanocomposite particles makes the subsequent separation of the magnetic sorbents from complex multiphase suspensions convenient and effective.     

铜原子纳米团簇热力学性质的分子动力学模拟研究

利用分子动力学模拟方法,研究了CuN(N=80,140,216,312,408,500,628和736)纳米团簇在热化和冷凝过程中结构和热力学性质的变化,模型采用的是Johnson的EAM作用势.模拟结果表明:铜团簇的熔点和凝固点随其尺寸线性增加,并逐渐向大块晶体靠拢;所有团簇的凝固点都低于熔点,出现凝固过程中的滞后现象;在熔点和凝固点附近,团簇都具有负热容特性,负热容是由相变前后团簇内部结构突变引起的.