重金属Pb2+对玉米苗生长的影响

以水栽培的玉米幼苗为材料，用不同浓度的醋酸铅溶液处理后，分别在第10天、第20天、第30天对玉米苗的根、茎、叶分别进行Pb^2＋含量测定。分析结果：Pb^2＋在玉米体内的分布表现为根〉叶〉茎；玉米中的叶绿素含量均降低；随着Pb^2＋浓度的增大，玉米细胞的膜透性表现根〉叶〉茎依次升高；Pb^2＋对玉米的伤害率的大小表现为根〉叶〉茎。该实验为进一步研究农作物对重金属Pb^2＋的耐性和重金属Pb^2＋在农作物体内的分布提供了可参考的数据。     

Synthesis and characterization of corn starch based green composites reinforced with Saccharum spontaneum L graft copolymers prepared under micro-wave and their effect on thermal, physio-chemical and mechanical properties

In this paper, green composites of the corn starch were developed by using resorcinol-formaldehyde (Rf) as the cross-linking agent and reinforced with graft copolymers Saccharaum spontaneum L(Ss) and methyl methacrylates (MMA) as principal monomer and its binary mixture with acrylamide (AAm), acrylonitrile(AN), acrylic acid (AA) prepared under micro-wave. The matrix and composites were found to be thermally more stable than the natural corn starch backbone. There was improvement in physico-chemical and mechanical properties of composite were found to exhibit better than matrix. Ss-g-poly(MMA)-MW reinforced composites were found to exhibit better tensile strength, on the other hand Ss-g-poly(MMA + AA)-MW reinforced composites showed maximum compressive strength and wear resistance than other graft copolymers reinforced composite and the basic matrix. Further the matrix and composites were subjected for biodegradation studies through soil composting method. Different stages of biodegradation were evaluated through FT-IR studies and scanning electron microscopic (SEM) techniques.     

Rapid biomass analysis

New, rapid, and inexpensive methods that monitor the chemical composition of corn stover and corn stover-derived samples are a key element to enabling the commercialization of processes that convert stover to fuels and chemicals. These new techniques combine near infrared (NIR) spectroscopy and projection to latent structures (PLS) multivariate analysis to allow the compositional analysis of hundreds of samples in 1 d at a cost of about $10 each. The new NIR/PLS rapid analysis methods can also be used to support a variety of research projects that would have been too costly to pursue by traditional methods.     

Measurement of rheological properties of corn stover suspensions

Corn stover is currently being evaluated as a feedstock for ethanol production. The corn stover suspensions fed to reactors typically range between 10 and 40% solids. To simulate and design bioreactors for processing highly loaded corn stover suspensions, the rheologic properties of the suspension must be measured. In systems with suspended solids, rheologic measurements are difficult to perform owing to settling in the measurement devices. In this study, viscosities of corn stover suspensions were measured using a helical ribbon impeller viscometer. A calibration procedure is required for the impeller method in order to obtain the shear rate constant, k, which is dependent on the geometry of the measurement system. The corn stover suspensions are described using a power law flow model.     

Computer controlled-flow injection potentiometric system based on virtual instrumentation for the monitoring of metal-biosorption processes

A completely automated flow-injection system was developed for the monitoring of biosorption studies of Cu(II) ion on vegetable waste by-products. The system employed flow-through Cu(II)-selective electrodes, of epoxy-resin-CuS/Ag₂S heterogeneous crystalline type, and computer controlled pumps and valves for the flow operation. Computer automation was done through a specially devised virtual instrument, which commanded and periodically calibrated the system, allowing for the monitoring of Cu(II) ions between 0.6 and 6530 mg L⁻¹ at a typical frequency of 15 h⁻¹. Grape stalk wastes were used as biosorbent to remove Cu(II) ions in a fixed-bed column with a sorption capacity of 5.46 mg g⁻¹, obtained by the developed flow system, while the reference determination performed by FAAS technique supplied a comparable value of 5.41 mg g⁻¹.     

基于高光谱技术的玉米种子可视化鉴别研究

种子纯度是衡量种子品质的重要指标。提出一种基于近红外(874～1 734 nm)高光谱技术实现玉米种子可视化鉴别的方法。采集4个品种共384个玉米种子样本的高光谱图像数据,随机选择288个样本作为建模集,剩余96个样本作为预测集。对玉米种子光谱曲线进行分析后,通过连续投影算法（SPA）选取7个特征波段作为输入,结合偏最小二乘法判别分析(PLS-DA)模型,对预测集进行预测,获得较好的分类效果,其中R_C=0.917 7,RMSECV=0.444 2; R_CV=0.911 5,RMSECV=0.459 9,建模集和预测集的总体鉴别率分别为78.5%和70.8%。通过图像处理技术提取高光谱图像中每个玉米颗粒的平均光谱数据,输入建立的SPA-PLS-DA模型,在计算生成的鉴别图中以不同颜色标识不同类别,实现了混杂玉米种子样本的可视化鉴别。对3份不同组成的混杂种子样本进行鉴别,达到了较好的可视化效果。结果表明,通过可视化鉴别技术,可以直观方便地观察混杂种子样本中不同品种种子的分布和数量,为农业生产中种子的纯度鉴别和筛选提供了帮助。     

高效液相色谱串联质谱法测定玉米及植株中胺唑草酮及其代谢物

建立了同时测定玉米及玉米植株中胺唑草酮及其两个代谢物残留量的液相色谱串联质谱分析方法.样品采用乙腈提取,石墨化炭黑(GCB)和C18分散固相萃取净化,以甲醇-5 mmol/L乙酸铵溶液为流动相,液相色谱串联质谱分析测定.在1 ～ 1000 μg/L的浓度范围内,3种目标化合物的响应值与浓度呈良好的线性关系,在3个添加水平下,玉米籽粒及植株中胺唑草酮及其代谢物的平均添加回收率为85％～111％,相对标准偏差(RSD)为2.3％～11.0％.方法定量限(LOQ)为5μg/kg.采用本方法监测15例市售玉米样品,样品中目标物均低于方法检出限.本方法简单,快速,灵敏度高,可完全满足国外胺唑草酮相关现行法规的限量要求.     

玉米叶片重金属铅含量的SVD-ANFIS高光谱预测模型

重金属污染农作物后可通过食物链进入人体从而严重危害身体健康.如何快速准确地监测农作物中重金属含量已成为当今生态与粮食安全等领域的重要研究内容.常规的生化监测方法存在操作繁琐、过程长、具有破坏性等缺点,而高光谱遥感具有光谱分辨率高、信息量大、生化反演能力强、方便快捷、对监测对象无损伤等优势,因此利用高光谱遥感技术监测农作...     

重金属铅离子胁迫下玉米叶片光谱弱差信息的DSAT甄别模型

光谱间微弱信息测度是当今高光谱遥感研究难点之一,传统光谱测度方法难以区分光谱信息的微弱差异。研究设计了不同浓度的铅(Pb)污染实验,并测量了不同浓度铅离子(Pb2+)胁迫下玉米叶片的高光谱反射率、叶绿素含量及Pb2+含量,但是从所测结果得出,不同浓度Pb2+胁迫下的光谱相似性相关系数均达到0.999,难以区分不同浓度Pb2+胁迫引发的光谱间微弱信息差异和污染程度。针对这一情况,基于光谱微分处理、正切函数增强、光谱角量度与波谱分段检测等,提出了一种新型的相似光谱测度方法,即微分光谱角正切(derivative spectral angle tangent,DSAT)法。为了验证DSAT在区分相关系数达0.99以上相似光谱的可行性和有效性,将DSAT用于不同浓度Pb2+胁迫玉米叶片的整体波形与光谱区间子波形的信息差异性度量与检测。实验结果得到,波形差异信息与玉米叶片中叶绿素相对浓度与Pb2+含量显著相关。进而也证明DSAT法在甄别较高相似性光谱间差异上具有更好的实用性和优越性。     

Reaction kinetics of stover liquefaction in recycled stover polyol

The purpose of this research was to study the kinetics of liquefaction of crop residues. The liquefaction of corn stover in the presence of ethylene glycol and ethylene carbonate using sulfuric acid as a catalyst was studied. It was found that the liquefaction yield was a function of ratio of solvent to corn stover, temperature, residence time, and amount of catalyst. Liquefaction of corn stover was conducted over a range of conditions encompassing residence times of 0–2.5 h, temperatures of 150–170°C, sulfuric acid concentrations of 2–4% (w/w), and liquefaction reagent/corn stover ratio of 1–3. The liquefaction rate constants for individual sets of conditions were examined using a first-order reaction model. Rate constant increased with the increasing of liquefaction temperature, catalyst content, and liquefaction reagent/corn stover ratio. Reuse of liquefied biomass as liquefying agent was also evaluated. When using recycled liquefied biomass instead of fresh liquefaction reagent, the conversion is reduced. It appeared that 82% of liquefaction yield was achieved after two times of reuse.