铜（Ⅱ）的嘧啶类三元混配配合物的合成及表征

本文合成了二价铜与多取代嘧啶类（Ｌ１或Ｌ２）的配合物,并用元素分析、红外、紫外光谱、摩尔电导和差热－热重分析等方法对它们的性质、结构进行了表征。配合物的化学式为［Ｃｕ（Ｌ１）Ｃｌ２］·１２Ｈ２Ｏ和［Ｃｕ（Ｌ２）Ｃｌ２］。     

Synthesis,structure and characterization of the trinuclear copper (I) complex [Cu3(μ3-Br)2(dppm)3]Br

The novel trinuclear copper(I) complex [Cu₃(μ₃,-Br)₂(dppm)₃]Br has been obtained by reaction of bis(diphenyl-phosphino)methane (dppm) with cupric bromide. The title complex was characterized by single-crystal X-ray analysis, elemental analysis, molecular weight determination, ³¹P NMR and its conductivity was also measured. The [ Cu₃ (dppm)₃ Br₂ ]⁺ cation consists of a triangular array of copper atoms, with dppm ligands (Ph₂ PCH₂ PPh₂) bridging each edge of the triangle and two triply bridging Br groups bound to the two faces of the Cu₃ unit. Crystallographic data: monoclinic, space group P2₁/c, a = 1.4739(4), b = l.7708(5), c = 2.8395(8) nm, β= 97.16(3)°, V = 7.353nm³, Z = 4, F(000)= 3296, D_calc, = 1.472 g/cm³, μ = 26.478 cm^?1, R=0.06, R_W = 0.08, 4654 reflections observed with I3≥(I).     

火焰原子吸收法快速分析硫酸中铅镉铜锌

文中直接取硫酸样品3ml于装有约10ml水的25ml比色管中,加入碘化钾溶液2ml,用水稀至刻度。加入甲基异丁酮5ml,萃取lmin,分层后,在有机相中测定铅、镉、铜含量;在水相中测定锌含量。方法的加标回收率为98.9％～103％,精密度1.8％～4.3％,标准曲线法和标准加入法结果相近,倍比试验结果亦相吻合,方法快速简便、准确,适合于工业中的快速分析。     

铜（Ⅱ）锌（Ⅱ）－氟哌酸体系电化学行为及示波极谱法研究

铜（Ⅱ）和锌（Ⅱ）分别在０．１ｍｏｌ／ＬＫＨ＿２ＰＯ＿４－Ｎａ＿２ＨＰＯ＿４缓冲溶液（ｐＨ６．５）和０．２５ｍｏｌ／ＬＮＨ＿４Ｃｌ溶液中，与氟哌酸形成良好的络合吸附波，峰电位分别为－０．２６Ｖ和－１．２８Ｖ（ｖｓ；ＳＣＥ）；络合比分别为１：３和１：２；峰电流与铜（Ⅱ）和锌（Ⅱ）的浓度均在４．０×１０￣（－７）～５．０×１０￣（－６）ｍｏｌ／Ｌ范围内呈线性关系，检测限分别为７．０×１０￣（－８）和５．０×１０￣（－８）ｍｏｌ／Ｌ。用线性扫描和循环伏安法等手段研究体系的行为，表明均具吸附性，而铜（Ⅱ）－氟哌酸体系属络合物中铜（Ⅱ）的两电子还原的可逆过程。     

116例冠心病患者血清中铜铬锰钴镍钒含量的探讨

测定了１１６例冠心病患者血清中铜、铬、锰、钴、镍、钒的含量并与正常值比较，显示含量升高才是有铬和镍，降低者有钴和钒、无差异者有铜和锰。     

Temporal evolution of Raman intensities on surface-enhanced Raman scattering active copper and gold electrodes at negative potentials

The effect of a roughening procedure on surface-enhanced Raman scattering (SERS) intensity of pyridine at copper and gold electrodes subjected to negative potential has been investigated. Among four procedures tested for a copper electrode the one consisting of electrochemical activation in a solution of LiCl and CuCl₂ resulted in the most stable and effective surface. It was proved that the presence of pyridine during the pretreatment procedure caused a very fast, irreversible decay of SERS intensity for both copper and gold electrodes. Quite stable, at least at room temperatures, gold surfaces were obtained by oxidation-reduction cycles activation in KCl solution.     

A Facile Generation of a Cyclopropylzinc Compound from an Alkenylzinc Derivative and Its Reaction with Electrophiles

The one-pot synthesis of cyclopropyl compounds from 1-alkynes has been achieved by direct cyclopropanation of a 1-alkenylzinc species upon treatment with iodomethylzinc and trapping of the cyclopropylzinc intermediate with allyl bromide in the presence of CuCN⋅2 LiCl (see reaction scheme). This method proceeds under mild conditions and in good yield.     

The Effects of M2O3 on Stabilizing Monocopper over the Surface of Cu-ZnO-M2O3 Catalysts for Mathanol Synthesis

The effects of M₃O₃ (M = Al, Sc etc.) in Cu-ZnO-M₂O₃ catalysts on methanol synthesis at low pressure were studied with ESR, XPS and TPR spectroscopy. The results of ESR showed that the generation of monovalent cationic defects was because the valence state and electronic charge on the ZnO lattice lost their balance as M³⁺ doped into ZnO. The induced effect by Sc³⁺ is stronger than that by Al³⁺. The results of XPS and TPR indicated that the amount and stabilization of Cu⁺ on the surface of reduced copper-based catalyst and its catalytic activity were affected by the monovalent cationic defects on the surface of ZnO.     

流动注射在线共沉淀预富集火焰原子吸收法测定痕量铜

研究了以Ｎｉ＾２＋－ＤＤＴＣ为共沉淀载体，流动注射在线共沉淀预富集－火焰原子吸收光谱法测定痕量铜的体系，在０．３ｍｏｌ．Ｌ＾－１的硝酸介质中，铜离子在编织反应器中与Ｎｉ＾２＋－ＤＤＴＣ（产生共沉淀，并被收集在编织器内壁上，用甲基异丁基酮（ＭＩＢＫ）在线洗脱沉积物并引入火争原子化器中测定。当富集时间为４０ｓ时，４０μｇ．Ｌ＾－１的铜１０次测定的相对标准偏差为３．０％，灵敏度提高６０倍，检出限（３σ）     

On-line pretreatment and determination of Pb, Cu and Cd at the μg l level in drinking water by chelation ion chromatography

A novel, highly sensitive method for the simultaneous separation and determination of lead, copper, cadmium and other transition metals in drinking water was achieved by on-line sample pretreatment of chelation ion chromatography. Manganese, which coeluted with cadmium, was oxidized to permanganate by ammonium persulfate before injection. Permanganate, with bulk quantity of alkali, alkaline earth metals, iron and aluminum, was eliminated by pyrophosphoric acid–ammonium acetate buffer solution (pH 5.5), while retaining heavy and transition metals on a selective chelating resin (MetPac CC-1 column). Then, they were disabsorbed and transferred to a sulfonated cation exchanger (TMC-1 column). Finally, the concentrated trace metals were separated on a bifunctional ion-exchange column (CS5A) by a concentration gradient of oxalic acid and sodium nitrate eluents, coupled with post-column spectrophotometric detection with 2-[(5-bromo-2-pyridyl)azo]-5-diethylaminophenol (5-Br-PADAP) at 560 nm. The separation and color-development conditions were optimized. The detection limits for the method (signal-to-noise ratio=3:1) were at or below the μg l⁻¹ level. The results of drinking water analyses were satisfactory.