一种脉冲高电压测量探头的地电位隔离方法

为了消除脉冲功率装置放电时地电位抬升对测试系统造成的影响,在测量探头和测量设备之间使用了共模电感。对等效电路进行了仿真分析,结果表明：对于探头输出的信号,该共模电感等效为传输线;对于共模信号等效为一个较大的电感,可以实现探头地电位隔离。共模电感使用绕制在磁芯上的同轴电缆制作,并进行了快脉冲信号传输和地电位隔离效果实验。实验结果与理论分析一致。该共模电感的响应时间为5.4 ns,隔离了约10 kV的脉冲高压,确保了示波器的安全运行。     

相对论速调管放大器杂模振荡的抑制

研究了相对论速调管放大器（RKA）输入腔和中间腔之间的高阶杂模振荡问题。通过模式分析得知杂模在谐振腔内为TM11模式,而在漂移管中表现为TE11模式,针对该模式能在漂移管中传输的特性,利用漂移管内壁涂覆吸波材料吸收杂模功率的方法进行抑制。通过3维粒子模拟程序,分析了吸波材料的电导率及涂覆长度对抑制杂模增长率的影响。利用模拟分析得到的结果,对漂移管中涂覆吸波材料的RKA输入腔及中间腔结构进行了3维模拟研究,结果显示:合适的吸波材料的引入能够很好地抑制RKA输入腔和中间腔之间的杂模振荡。     

低过模高功率微波方圆模式转换器设计

设计了一种结构简单的高功率微波方圆模式转换器,可以实现圆波导TM01模式与矩形波导TE10模式之间的相互转换。转换器工作在C波段,中心频率4.1 GHz,其输入端口和输出端口相互垂直。计算和仿真结果表明:中心频率处该模式转换器的转换效率可达99%,回波损耗小于-20 dB,转换效率大于90%的带宽大于0.2 GHz。转换器整体3维尺寸都只有10 cm左右。     

圆锥形喷管的脉冲激光推进能量相似律数值模拟

为了验证理论分析得到的圆锥形喷管在单脉冲条件下的激光推进能量相似律,用2维轴对称辐射流体动力学方法,计算得到了不同构形的推进性能参数,分析了锥角、长度、无量纲因子、入射激光能量对冲量、冲量耦合系数的影响。计算揭示的激光推进能量相似律合理,在理论模型可以描述的范围内,其定性规律与理论分析、实验结果之间相互印证。结果表明：当锥角固定时,冲量和冲量耦合系数随无量纲因子先增大后减小,极大值对应的无量纲因子仅与气体比热比相关;当无量纲因子固定时,冲量随入射激光能量增加而增大,冲量耦合系数受激光能量的影响很小,冲量和冲量耦合系数均随锥角增大而单调减小。     

非化学专业无机及分析化学“讲练考”教学模式改革

This article discussed "teaching-practice-test" teaching mode with teaching practical experience and content matching.Results showed that this mode highlighted the proportion of practice and problem-solving in the process of learning; improved students' ability to solve problems using professional and disciplinary knowledge; changed learning styles from cramming way to autonomous learning step by step and trained students' creativity.     

Design and characterization of guided mode resonance filters with the improved structure for facile fabrication

In this study, a guided mode resonance filter with the improved structure for facile fabrication is designed; the properties of the designed filters are simulated by rigorous coupled wave analysis. It is found that the resonance wavelength and spectral linewidth are slightly increased with the increasing of the grating thickness, and seldom changed with the thickness of the grating filling factor, as the parameter error of the grating thickness and the grating filling factor are deviated from the designed value by ±10%, respectively, which are very favorable for simplifying preparation process of the GMR filter.     

An Investigation into the Migration of Segments in Crosslinked Fluorinated Polyimide Adhesive

Crosslinked fluorinated polyimides (CFPI) were successfully synthesized to study and explore the effect of cross-linkage on the migration of fluorinated segments and on the adhesion strength. Characterization by dynamic thermomechanical analysis (DMA) and thermo gravimetric analysis (TGA) confirmed good thermal properties of CFPI. X-ray photoelectron spectroscopy (XPS) results showed that the ratio of fluorinated component (6FDA-ODA) concentration of the surface to the bulk decreased with the crosslink density. The water contact angle of CFPI was lower than that of non-crosslinked fluorinated polyimide, indicating that the migration of fluorinated groups to the surface was reduced by the presence of cross-linkage. Therefore, CFPI, with no fluorine segregation on the surface, exhibited excellent wetting of adherent surfaces and adhesion strength, which was proved by lap shear strength (LSS) measurements and scanning electron microscopy.     

Syntheses and structures of M–Na (M=Zn,Mn) coordination polymers in which ligands and Na ions exhibit complex coordination modes

The novel heteronuclear complexes [Na₂Zn(dipic)₂(H₂O)] _n (1) and [Na₂Mn(dipic)₂(H₂O)₂] _n (2) (H₂dipic?=?pyridine-2,6-dicarboxylic acid) were synthesized and characterized by single-crystal X-ray diffraction, analysis, IR spectroscopy and thermogravimetric analysis. Complex 1 consists of infinite 2D double layers, which are further attached into a 3D network through π–π stacking. All sodium ions are 3-coordinate. Complex 2 has an intricate 3D structure, in which two sodium ions are differently involved in forming polymeric coordination units, and are 3- and 7-coordinate, respectively. Dipic anions act as multidentate ligands showing novel and unprecedented bridging coordination modes. One ligand coordinates to three metal ions and with five bonds; the other coordinates five metal ions with nine bonds.     

Reflective mode of deformed-helix ferroelectric liquid crystal cells for sensing applications

We present a detailed theoretical and experimental study of the reflectance response of a deformed-helix ferroelectric (DHF) liquid crystal (LC) cell to an applied voltage under cross-polarisers. Using a model based on the effective dielectric tensor approximation, we derive simple analytical formulas to design a LC cell with maximum modulation depth and optimal linearity of the electro-optical response intensity versus the electric field. Our experimental results show that the cell works at frequencies up to 10 kHz and exhibits excellent linearity, with a total harmonic distortion as low as ?70 dB. These findings suggest that DHF-LCs can be exploited to develop simple and accurate optical sensors.