基于DS/AHP的供应商选择方法

供应商选择方法有很多种，在众多的方法中层次分析法以能够将定性指标定量化而被广泛应用于供应商选择决策中。考虑到供应商选择问题中包含有很多的不确定性而证据理论在处理不确定问题又有着独特的优点，因此本文采用了一种由层次分析法和证据理论结合而产生的DS／AHP决策方法，并将其应用于供应商选择决策问题中，该方法综合了层次分析法和证据理论的优点，可以更科学的进行供应商选择决策，最后通过一个例子说明这种方法在供应商选择中的应用。     

稀疏过程在破产问题中的应用

本讨论一类人寿保险的风险过程，其中保单到达服从齐次Poisson过程。而描述退保及索赔发生的计数过程分别为这一过程的q-稀疏与p-稀疏．对此模型给出其破产概率的具体上界，并与其它一类风险模型进行比较．     

Synthesis of molecular imprinted organic-inorganic hybrid polymer binding caffeine

Random copolymers of poly{(methacrylamide)-co-(vinyl trimethoxysilane)} and poly{(methacrylic acid)-co-(vinyl trimethoxysilane)} were synthesized via a free radical polymerization reaction. Acid catalyzed sol-gel process of tetraethylorthosilicate (TEOS) with aforementioned polymers in the presence of methyl xanthine class of alkaloid like caffeine resulted in the formation of highly transparent monoliths. Solvent extraction of the template leaves behind the recognition sites intact with high selectivity towards the print molecule. The ionic and non-specific adsorptions, which are considered to be the main disadvantages of the molecularly imprinted polymers (MIP), are prevented to a considerable extent by the end capping of surface silanol groups. The template binding efficiencies of MIP were determined by HPLC analysis.     

Composite Silica Particles Using a Mixture of Organosilane Monomers

Composite silica particles were synthesized by a two-step (acid-base) process in an aqueous solution with a mixture of organoalkoxysilane monomers. The two-step process separates the hydrolysis and condensation procedures to easily control condensation rate. In this study, the silane monomers used were phenyltrimethoxysilane (PTMS), vinyltrimethoxysilane (VTMS), methyltrimethoxysilane (MTMS), and tetraethyl-orthosilicate (TEOS). The physical properties of the resultant composite particles were investigated with the change in the molar ratio of monomers. The size of the particles increased with increasing the molar ratio of R_aSi(OR)₃/R_bSi(OR)₃ or R_aSi(OR)₃/TEOS (R_a: phenyl; R_b: vinyl, methyl).     

NMR investigation of concentrated alumina and silica slurries

The longitudinal relaxation times (T₁) of water in concentrated silica and alumina slurries were measured as a function of solids content. It was shown that the results could be fit very well with a two-phase fast-exchange model between free and surface-bound water. As expected, values of T₁ for bound water were in the order of 20–2000 times lower than that for free water, indicating a higher effective viscosity of the surface-bound water. The strength of the interaction depended on the particular surface, and all of the aluminas examined interacted more strongly with water than the two silicas studied, which themselves differed considerably. The chemical mechanical polishing (CMP) removal rate of tantalum by silica slurries was shown to be directly correlated with the interaction parameters, derived from the NMR relation times rather than with total surface hydroxyl group concentration.     

溶胶-凝胶法制备小颗粒(Y,Gd)BO_3∶Eu及其表征

用溶胶 凝胶方法制备了平均粒径为 1～ 2 μm的小颗粒、高发射效率的 (Y ,Gd)BO3 ∶Eu红色发射荧光体。用XRD、SEM、粒度分析和PL光谱对荧光体作了表征和研究。常规固相反应合成 (Y ,Gd)BO3 ∶Eu需在 1 2 0 0℃以上才能形成均一的固溶体。而溶胶 凝胶法制取稀土正硼酸盐 80 0℃灼烧已可形成均一的单相 (Y ,Gd)BO3 ∶Eu,在 1 1 0 0℃可得到发光亮度最高的荧光体。它的亮度是常规固相反应于 1 2 0 0℃制得的荧光体的 1 2 0 %。采用溶胶 凝胶法制取 (Y ,Gd)BO3 ∶Eu荧光体 ,可在相当宽的实验条件范围内得到小粒径、窄分布和高亮度的荧光体 ,且有良好的颗粒形貌。     

Cl/HN3/I2全气相化学激光体系的化学动力学模拟计算

 对Cl/HN₃/I₂产生NCl(a)/I激光的过程进行了化学动力学计算，主要考察了Cl,HN₃和I₂的初始粒子数密度及其配比对小信号增益系数的影响。结果发现,当温度为400K, 初始Cl粒子数密度为1×10¹⁵，1×10¹⁶和1×10¹⁷cm^-3时,小信号增益系数分别达到1.6×10^-4,1.1×10^-3和1.1×10^-2cm^-1，获得最佳小信号增益系数的HN₃和I₂的初始粒子数密度分别为初始Cl粒子数密度的1～2倍和2%～4%。同时，对Cl，HN₃和I₂配比对小信号增益系数和增益持续时间的影响进行了讨论。     

采用空心阴极放电等离子体化学气相沉积方法制备a-CH薄膜

 研究了不同衬底-阴极距离、直流电压和H₂流量对a-CH薄膜沉积速率的影响。结果表明：衬底-阴极距离必须大于0.5cm，随着该距离的增加，薄膜的沉积速率减少；直流电压达550V时沉积速率最大；随着H2含量的增加，CH₄含量相对减少，沉积速率随之降低。用AFM观察了以该方法制得的448.4nm CH薄膜的表面形貌，表面粗糙度约为10nm。最后测出了不同条件下CH薄膜的UV-VIS谱，由此可以计算得到薄膜的禁带宽度及折射率。     

Harnack inequality for some classes of Markov processes

In this paper we establish a Harnack inequality for nonnegative harmonic functions of some classes of Markov processes with jumps. Mathematics Subject Classification (2000): Primary 60J45, 60J75, Secondary 60J25.This work was completed while the authors were in the Research in Pairs program at the Mathematisches Forschungsinstitut Oberwolfach. We thank the Institute for the hospitality.The research of this author is supported in part by NSF Grant DMS-9803240.The research of this author is supported in part by MZT grant 0037107 of the Republic of Croatia.     

BMAP/G/1 queue with correlated arrivals of customers and disasters

We consider a single server queue with disasters where the arrivals of customers and disasters are correlated. When a disaster occurs, it removes all the customers in the system and there requires repair time for the system to be operated normally. The stationary queue length distribution at the embedded points and at an arbitrary time are presented.