Optical detection of phenolic compounds based on the surface plasmon resonance band of Au nanoparticles

An indirect colorimetric method is presented for detection of trace amounts of hydroquinone (1), catechol (2) and pyrogallol (3). The reduction of AuCl4(-) to Gold nanoparticles (Au-NPs) by these phenolic compounds in the presence of cetyltrimethylammonium chloride (CTAC) produced very intense surface plasmon resonance peak of Au-NPs. The plasmon absorbance of Au-NPs allows the quantitative colorimetric detection of the phenolic compounds. The calibration curves derived from the changes in absorbance at lambda = 568 nm were linear with concentration of hydroquinone, catechol and pyrogallol in the range of 7.0 x 10(-7) to 1.0 x 10(-4)M, 6.0 x 10(-6) to 2.0 x 10(-4)M and 6.0 x 10(-7) to 1.0 x 10(-4)M, respectively. The detection limits were 5.3 x 10(-7), 2.5 x 10(-6) and 3.2 x 10(-7)M for the hydroquinone, catechol and pyrogallol, respectively. The method was applied satisfactorily to the determination of phenolic compounds in water samples and pharmaceutical formulations.     

A discussion on mass resolution in secondary ion mass spectrometry

Mass resolution is a very important parameter for mass spectrometry. It is necessary to compare the mass resolution between the newly developed TOF-SIMS and the conventionally high-performance magnetic SIMS. However, the definitions of mass resolution for these two types of instruments are quite different. Whether it is possible to compare mass resolution and how to do such comparison is a challenge. This problem was raised officially during the 2012 ISO/TC 201 meeting at Tampa, Florida, the United States and the long-term cooperation with ISO started afterwards. The definition of mass resolution is one of the most important and fundamental problems for mass spectrometry and should attract significant attention. Here, some detail discussions on mass resolution as well as the related experimental studies in the past few years, including the collaborations with ISO/TC 201/SC6 and SC1 are summarized. This summary covers the common problem for almost all the current existing and still used definitions of mass resolution. A reasonable new definition for mass resolution considering the peak shape or resolution function has been proposed, which has also been confirmed by using experimental studies of the mass resolution comparison between TOF and magnetic SIMS. This study lays a foundation for the future mass resolution comparisons between different mass spectrometry.     

The Fundamental Experiments of Red Tide Chemical Forecast

Many food algae and red tide algae were cultivated in the f/2 medium, and the nitric oxide (NO) concentration of the medium and the cell density were determined. The experiments on algae were conducted when different concentrations of NO were added into the medium using two methods. The results show that low concentrations of NO were self-produced by marine algae during the exponential growth period and were about nmol/L level. But at the end of the period, i.e., 2 or 3 days before the cell density reaches the maximum, an NO peak appeared, with the NO concentration reaching 10 nmol/L. The NO threshold concentration exists according to the influence of exogenous NO on the marine phytoplankton growth. One type is the threshold concentration that can promote algae growth, and its value is between 10 and 1 nmol level, or even lower. The other type can inhibit the phytoplankton growth, which is about μmol level or higher. The results indicate that red tide algae are far more sensitive to NO than are food algae. The fundamental experimental outcome above may provide a new clue for red tide chemical forecast by inspecting the NO change.     

Note on the theory of three-dimensional growth of the porous passivating layers on metals

An analytical relationship “the current peak height—the potential sweep rate” is derived for the three-dimensional film formation under ohmic resistance control. The model takes into account both the changing of the coverage degree and the thickening of the surface film. It is shown that a criterion for definition of the growth type (2D or 3D) of the surface film can be offered. An offered model is tested for anodic oxidation of silver in sulfuric acid solution.     

Hepatobiliary excretion and brain distribution of caffeine in rats using microdialysis

To investigate the pharmacokinetic mechanism of hepatobiliary excretion and brain distribution of caffeine, this study uses a method based on microdialysis technique and liquid chromatography that allows continuous and concurrent in vivo monitoring of extracellular caffeine in the blood, brain and bile of anesthetized rats following the administration of caffeine (3 or 10 mg/kg, i.v.) through the femoral vein. Dialysates of the blood, brain and bile were directly injected onto the liquid chromatographic system and no further clean-up procedures were required. The study design consisted of two groups of six rats in parallel: the rats of the control group received caffeine (3 or 10 mg/kg, i.v.) alone and those of the cyclosporine treated-group were injected cyclosporine (10 mg/kg, i.v.) 10 min prior to caffeine administration (3 or 10 mg/kg, i.v.). The decline of caffeine in the blood, brain striatum and bile suggested that caffeine had rapid exchange and equilibration between the peripheral compartment and the central nervous system. In addition, the results indicated that caffeine underwent hepatobiliary excretion and was distributed into brain. When cyclosporine was co-administered, the pharmacokinetic parameters were not significantly altered. The results of this study reveal that the pharmacokinetic mechanism of hepatobiliary excretion and brain distribution of caffeine might not relate to P-glycoprotein.     

模差渐进投影法解析重叠色谱峰

提出了一种鉴别重叠色谱峰类型的化学计量学方法——模差渐进投影(MDEP)法。该方法利用二维色谱数据中相邻两个色谱流出点的光谱矢量模的和与该两个矢量和的模之差,建立模差-时间(dm-t)曲线判断非纯色谱峰的纯组分区,同时判定第二组分色谱流出点和倒数第二组分色谱结束点。分别以纯组分区的光谱矢量建立正交阵对该色谱峰进行投影运算,得到投影后转换色谱。该转换色谱消除了纯组分区所对应化合物的色谱和光谱信息。对转换色谱重复上述操作至整个色谱峰的模差-时间曲线均为0时终止,得到重叠色谱峰各组分的色谱流出点和结束点。利用上述结果,采用不包含待测组分光谱信息的该重叠峰二维色谱数据建立正交矩阵对该色谱峰进行投影运算,获得待测组分的相似色谱图。通过比对分析即可得到该组分在重叠色谱峰中的光谱和色谱信息。依次操作,即可获得重叠色谱峰中各组分的光谱和色谱信息。采用模差渐近投影法对4组分模拟重叠二维色谱峰及杜香挥发油GC-MS的重叠色谱峰进行了解析,方法简便、结果准确。     

D-和L-丙氨酸的低温磁相变——磁场变化下的比热和直流磁化率(英文)

为了解D-和L-丙氨酸单晶晶格在极低温下是否存在磁手性相变,在2-20 K下改变磁场强度(0,1,3,5T)测定其比热.实验结果表明比热和温度之间的函数关系很好地符合C(T)=aT3+b/T2方程,其中aT3项为晶格声子的贡献,可由公式CV=(12/5)π4R(T/ΘD)3来描述(ΘD为德拜温度),b/T2项为磁场对比热的贡献.实验发现,在2-20 K范围内D-和L-丙氨酸单晶在不同磁场强度下均存在Boson峰(在Cp/T3-T曲线中表现为一个最大值).磁的贡献导致D-和L-丙氨酸单晶的四条Cp/T3-T曲线在2-12 K时不重合,且在12-20 K时消失,此即Schottky反常.零磁场下,D-和L-丙氨酸的Boson峰分别为9.44和10.86 K;德拜温度分别为151.5和152.7 K.结合磁场强度1 T下的直流磁化率测定,发现在温度低于5 K时,D-和L-丙氨酸单晶有相反的磁化率行为,反映了核自旋和电子自旋弱相互作用的手性表现.     

分数导数结合傅里叶最小二乘拟合处理含噪音的重迭信号

提出了一种含噪音重迭信号的综合处理方法 :先用傅里叶最小二乘法拟合噪音数据 ,然后对拟合后的信号求 2 .5次导数 ,在对模拟数据研究的基础上 ,讨论了求导后峰位漂移及其影响因素 ,给出了一个用于矫正峰位值的经验公式。用该方法对模拟和实际的紫外含噪音重迭信号进行处理 ,结果良好     

Advantages of using a modified orthogonal sampling configuration originally designed for LC-ESI-MS to couple CE and MS for the determination of antioxidant phenolic compounds found in virgin olive oil

A ThermoFinnigan sheath liquid flow capillary electrophoresis-mass spectrometry system designed for coupling via a co-axial interface was coupled through an adapted via an alternative, commercially available interface for orthogonal sampling. The affordable, reversible structural alterations made in the commercial LC-MS interface resulted in improved analytical performance.The results of a conventional capillary electrophoresis (CE) method using a commercial co-axial source to determine antioxidant phenolic acids present in virgin olive oil, were compared with those obtained by using a modified orthogonal sampling position. In both cases, separations were done using a 10 mM ammonium acetate/ammonium hydroxide buffer solution at pH 10.0 and a constant applied voltage of 25 kV. The operating variables for the mass spectrometry interface were re-optimized for the modified orthogonal orientation. This allowed the sheath liquid, sheath gas flow rates and capillary voltage to be lowered with respect to the co-axial coupling configuration. In addition, the orthogonal sampling position provided a higher selectivity by effect of ion sampling excluding larger droplets—with an increased momentum along the axis—which were drained through the sink at the bottom of the ion source. Also, the new configuration facilitated sample ionization, improved electrospray stability and led to stronger signals as a result.The new system was validated in terms of precision (repeatability), linearity, and limits of detection and quantification. A comparison of the validation data with the results previously obtained by using a commercial co-axial configuration revealed the adapted orthogonal sampling position to provide better repeatability in both migration times and relative peak areas (<1% and 7% respectively with n = 15 replicates), a good linear range (with levels in the microgram-per-litre region) and lower limits of detection—especially for the compounds detected with the lowest sensitivity when co-axial ESI was used, as HFA, GEN, FER and VAN finding LOD among 24-3.0 μg L⁻¹ respectively.     

Beyond labels: A review of the application of quantum dots as integrated components of assays, bioprobes, and biosensors utilizing optical transduction

A comprehensive review of the development of assays, bioprobes, and biosensors using quantum dots (QDs) as integrated components is presented. In contrast to a QD that is selectively introduced as a label, an integrated QD is one that is present in a system throughout a bioanalysis, and simultaneously has a role in transduction and as a scaffold for biorecognition. Through a diverse array of coatings and bioconjugation strategies, it is possible to use QDs as a scaffold for biorecognition events. The modulation of QD luminescence provides the opportunity for the transduction of these events via fluorescence resonance energy transfer (FRET), bioluminescence resonance energy transfer (BRET), charge transfer quenching, and electrochemiluminescence (ECL). An overview of the basic concepts and principles underlying the use of QDs with each of these transduction methods is provided, along with many examples of their application in biological sensing. The latter include: the detection of small molecules using enzyme-linked methods, or using aptamers as affinity probes; the detection of proteins via immunoassays or aptamers; nucleic acid hybridization assays; and assays for protease or nuclease activity. Strategies for multiplexed detection are highlighted among these examples. Although the majority of developments to date have been in vitro, QD-based methods for ex vivo biological sensing are emerging. Some special attention is given to the development of solid-phase assays, which offer certain advantages over their solution-phase counterparts.