工作气压对磁控溅射ITO薄膜性能的影响

工作气压在ITO薄膜的制备过程中是一个重要的工艺参数,直接决定着薄膜的性能.本文利用射频磁控溅射方法,采用氧化铟锡陶瓷靶材,在衬底温度为175℃,工作气压范围为0.45～1.0 Pa条件下,制备了氧化铟锡透明导电薄膜.研究了工作气压对其微观结构、表面形貌和光电特性的影响.在衬底温度为175℃、纯氩气中制备的氧化铟锡薄膜电阻率为3.04 ×10-4 Ω·cm、可见光波段(400～800 nm)透过率为91.9;,适合用作异质结太阳电池的前电极和减反射膜.     

Cloning, Expression and Purification of Wheat Acetyl-CoA Carboxylases CT Domain in E.coil

The entire gene of carboxyltransferase(CT) domain of acetyl-CoA carboxylase(ACCase) from Chinese Spring wheat(CSW) plastid was cloned firstly,and the 2.3 kb gene was inserted into PET28a+ vector and expressed in E.coil in a soluble state.The (His)6 fusion protein was identified by SDS-PAGE and Western blot.The recombinant protein was purified by affinity chromatography,and the calculated molecular mass(Mr) was 88000.The results of the sequence analysis indicate that the cloned gene(GeneBank accession No.EU124675) was a supplement and revision of the reported ACCase CT partial cDNA from Chinese Spring wheat plastid.The recombinant protein will be significant for us to investigate the recognizing mechanism between ACCase and herbicides,and further to screen new herbicides.     

（Ti,Al）N薄膜光学性能的研究

研究了（Ｔｉ，Ａｌ）薄膜的光学特性，对其反射和透射光谱作了仔细分析。运用Ｈａｄｌｅｙ方程，算出一定成分（Ｔｉ，Ａｌ）Ｎ膜的折射率ｎ，消光系数ｋ随波长的变化关系。又根据透射曲线，计算出了（Ｔｉ，Ａｌ）Ｎ膜的光隙能。     

电子束、离子辅助和离子束溅射三种工艺对光学薄膜性能的影响

运用电子束、离子辅助和离子束溅射三种镀膜工艺分别制备光学薄膜,包括单层氧化物薄膜和增透膜,然后采取一系列测试手段,如Zygo轮廓仪、原子力显微镜、表面热透镜技术和X射线衍射等技术,来分析和研究不同的工艺对这些薄膜性能的不同影响,以判断合理的沉积工艺。     

Effects of laser irradiation on optical properties of a-Se100−x Te x thin films

The effect of laser irradiation on the optical properties of thermally evaporated Se_100?x Te _x (x=8, 12, 16) chalcogenide thin films has been studied. The result shows that the irradiation causes a shift in the optical gap. The results have been analyzed on the basis of laser irradiation-induced defects in the film. The width of the tail of localized state in the band gap has been evaluated using the Urbach edge method. As the irradiation time increases, the values of the optical energy gap for all compositions decrease, while tail energy width increases. It is also observed that the optical energy gap decreases with increasing Te content in the alloy. These changes are a consequence of an increment in disorder produced by laser irradiation in the amorphous structure of thin film.     

Adhesive fracture of heterogeneous interfaces

We have studied the effect of interface heterogeneity on fracture, at both local and global scales. The single cantilever beam adhesion test was used to investigate interfacial fracture between polycarbonate plates and an elastic/fragile epoxy adhesive. Two surface treatments were applied to a (given) polycarbonate plate giving zones of strong and weak adhesion parallel to the crack direction. Calculated fracture energies differed from those expected from a simple rule-of-mixtures. A perturbation method, proposed by Rice, was used and results compared with crack fronts observed in situ. The technique was applied successfully but the difference in values of stress intensity factor between the zones was found substantially different from the experimental value. In an attempt to explain discrepancies, specimens with discontinuous crack fronts (adhesive and/or plates severed along the strong/weak adhesion frontier) were tested. Good agreement was found with the rule-of-mixtures predictions raising questions about the role of crack front continuity in load transfer.     

Characterizing polymer macrostructures by identifying and locating microstructures along their chains with the kerr effect

In this brief report, we demonstrate that Kerr effect measurements, which determine the excess birefringence contributed by polymer solutes in dilute solutions observed under a strong electric field, are highly sensitive to and capable of determining their microstructures, as well as their locations along the macromolecular backbone. Specifically, using atactic triblock copolymers with the same overall composition of styrene (S) and p-bromostyrene (pBrS) units, but with two different block arrangements, that is, pBrS₉₀-b-S₁₂₀-b-pBrS₉₀ (I) and S₆₀-b-pBrS₁₈₀-b-S₆₀ (II), which are indistinguishable by NMR, we detected a dramatic difference in their molar Kerr constants (_mK), in agreement with those previously estimated. Although similar in magnitude, their Kerr constants differ in sign, with _mK(II) positive and _mK(I) negative. In addition, S/pBrS random and gradient copolymers synthesized by reversible addition-fragmentation chain-transfer (RAFT) polymerization exhibit a heretofore unexpected enhanced enchainment of racemic (r) pBrS-pBrS diads. Comparison of their observed and calculated _mKs suggests that the gradient S/pBrS copolymers possess an unanticipated additional gradient in stereosequence that parallels their comonomer gradient, that is, as the concentration of pBrs units decreases from one end of the copolymer chain to the other, so does the content of r diads. This conclusion could only be reached by comparison of observed and calculated Kerr effects, which access the global properties of macromolecules, and not NMR, which is only sensitive to local polymer structural environments, but not to their locations on the copolymer chains. Molar Kerr constants are characteristic of entire polymer chains and are highly sensitive to their constituent microstructures and their distribution along the chain. They may be used to both identify constituent microstructures and locate them along the polymer chain, thereby enabling, for the first time, characterization of their complete macrostructures. © 2013 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys, 2013     

Design of a new thin-film electro-optic switch

A new thin-film electro-optic switch employing two stable states of polarization is proposed and investigated. The design can be further employed to realize a TE-TM polarization converter by constructing a Mach-Zehnder type interferometer integrated optical switch. The limitations and design procedures for electro-optic devices are also discussed.     

Capillarity driven spreading of power-law fluids

We investigate the spreading of thin liquid films of power-law rheology. We construct an explicit travelling wave solution and source-type similarity solutions. We show that when the nonlinearity exponent λ for the rheology is larger than one, the governing dimensionless equation h_t + (h^λ+2|h_xxx|^λ−1h_xxx)_x=0 admits solutions with compact support and moving fronts. We also show that the solutions have bounded energy dissipation rate.