Topical Problems in the Biosynthesis of Red Blood Pigment

Uroporphyrinogen III plays a key role in the biosynthesis of heme, the red pigment of blood. In vivo studies with specifically ¹⁴C- and ³H-labeled precursors have revealed that the formation uroporphyrinogen III in the organism follows several primary and subsidiary pathways. Model experiments on the pattern of biosynthesis have led to simple and effective methods of synthesizing uroporphyrin analogs and have shown that their production is strongly favored thermodynamically. The biologically porphyrins important thus available permit a mechanistic explanation of the light-induced dermatoses in porphyria diseases and suggest promising medical applications in diagnosis and therapy.     

Functional magnetic resonance imaging of tonic pain and vasopressor effects in rats

In functional magnetic resonance imaging (fMRI) studies, an elevation in blood pressure (BP) in individuals with a poor autoregulatory response may increase cerebral blood flow, potentially enhancing the blood oxygenation level dependent response. To investigate the role of BP changes, the cerebral activation to either tonic pain or the infusion of the vasopressor norepinephrine was correlated with the accompanying BP changes in alpha-chloralose anesthetized rats. Immediately after formalin (2%) injection into the forepaw, fMRI detected an activation that was correlated with the BP increase and additional activations that were independent of blood pressure changes 5–40 minutes later. The activation detected with the administration of the vasopressor norepinephrine, which does not cross the blood-brain barrier was correlated to both the amount and rate of increase in BP. The response ranged from being sparse, localized within cortex or widespread during modest, moderate or severe elevations in BP, respectively. The cerebral circulatory effects of hypertension should be considered as contributing to changes in cerebral blood oxygenation in fMRI studies involving increases in BP.     

基于近红外反射光谱的无损血糖分析

无损血糖监测是一种方便且无痛的血糖监测方法。目前,大部分的血糖检测方法都是有损的。提出了一种基于近红外反射光谱的无损血糖检测方法。近红外反射光谱是一种安全、简单并且有效的方法,被应用于很多领域。采用口服葡糖糖耐量试验来采集数据,用偏最小二乘回归方法来建模。使用市售血糖仪采指尖血作为参考值,同时用光谱仪提取手掌光谱,共取得42组样本。血糖浓度范围在5~12 mmol·L-1。采用留一法交叉验证,获得所有数据的交叉验证的均方根误差为1.16 mmol·L-1。通过归一化和无关变量消除的预处理方法来减少噪声并消除一些额外因素,优化的均方根误差为0.79 mmol·L-1。基于个人的数据进行建模,得到了远小于整体数据的结果：0.41 mmol·L-1。该方法在个人血糖检测的市场化方面有广阔的应用前景。     

Perfluoro compounds as blood substitutes.

Inconceivable as it is, it has been proved that animals can survive after having had their blood massively or even totally replaced by emulsions of perfluorinated compounds in salines. “Bloodles” rats charged with an emulsion of perfluorotri-n-butylamine survived a five hour period in an atmosphere containing 50% oxygen and 50% carbon monoxide, i.e. in conditions where the transport of oxygen by the red cells is entirely blocked. This review discusses: (1) the experiments which have demonstrated the capability of blood substitutes based on perfluorinated compounds to sustain life; (2) the characteristics and preparation of the relevant perfluoro compounds and the production and handling of their emulsions; (3) their “physiology”, i.e. toxicity, life-span in the blood-stream, effect on the organs and their functions, and excretion properties. Obstacles remaining to be overcome in order to provide a safe blood substitute for medical practice include the availability of numerous series of well-defined pure and inert perfluorinated chemicals, the production of stable emulsions, the optimization of fluid balance, and the attainment of reasonable excretion rates. The accent is placed upon the role of the chemist in the progress of this research.     

Analytical techniques for cyanide in blood and published blood cyanide concentrations from healthy subjects and fire victims

Hydrogen cyanide can be produced by the pyrolysis of man-made polymers. Cyanide has been measured in the blood of healthy adults as well as the blood of fire survivors and fatalities. In healthy subjects the blood cyanide concentration of smokers is higher than that of non-smokers. Fire survivors and fatalities have been found to have higher cyanide levels than of control groups and the levels from fire fatalities are often higher than survivors. Blood concentrations quoted as normal, toxic or fatal are highly variable in the literature. Many studies have been performed to measure the blood cyanide levels in control subjects as well as those who have been exposed to fire but the values found differ. The values for control subjects can vary from none detected to 19 μmol dm⁻³ while those for fire survivors range from not detected to 150 μmol dm⁻³ and fatalities range from not detected to 284 μmol dm⁻³. Analytical techniques and published data are critically reviewed.Many of the existing antidotes for cyanide poisoning are highly toxic themselves and should ideally be administered at doses proportional to the amount of cyanide a patient has received to avoid compounding damage done by cyanide intoxication. For this reason, a rapid, accurate bedside assay of blood cyanide concentration that differentiates between bound and free cyanide would represent a leap forward in the clinical management of cyanide poisoning.     

Practical and quality-control aspects of multi-element analysis with quadrupole ICP–MS with special attention to urine and whole blood

Two screening methods were developed for rapid analysis of a great number of urine and blood samples within the framework of an exposure check of the population after a firework explosion. A total of 56 elements was measured including major elements. Sample preparation consisted of simple dilution. Extensive quality controls were applied including element addition and the use of certified reference materials. Relevant results at levels similar to those found in the literature were obtained for Co, Ni, Cu, Zn, Sr, Cd, Sn, Sb, Ba, Tl, and Pb in urine and for the same elements except Ni, Sn, Sb, and Ba in blood. However, quadrupole ICP–MS has limitations, mainly related to spectral interferences, for the analysis of urine and blood, and these cause higher detection limits. The general aspects discussed in the paper give it wider applicability than just for analysis of blood and urine—it can for example be used in environmental analysis.     

Sampling procedure and a radio-indicator study of mercury determination in whole blood by using an AMA 254 atomic absorption spectrometer

A sampling procedure appropriate for the determination of mercury in whole blood was tested by using both inactive controls and a ¹⁹⁷Hg mercury radio-indicator. To exclude the influence of the instrumental device (an AMA 254 single-purpose mercury atomic absorption spectrometer) on the determination of mercury in whole blood, the function of the instrument was checked by using rat blood with metabolised ¹⁹⁷Hg. The measurement procedure was found to be free of errors. However, the study showed that the material used for the sampling vessels is a crucial parameter for obtaining accurate analytical results. The stability of solutions and samples was tested towards polyethylene (PE) and polypropylene (PP) vessels. PE displayed a time-dependent increase in the mercury content both in the samples and in the blood control material. The probable cause of this increase was direct contamination from the material of the vessel and/or diffusion of mercury from the environment through the vessel walls related to a strong complexing affinity of the sample matrix. This assumption was confirmed by supplying the vessels with the complexing agent Na₂EDTA (0.05 mol L^–1). Commercial PP vessels for blood sampling (Sarstedt S-Monovette Metall Analytik) did not give rise to statistically significant variations in mercury content in the samples and blood control material over a 30-day period.     

Comprehensive blood plasma lipidomics by liquid chromatography/quadrupole time-of-flight mass spectrometry

A lipidomics strategy, combining high resolution reversed-phase liquid chromatography (RPLC) with high resolution quadrupole time-of-flight mass spectrometry (QqTOF), is described. The method has carefully been assessed in both a qualitative and a quantitative fashion utilizing human blood plasma. The inherent low technical variability associated with the lipidomics method allows to measure 65% of the features with an intensity RSD value below 10%. Blood plasma lipid spike-in experiments demonstrate that relative concentration differences smaller than 25% can readily be revealed by means of a t-test. Utilizing an advanced identification strategy, it is shown that the detected features mainly originate from (lyso-)phospholipids, sphingolipids, mono-, di- and triacylglycerols and cholesterol esters. The high resolution offered by the up-front RPLC step further allows to discriminate various isomeric species associated with the different lipid classes. The added value of utilizing a Jetstream electrospray ionization (ESI) source over a regular ESI source in lipidomics is for the first time demonstrated. In addition, the application of ultra high performance LC (UHPLC) up to 1200 bar to extend the peak capacity or increase productivity is discussed.     

不同表面性质聚电解质多层膜的制备及蛋白质吸附和血液相容性能

利用层层自组装方法制备了聚烯丙基铵盐酸盐(PAH)/聚苯乙烯磺酸钠(PSS)多层膜. 通过吸附或共价偶联, 在多层膜表面修饰了聚乙二醇(PEG)、牛血清白蛋白(BSA)或肝素, 通过石英晶体微天平(QCM)、椭圆偏振光谱和原子力显微镜(AFM)研究了多层膜的表面形貌及修饰方法对各种蛋白的吸附性能. 经修饰后的多层膜较基底膜的厚度均有所增大; 最外层经修饰后的多层膜吸附的BSA、纤维蛋白原及血浆蛋白的量较未修饰多层膜均有所减少. 采用SEM观察了血小板在多层膜上的黏附情况和形态变化, 计算了血小板的黏附率. 比较各多层膜的凝血酶原时间(PT), 发现修饰后的多层膜的凝血酶原时间均有所延长, 但各组间无显著性差异.     

纤维素/甲壳素共混膜的结构表征与抗凝血性能

以 6wt %NaOH 4wt%尿素为纤维素的新溶剂 ,采用溶液共混法制备出纤维素 甲壳素共混膜 ,为甲壳素在碱性溶液中制膜提供了新的方法 .红外光谱、X 射线衍射、扫描电镜和力学性能、抗凝血性能测试结果表明 ,共混膜中甲壳素含量低于 4 0wt%时 ,纤维素与甲壳素分子间具有良好的相容性 ;在纤维素中引入适量甲壳素可提高共混膜的抗张强度 ,共混膜的干、湿态抗张强度在甲壳素含量 10wt%时最大 ,其值分别为 89 1MPa和 4 3 7MPa ,比纯态纤维素膜的干、湿态抗张强度分别提高了 6 7%和 11 5 % ;甲壳素的引入可明显降低血小板在共混膜表面的粘附、凝聚与变性 ,增大共混膜的抗凝血参数 ,甲壳素含量达到 5 0wt%时 ,该共混膜具有良好的抗凝血性能