空间薄膜阵面结构褶皱的实验研究

阵面薄膜上的褶皱会显著影响航天器性能,褶皱控制也是薄膜航天器研发的难点。本文采用白光扫描技术,测试了一个正方形薄膜阵面结构在纯剪切作用下的褶皱特性。测试结果显示,随着剪切力的增大,结构膜面褶皱数增加,褶皱幅度增大,膜面平整度降低。随着膜面预应力的增大,膜面上的褶皱数略有增大,褶皱幅度有所减小,膜面平整度有所提高。测试结果还显示,膜面上粘结缝的存在、以及粘结缝与剪切力间的方位关系对膜面褶皱有复杂的影响。论文所得结论对薄膜阵面结构设计研发具有参考价值。     

流动肥皂膜气体界面及其在柱状汇聚激波作用下演化的实验研究

在Richtmyer-Meshkov(RM)不稳定性实验研究中,形成两种不同密度流体的初始扰动界面是前提和关健.本文提出了一种流动肥皂膜气体界面生成方法,其工作原理是由细丝构成的导流框从激波管实验段穿过,肥皂液从导流框的上端注入并在重力作用下在导流框中形成流动肥皂膜,膜的两测可以分别充入不同密度的气体从而形成稳定的气体...     

基于油膜干涉法的表面摩擦应力测量技术研究

本文应用油膜干涉法及速度型方法在平板模型上进行低速湍流的表面摩擦阻力测量,探索了油膜法测量表面摩擦阻力的实验技术,分析了不同实验方式对测量结果的影响以及实验误差产生的原因.研究表明,模型安装方式、油膜布置方式以及重力作用的影响在油膜干涉法中基本都可以忽略,在精度要求不高的情况下,不需要对结果进行修正.通过采用热膜法和油...     

Strain tunability of dielectric and ferroelectric properties in epitaxial lead titanate thin films

Many distinguished properties of epitaxial ferroelectric thin films can be tunable through the misfit strain. The strain tunability of ferroelectric and dielectric properties in epitaxial lead titanate ultrathin films is numerically investigated by using a phase field model, in which the surface effect of polarization is taken into account. The response of polarization to the applied electric field in the thickness direction is examined with different misfit strains at room temperature. It is found that a compressive misfit strain increases the coercive field and the remanent polarization while a tensile misfit strain decreases both of them. The nonlinear dielectric constants of the thin films with tensile misfit strains are much larger than those of the thin films without misfit strains, which are attributed to the existence of the a/c/a/c multiple domains in the thin films under tensile misfit strains.     

Experimental and numerical study on the falling film flow characteristics outside circular tube applied in floating liquefied natural gas (FLNG) under offshore conditions

Spiral wound heat exchanger (SWHE) relying on falling film evaporation and boiling is often used for FLNG. The performance of SWHE can be impacted strongly by the motion of the FLNG caused by the wave and typhoon. The falling film characteristics of SWHE outside circular tube are studied experimentally and numerically by a visualization experimental device based on the high-speed camera and a numerical model based on the dynamic grid. The results show that the wave crest of the liquid film moves to the titled side under offshore conditions. The evolution process of falling film flow pattern outside circular tube with the tilt angle of 9° can be divided into four stages: droplet formation and migration, liquid column formation and migration, liquid column coalescence, liquid sheet formation. A correlation permitting the prediction of the falling film flow pattern outside circular tube and the other one permitting the prediction of the average film thickness of circular tube are developed respectively based on the experimental and numerical data.     

一种基于荧光信号的海面厚油膜评估方法

油膜厚度是海面溢油污染评估分析的一个重要指标,激光诱导荧光(LIF)技术是目前最有效的海面溢油探测技术之一,基于LIF探测技术的油膜厚度反演算法当下仅有适用于薄油膜(≤10~20 μm)的评估方法,而对于较厚油膜(>20 μm)的评估目前尚无有效的反演算法。鉴于此,提出一种基于LIF技术适用于较厚油膜的反演算法,该算法采用油膜荧光信号反演油膜厚度,推导了油膜厚度反演公式,并给出了基于该反演算法的油膜厚度评估方法。首先采用最大类间方差算法(Otsu)选取合适的荧光光谱波段,然后根据选取波段内每个波长的光谱数据反演油膜厚度,最后采用反演油膜厚度的平均值作为油膜厚度评估结果。研究了该算法的适用范围,给出了该算法有效评估范围最大值与测量相对误差的关系,并结合消光系数给出了在多种测量误差条件下不同消光系数油品有效评估范围的最大值。通过实验对本文方法进行了验证,选用原油和白油的混合油(1∶50)作为实验油品,以波长为405 nm的激光作为激发光源,采集波长范围为420～750 nm,采集了海水背景荧光和拉曼散射光光谱、实验油品的荧光特征光谱和多种不同厚度的较厚油膜的荧光光谱。采用Otsu算法选取420～476 nm波段评估油膜厚度,在实验油品油膜厚度≤800 μm时,该算法对油膜厚度的评估具有较高的精度,平均误差为10.5%;在油膜厚度>800 μm时,平均误差为28.8%,评估误差较大且随油膜厚度的增加快速变大,该实验结果与利用测量相对误差和消光系数的分析结果一致。实验结果表明,该方法可以实现对海面较厚油膜厚度的有效评估,并可以根据测量相对误差和消光系数判断评估结果的有效性。     

厚度对未掺杂ZnO薄膜光谱性能的影响

X射线衍射光谱、拉曼光谱和紫外可见透射光谱技术是薄膜材料检测的重要技术手段。通过对薄膜材料光谱性能的分析,可以获得薄膜材料的物相、晶体结构和透光性能等信息。为了解厚度对未掺杂ZnO薄膜的X射线衍射光谱、拉曼光谱和紫外可见透射光谱性能的影响,利用溶胶-凝胶法在石英衬底上旋涂制备了不同厚度的未掺杂ZnO薄膜样品,并对薄膜样品进行了X射线衍射光谱、拉曼光谱和紫外可见透射光谱的检测。首先,通过X射线衍射光谱检测发现,薄膜样品呈现出（002）晶面的衍射峰,ZnO薄膜为六角纤锌矿结构,均沿着C轴择优取向生长,且随着薄膜厚度的增加,衍射峰明显增强,ZnO薄膜的晶粒尺寸随着膜厚的增加而长大。利用扫描电子显微镜对薄膜样品的表面形貌分析显示,薄膜表面致密均匀,具有纳米晶体的结构,其晶粒具有明显的六角形状。通过拉曼光谱检测发现,薄膜样品均出现了437 cm-1的拉曼峰,这是ZnO纤锌矿结构的特征峰,且随着薄膜厚度的增加,其特征拉曼峰强度也增加,进一步说明了随着ZnO薄膜厚度的增加,ZnO薄膜晶化得到了加强。最后,通过紫外可见透射光谱测试发现,随着膜厚的增加,薄膜的吸收边发生一定红移,薄膜样品在可见光区域内的透过率随着膜厚度增加而略有降低,但平均透过率都超过90%。通过对薄膜样品的紫外-可见透射光谱进一步分析,估算了薄膜样品的折射率,定量计算了薄膜样品的光学禁带宽度,计算结果表明：厚度的改变对薄膜样品的折射率影响不大,但其禁带宽度随着薄膜厚度的增加而变窄,且均大于未掺杂ZnO禁带宽度的理论值3.37 eV。进一步分析表明,ZnO薄膜厚度的变化与ZnO晶粒尺寸的变化呈正相关,本质上,吸收边或光学禁带宽度的变化是由于ZnO晶粒尺寸变化引起的。     

Ftir Studies on LB Film of Amphiphile with Schiff Base as Headgroup and Its Copper Complex

Two different ways to form monolayers and LB films (surface film and subphase film) of the complex have been used, where a novel amphiphile containing Schiff base as a headgroup was used as a ligand. the monolayer behavior at the air/water interface was characterized by π-A isotherms and two-dimensional molecular orientation of alkyl chains in LB films and thermal stability were measured by polarized and variable temperature FTIR transmission spectra, indicating that the LB film of the novel amphiphile and its copper(II) complex are very stable as well as stearic acid. Because incorporating the metal ion into the monolayer makes it more condensed, thermal stability of the LB film was enhanced. as can be compared from their structure and properties, subphase films are superior to surface films.     

Lift‐off protocols for thin films for use in EXAFS experiments

Lift‐off protocols for thin films for improved extended X‐ray absorption fine structure (EXAFS) measurements are presented. Using wet chemical etching of the substrate or the interlayer between the thin film and the substrate, stand‐alone high‐quality micrometer‐thin films are obtained. Protocols for the single‐crystalline semiconductors GeSi, InGaAs, InGaP, InP and GaAs, the amorphous semiconductors GaAs, GeSi and InP and the dielectric materials SiO₂ and Si₃N₄ are presented. The removal of the substrate and the ability to stack the thin films yield benefits for EXAFS experiments in transmission as well as in fluorescence mode. Several cases are presented where this improved sample preparation procedure results in higher‐quality EXAFS data compared with conventional sample preparation methods. This lift‐off procedure can also be advantageous for other experimental techniques (e.g. small‐angle X‐ray scattering) that benefit from removing undesired contributions from the substrate.     

声表面波气体传感器研究进展*

基于声表面波技术的气体传感器包括采用敏感膜和结合气相色谱两种方式。比较而言,采用敏感膜的声表面波气体传感器体积小、功耗低,适应小型化毒气报警器的发展要求,但可检测的气体种类少、灵敏度低、存在交叉干扰问题;声表面波与气相色谱联用的气体分析仪灵敏度高、可检测气体种类多、很好地解决交叉干扰问题,特别适合于复杂大气背景条件下的气体成分分析。本文从传感器响应机理分析与物理功能结构两方面出发介绍了两类声表面波气体传感器的研究进展情况。