SARS CoV内对照RNA病毒样颗粒的构建和表达

在SARS-CoV的核酸检测方法中,由于普遍缺乏安全、稳定、特异的内对照,而不能对样品处理、反转录、扩增以及定量检测实施全程监控。构建的病毒样核蛋白颗粒内对照,能够对SARS-CoV临床检测实施监控。本文通过克隆1.7Kb大肠杆菌噬菌体MS2的装配蛋白和壳蛋白基因以及SARS冠状病毒经过突变产生的270bp内对照片断,并将这些基因连接到载体pTrc99a上表达,进行纯化、定量分析、RT-PCR检测和稳定性试验。获得SARS内对照病毒样核蛋白颗粒,在人血清和SM缓冲液中37℃稳定性可达到30天,能抵抗核糖核酸酶降解。将内对照颗粒加入临床样本中一同检测,能够对检测的全过程(样品处理、反转录和PCR)有效进行监控,与SARS-CoV没有交叉反应。研究表明制备的该病毒样核蛋白颗粒稳定、安全、可靠,可作为SARS冠状病毒RT-PCR检测、定量分析的有效内对照参考品。     

聚丙烯酰胺/醋酸铬与聚丙烯酰胺/酚醛胶态分散凝胶的纳米颗粒自组织分形结构

采用原子力显微镜 ,分别对无机交联体系聚丙烯酰胺 Cr3+ 和有机交联体系聚丙烯酰胺 酚醛胶态分散凝胶的微观结构进行了显微图像分析 .发现无论是在有机还是无机交联体系中 ,也无论聚丙烯酰胺和交联剂浓度如何变化 ,在微米尺度上最终形成的都是具有自相似性的树枝状分形图像 ,在更小尺度上则发现单个小树杈分形体都是由纳米级的颗粒紧密堆积而成 .在所研究的胶态分散凝胶体系中 ,树枝状分形结构的形成及其具体的形态取决于聚丙烯酰胺的浓度 ,而交联剂的有无及其多少只对树枝状凝胶分形的几何形态产生一定影响 .实验结果还表明纳米级 (≤ 10 0nm)的胶体颗粒构成的分形结构的凝胶其弹性模量G′比微米级的高出一个数量级 .且粒子尺度越小 ,则凝胶的力学稳定性越强     

Recyclable,non-leaching antimicrobial magnetic nanoparticles

Recyclable antimicrobial magnetic nanoparticles, Fe₃O₄@P(St-co-AcQAC), were prepared through surfactantfree seeded emulsion polymerization involving a polymerizable, hydrophobic quaternary ammonium compound (QAC). These antimicrobial magnetic nanoparticles demonstrated excellent antimicrobial activities against both Grampositive and Gram-negative bacteria, and can be reused for multiple times.     

Protein-coated β-ferric hydrous oxide particles: An electrokinetic and electrooptic study

Using microelectrophoresis and electric light scattering techniques, we investigated the adsorption characteristics, surface coverage and surface electric parameters of superstructures from two isoforms of plastocyanin, PCa and PCb, in an oxidized state adsorbed on β-ferric hydrous oxide particles. The surface electric charge and electric dipole moments of the composite particles and the thickness of the protein adsorption layer are determined in a wide pH range, at different ionic strengths and concentration ratios of PC to β-FeOOH. The adsorption of the two proteins was found to shift the particles’ isoelectric point and to alter the total electric charge and the electric dipole moments of the oxide particles to different extent. A “reversal” in the direction of the permanent dipole moment is observed at lower pH for PCb- than for PCa-coated oxide particles. Strict correlation is found between the changes in the electrokinetic charge of the composite particles and the variation in their “permanent” dipole moments. Data suggest that the adsorption of the proteins is driven by electrostatic and/or hydrophobic interactions with the oxide surfaces dependent on pH. The adsorption behaviour is consistent with the involvement of the “eastern” and “northern” patches of the plastocyanin molecules in their adsorption on the oxide surfaces that are differently charged depending on pH.     

Structure of polynuclear palladium(ii) hydroxocomplexes formed upon alkaline hydrolysis of palladium(ii) chloride complexes

The structure of polynuclear Pd^II hydroxocomplexes (PHC) formed as a result of alkaline hydrolysis of Pd^II chloride complexes was studied by EXAFS, SAXS, and TEM methods. It is established that in aqueous solutions a hydroxocomplex particle is a filament curled into a ball containing about 100 Pd atoms. The filament consists of planar coordination squares of PdO₄ units linkedvia one or two oxygen bridges of different geometry. Aging of samples results in an increase in the number of single bridging ligands and a decrease in the diameter of particles. Interatomic distances around palladium atoms were determined.Translated fromIzvestiya Akademii Nauk. Seriya Khimlcheskaya, No. 10, pp. 1901–1905, October, 1995.     

Growth Mechanism of Large Monodispersed Silica Particles Prepared from Tetraethoxysilane in the Presence of Sodium Dodecyl Sulfate

Monodispersed silica particles up to ca. 1.2 μm in diameter were prepared by hydrolysis of tetraethoxysilane in the presence of sodium dodecyl sulfate (SDS). The particle size was increased with an increase of SDS added. The geometrical standard deviation of the particles was decreased with an increase of SDS. In the earlier reaction stage, double spherical particles by the coalescence of the particles were frequently observed when large amounts of SDS were added. Particle size was gradually increased after the coalescence occurred and spherical particles were finally obtained. The results of Nielsen’s chronomal analysis suggest that the polynuclear layer growth took place after the coalescence of the particles in the presence of larger amount of SDS.     

Early-stage flocculation kinetics of polystyrene latex particles with polyelectrolytes studied in the standardized mixing: Contrast of excess and moderate polyelectrolyte dosage

Standardized mixing procedure was applied to the analysis of flocculation of polystyrene latex (PSL) particles with polyelectrolytes. After confirming the initial enhancement of flocculation rate in the very beginning followed by abrupt stop with excess dosage, attention was shifted to the system of moderate dosage. In the former, effects of ionic strength were further analyzed to find the consistency with adsorption isotherm. In the latter, flocculation started slowly in the beginning, sometime slower than salt-induced rapid coagulation, however, the rate gradually increases in the middle stage. Often, the increased rate exceeds that of salt-induced rapid coagulation. This behavior emerged more clearly in the case of lower ionic strength. This is the indication that the rate of relaxation of polymer on the colloidal surface is a function of surface coverage and ionic strength. The ultimate degree of flocculation is usually higher than that observed for excess dosage. The size distribution of flocs was also examined, however, no clear difference between different experimental conditions was confirmed for the same degree of flocculation.     

表面能与晶体生长/溶解动力学研究的新动向

界面现象使物质在结晶过程中出现了临界现象.但最近的研究指出在物质溶解过程中,在表面能量的控制下也存在着临界现象以及尺寸效应.实验发现,当晶体自身小到一 定的程度时(通常在纳米尺度上并和临界蚀坑的大小相近),在溶解过程中其速度会自发降 低,反应被抑制乃至停止.尽管在热力学上表面能的因素可以赋予小颗粒晶体较大的溶解度 ,但表面能却也能通过对临界条件的控制而使这些微粒在动力学上不被溶解.这个发现不仅 解决了纳米颗粒在水溶液中稳定性的问题,而且还从动力学的角度解释了生物矿物选择纳米 尺度作为其基本构成单元的原因.由于表面能和晶体生长/溶解的动力学有着密切的关系, 我们可以通过对表面能的调节来修改它们的动力学速度和晶体的形貌.反过来,也可以用动力学的方法来测定表面能及表面吸附/脱附常数等.相对于常规的界面研究手段,通过生 长和溶解动力学途径所得的数据有着很好的可靠性及重复性.我们认为,晶体生长和溶解的 动力学和表面能的研究相结合,不仅为界面研究提供了新的思路和方法,而且也会推动晶体生长和材料科学的发展.     

A New Family of Binary Layered Compounds of Platinum with Alkali Metals (A = K,Rb, Cs)

By reacting platinum with alkali metals (A = K, Rb, Cs) a new family of binary alkali metal platinides has been synthesized and characterized by chemical analysis, X‐ray powder diffraction, thermal analysis (DTA and DSC), and magnetic measurements. All three compounds exhibit similar XRD‐patterns with strong reflections that can be indexed on the basis of a rhombohedral crystal system (K_xPt: a = 2.6462(1), c = 17.123(1); Rb_xPt: a = 2.6415(1) Å, c = 17.871(1) Å; Cs_xPt: a = 2.6505(1) Å, c = 18.536(1) Å; x < ½. The a lattice constant is independent on the alkali metal used and of value close to the Pt–Pt distance in NaPt₂ (2.645Å). The c parameter increases monotonically with the growing atomic radius of the alkali metal. The average structure of the alloys consists of cubic close packed layers of platinum atoms with layers of disordered alkali metals in between. For all compounds besides the strong reflections small satellites are observed which cannot be indexed together with the rhombohedral peaks in any rational 3‐dimensional lattice. However, these satellites can be indexed as incommensurate modulations within the ab plane (found propagation vectors k = (0.1011, 0.2506, 0) for Cs_xPt, and k = (0.0168, 0.2785, 0) for Rb_xPt).     

Deposition of Oral Bacteria and Polystyrene Particles to Quartz and Dental Enamel in a Parallel Plate and Stagnation Point Flow Chamber

The aim of this paper is to determine to what extent (i) deposition of oral bacteria and polystyrene particles, (ii) onto quartz and dental enamel with and without a salivary conditioning film, (iii) in a parallel plate (PP) and stagnation point (SP) flow chamber and at common Peclet numbers are comparable. All three bacterial strains showed different adhesion behaviors, and even Streptococcus mitis BMS, possessing a similar cell surface hydrophobicity as polystyrene particles, did not mimic polystyrene particles in its adhesion behavior, possibly as a result of the more negative ζ potentials of the polystyrene particles. The stationary endpoint adhesion of all strains, including polystyrene particles, was lower in the presence of a salivary conditioning film, while also desorption probabilities under flow were higher in the presence of a conditioning film than in its absence. Deposition onto quartz and enamel surfaces was different, but without a consistent trend valid for all strains and polystyrene particles. It is concluded that differences in experimental results exist, and the process of bacterial deposition to enamel surfaces cannot be modeled by using polystyrene particles and quartz collector surfaces.