金橙G螯合形成树脂分离富集地质样品中的微量贵金属

主要研究了金橙Ｇ螯合形成树脂分离富集地质样品中金、铂、钯的最佳实验条件。在柱高大于１６ｃｍ，０．１ｍｏｌ／Ｌ ＨＣｌ介质的样品溶液以小于或等于０．５ｍＬ／ｍｉｎ流速过柱，用０．１ｍｏｌ／Ｌ ＨＣｌ的３％硫脲溶液以小于或等于０．５ｍＬ／ｍｉｎ流速洗脱金、铂、钯（和铑），都能同时定量富集。用火焰原子吸收光谱法测定，回收率均在９５％￣１１０％之间。经地质样品加标准回收实验，结果令人满意。证明这种以磺酸基     

石墨炉原子吸收光谱无标样分析法的研究：Ⅰ.消除基体干扰

实现石墨炉原子吸收光谱绝对分析必须消除基体干扰，本研究采用有机基体改进剂，管壁原子化、热解涂层石墨管，峰面积积分吸收信号，Ｄ２灯或Ｚｅｅｍａｎ效应扣除背景，有效地控制和消除了海水基体对Ａｓ，Ｃｄ，Ｃｏ，Ｃｒ，Ｃｕ，Ｍｎ，Ｎｉ，Ｐｂ和Ｖ等元素的干扰，实现了无干扰测定。     

钯镁基体改进剂对铅,铋,锗在石墨炉中原子化影响的研究

通过原子吸收和X-射线衍射分析证明,加入钯镁基体改进剂在预热处理后对Pb、Bi和Ge三个元素分别生成金属间化合物PbPd_3、BiPd_3、Ge_9Pd_(23)和其他化合物,从而提高了最高允许灰化温度,改变了原子化机理。在原子化阶段这些金属间化合物直接分解为金属原子,结果提高测定灵敏度。     

二价铜、镍EDTA络合物晶体的电子吸收光谱

络合物晶体的电子吸收光谱作为研究晶体的电子结构的基础内容,很早以前就得到人们注意,虽然对Cu~(2+)、Ni~(2+)等络合物电子光谱的能级的经验指认已是一项较为成熟的工作,但对吸收光谱的系统的理论计算和定量解释在以前的文献中尚不多见.近年来,我们对多种晶体的电子吸收光谱进行了定量的解释,结果表明理论计算值总是能很好地符合于实验测定值。一般说来,吸收峰位的波数误差在8%以内. 早在本世纪四十年代就奠定了乙二胺四乙酸(EDTA)在分析化学中的应用基础。     

New diphthalocyanine complexes of rare-earth metals based on 4,5-isopropylidenedioxyphthalonitrile

A series of the earlier unknown diphthalocyanine complexes of rare-earth metals based on 4,5-isopropylidenedioxyphthalonitrile were prepared. Their compositions and yields depend on the radius of the complexing ion. The synthesized compounds were studied by spectroscopy and electrochemical methods. The redox potentials of the complexes studied change nonlinearly with a decrease in the lanthanide ion radius. Published in Russian in Izvestiya Akademii Nauk. Seriya Khimicheskaya, No. 2, pp. 274—279, February, 2006.     

Solid Phase Extraction and Flame Atomic Absorption Spectrometric Determination of Trace Amounts of Zinc and Cobalt Ions in Water Samples

A simple and rapid method for the preconcentration of Co²⁺ and Zn²⁺ as their 2-guanidino-benzimidazole chelates is proposed using an octadecyl silica cartridge. The retained analytes were recovered with a mixture of 5mL of 0.01M HNO₃ and 5mL of methanol. The metal ions in the effluent were determined by flame atomic absorption spectrometry. The effect of different parameters, such as sample matrix, amount of ligand, type of eluent for elution of ions from cartridge, flow rates of sample solution and eluent, breakthrough volume, and limit of detection, were evaluated. The effects of various cationic and anionic interferences on the percent recovery of Co²⁺ and Zn²⁺ were also studied. Quantitative extraction efficiencies were obtained by elution of the cartridge with a minimal amount of solvent. Hence, with a typical preconcentration factor of 50, the limits of detections of the proposed method are 0.26 and 1.62ngmL^–1 for Zn²⁺ and Co²⁺, respectively. The method was applied to the determination of zinc and cobalt ions in different water samples.     

Structural investigation of high-valent manganese-salen complexes by UV/Vis,Raman, XANES,and EXAFS spectroscopy

XANES and EXAFS spectroscopic studies at the Mn-K- and Br-K-edge of reaction products of (S,S)-(+)-N,N'-bis(3,5-di-tert-butylsalicylidene)-1,2-cyclohexanediaminomanganese(III) chloride ([(salen)Mn(III)Cl], 1) and (S,S)-(+)-N,N'-bis(3,5-di-tert-butylsalicylidene)-1,2-cyclohexanediaminomanganese(III) bromide ([(salen)Mn(III)Br], 2) with 4-phenylpyridine N-oxide (4-PPNO) and 3-chloroperoxybenzoic acid (MCPBA) are reported. The reaction of the Mn(III) complexes with two equivalents of 4-PPNO leads to a hexacoordinated compound, in which the manganese atom is octahedrally coordinated by four oxygen/nitrogen atoms of the salen ligand at an average distance of approximately 1.90 A and two additional, axially bonded oxygen atoms of the 4-PPNO at 2.25 A. The oxidation state of this complex was determined as approximately +IV by a comparative study of Mn(III) and Mn(V) reference compounds. The green intermediate obtained in reactions of MCPBA and solutions of 1 or 2 in acetonitrile was investigated with XANES, EXAFS, UV/Vis, and Raman spectroscopy, and an increase of the coordination number of the manganese atoms from 4 to 5 and the complete abstraction of the halide was observed. A formal oxidation state of IV was deduced from the relative position of the pre-edge 1s-->3d feature of the X-ray absorption spectrum of the complex. The broad UV/Vis band of this complex in acetonitrile with lambda(max)=648 nm was consistent with a radical cation structure, in which a MCPBA molecule was bound to the Mn(IV) central atom. An oxomanganese(V) or a dimeric manganese(IV) species was not detected.     

Matrix separation of palladium and iridium by the cellulose anion exchanger Cellex T and the subsequent determination of palladium at theμg/g-level

The preconcentration and separation of palladium and iridium from base metals is studied with cellulose (Cellex T) and styrene-divinylbenzene (Varion AT 400) anion exchangers. In spite of lower capacity of Cellex T to chloride complexes of Pd and Ir, it allowed to get a higher preconcentration factor. Yields of 92–99% are achieved for Pd and 96–97% for Ir from the solutions containing great excess of base and heavy metals. Graphite furnace atomic absorption spectrometry is used for the final measurements. The procedure has been applied to the determination of palladium in natural samples.     

高频燃烧红外吸收光谱法测定钨钛合金中碳含量

建立高频燃烧红外吸收光谱法测定钨钛合金中碳含量的分析方法。在1980 W分析功率下,称取0.3 g样品,以2.0 g钨锡及0.5 g纯铁混合助熔,用高频红外分析仪测定碳。碳的含量在0.013%~0.050%范围内与红外吸收峰面积线性相关,相关系数为0.9993。碳的测定下限为3.6μg/g,方法检出限为1.08μg/g。该法测定结果的相对标准偏差为2.97%~4.11%(n=8),碳的加标回收率为96.2%~103.1%。该方法能够满足合金中碳含量的分析要求。     

Preconcentration of copper with multi-walled carbon nanotubes pretreated by potassium permanganate cartridge for solid phase extraction prior to flame atomic absorption spectrometry

A procedure for the preconcentration of copper was described in this paper using multi-walled carbon nanotubes (MWCNTs) oxidized by potassium permanganate as the adsorbent for the enrichment of trace copper in water samples. Important parameters, such as the sample pH, the concentration and volume of eluent, sample flow rate and volume, and interference of coexisting ions, were investigated. The obtained results indicated that proposed method possessed an excellent analytical performance. The linear range, the detection limit, and precison (RSD) were 1-100 ng/mL (R2 = 0.9993), 0.32 ng/mL and 2.88%, respectively. The results showed that copper could be adsorbed quantitatively on the pretreated MWCNTs with potassium permanganate, and proposed method was very useful in the monitoring of copper in the environment.