a-C:F薄膜的热稳定性与光学带隙的关联

以CF4和C6H6的混合气体作为气源,在微波电子回旋共振化学气相沉积(ECRCVD)装置中制备了氟化非晶碳薄膜(aC:F),并在N2气氛中作了退火处理以考察其热稳定性.通过傅里叶变换红外吸收谱和紫外可见光谱获得了薄膜中CC双键的相对含量和光学带隙,发现膜中CC键含量与光学带隙之间存在着密切的关联,在高微波功率下沉积的氟化非晶碳膜具有低的光学带隙和较好的热稳定性. 关键词： 氟化非晶碳膜 光学带隙 退火温度 热稳定性     

Indirect Methods For Determination of The Protective Effects of Coating Films on The Surface of Crystals

The extents of the protective effects of coating films on the surface of crystals were determined. Three different samples were made with different quantities of coating fluid (Sepifilm LP 010 in 10% aqueous solution). Since the atomizing rate was constant, the coating time increased in parallel with the volume of coating fluid applied. The direct measurement of film thickness and smoothness is very difficult, and therefore indirect methods were used. Dimenhydrinate was chosen as model drug; this is a heat-sensitive antihistamine with a low melting point. This temperature can be reached during the tableting process. The behaviour of samples on exposure to heat was examined by differential scanning calorimetry. The water uptakes of the samples were determined with an Enslin apparatus. Plasticity was studied with an instrumented tablet machine. These indirect methods (thermal conductivity, water uptake and plasticity measurements) revealed connections between the results of the various experiments. An overlong coating time decreased the protective effect of the coating film. This revised version was published online in August 2006 with corrections to the Cover Date.     

宽带膜厚实时监控过程中膜层折射率的确定方法

为了准确计算出镀膜过程中每层膜的折射率，介绍了实时监控过程中确定膜层折射率的2种方法：一种是由实测的透射比光谱直接反算出膜层的折射率；另一种是用最小二乘法的优化算法实时拟合折射率。试验结果表明：在线反算适合单点监控，所得折射率误差小于2%。然而在实际镀膜过程中,由于宽带内膜层参数误差较大,一般大于25%。为此，采用最小二乘法拟合，即在整个宽光谱范围内采集每个波长点的信息，所得结果误差很小，一般都在2％～5%之间,有时可达到10%,在很大程度上提高了实际镀膜时膜厚监控的精度。     

催化剂薄层内甲烷水蒸气重整反应强化管内对流换热的数值模拟

本文以竖直圆管内壁催化剂薄层内发生甲烷水蒸气重整反应强化对流换热作为研究对象,对其进行了数值模拟．结果发现,催化剂薄层内的吸热化学反应可以有效地强化对流换热,降低流体和壁面温度,从而对壁面起到保护作用;极限热流密度的大小与流体的入口温度有关,存在最佳入口温度使极限热流密度最大．     

两种方法制备ITO薄膜的红外特性分析

比较了用电束加热蒸发法和直流磁控溅射法制备的氧化锡铟(ITO)薄膜在红外波段的光学特性实验发现,通过直流磁控溅射在常温下制备的ITO薄膜在红外波段折射率稳定、消光系数小,比电子束加热蒸发制备的膜有较高的透过率在波长1550nm附近的透过率可达86%以上,消光系数约为004,方电阻最低为100Ω/□.     

相变光盘介电薄膜ZnS-SiO2 的微结构和光学特性

采用射频磁控溅射法制备了ZnS-SiO₂ 介电薄膜,利用透射电镜和椭偏仪研究了溅射条件对ZnS-SiO₂薄膜微结构和折射率n的影响.研究表明,ZnS-SiO₂薄膜中存在微小晶粒,大小为2～10 nm的ZnS颗粒分布在SiO₂基体中,当溅射功率和溅射气压变化时,ZnS-SiO₂薄膜的微结构和折射率n发生显著变化,微结构的变化是导致折射率n变化的主要原因,通过优化溅射条件可以制备适用于相变光盘的高质量ZnS-SiO₂介电薄膜.     

Experimental investigation of time-dependent cavitation in an oscillatory squeeze film

The occurrence of time-dependent cavitation and tensile stress in an oscillatory oil squeeze film were investigated experimentally. The test apparatus was a simple thrust bearing consisting of two parallel circular plates separated by a thin viscous oil film. During the test, one plate was at rest while the other (transparent) oscillated in a direction normal to its surface. This test configuration was chosen to avoid the rotational motion and complicated geometry of a squeeze film journal bearing. The frequency of oscillation was in the range of 5 to 50 Hz and was controlled by an electro-magnetic exciter. The process of cavity formation and its subsequent development was recorded by a high-speed video camera. Concomitant pressure in the oil film was measured both within and without the cavitation region. It was found that both tensile stress and cavities existed in a squeeze film under certain working conditions.     

Thermal analysis of glasses for proecological applications

Thermal behaviour and biochemical activity of potassium-silicate-phosphate glasses modified by addition of Ca, Mg, acting as ecological fertilisers of controlled release rate of the nutrients for plants were studied. It has been found that the biochemical activity of silicate-phosphate glasses depends on the nature and the number of components forming the glassy framework and is related to the thermal stability of glass demonstrated by the formation of new compounds during the process of crystallisation. It is proved that these seemingly different properties are determined by the same parameters which are the strengths bonds of glass network-formers and modifiers as well as their chemical affinity. This revised version was published online in July 2006 with corrections to the Cover Date.     

蓝宝石R面上ZnO薄膜的NH3掺杂研究

以NH₃为掺杂源,利用金属有机化学气相沉积(MOCVD)系统在蓝宝石R面上生长出掺氮ZnO薄膜。通过XRD,SEM测量优化了其生长参数,在610℃和在80sccm的NH₃流量下生长出了〈1120〉单一取向的ZnO薄膜。经Hall电阻率测量,得知该薄膜呈现弱p型或高电阻率,并对其光电子能谱进行了研究。     

3,7-二硝基亚氨基-2,4-二氮杂双环[3,3,0]辛烷的放热分解反应动力学

在程序升温条件下 ,用DSC研究了标题化合物的放热分解反应动力学 .用线性最小二乘法、迭代法以及二分法与最小二乘法相结合的方法 ,以积分方程、微分方程和放热速率方程拟合DSC数据 .在逻辑选择建立了微分和积分机理函数的最可几一般表达式后 ,用放热速率方程得到相应的表观活化能 (Ea)、指前因子 (A)和反应级数 (n)的值 .结果表明 :该反应的微分形式的经验动力学模式函数、Ea 和A值分别为 (1-α) 0 .44、2 30 .4kJ/mol和 10 18.16s-1.借助加热速率和所得动力学参数值 ,提出了标题化合物放热分解反应的动力学方程 .该化合物的热爆炸临界温度为 30 2 .6℃ .上述动力学参数对分析、评价标题化合物的稳定性和热变化规律十分有用 .