Stabilisation of ultra-high molecular weight polyethylene with Vitamin E

Ultra-high molecular weight polyethylene (UHMWPE) has been the material of choice for load-bearing articular components used in total joint arthroplasty in the past 30 years. However, the durability of the whole implant has often been compromised by oxidation of UHMWPE components. Since the use of a suitable, biocompatible stabilizer would minimize this inconvenience, the possibility of adding synthetic Vitamin E to medical grade UHMWPE is currently under investigation.In the present work, medical grade UHMWPE was blended with 0.05, 0.1 or 0.5 w/w% of α-tocopherol and consolidated by compression moulding. Small blocks of reference UHMWPE and of each blend were then gamma irradiated to 30 or 100 kGy. FTIR spectroscopy was used to monitor changes in both the polymer and the additive. Thin sections of virgin and α-tocopherol doped UHMWPE irradiated and unirradiated were aged in a ventilated oven at 90 °C and the kinetic of oxidation was followed by FTIR. In addition, CL-imaging curves were recorded at 180 °C on both irradiated and unirradiated samples.Phenol loss is observed in all the α-tocopherol doped samples upon irradiation. Hypotheses on the rearrangements of the additive structure include the formation of quinonoid products. Nevertheless, all the additive-containing samples exhibit better oxidation resistance compared to the virgin material, indicating stabilizing activity of the α-tocopherol derivatives.     

微波辐射下LaNaY沸石的水热交换反应

报道微波辐射应用于ＮａＹ沸石与Ｌａ（ＮＯ＿３）＿３溶液的离子交换反应，结果表明微波辐射可提高Ｌａ￣＋的交换度，缩短交换时间。     

The mechanism of nitrite formation in the radiation-induced oxidation of ammonia in aerated aqueous solutions

The mechanism of the radiation-induced conversion of ammonia to nitrites and nitrates in aerated aqueous solutions has been studied. The formation of the pernitrite ion, O=N-O-O^–, was detected at pH 10.5. The kinetics of its formation and decay were studied, andk _form was estimated at (2.3±0.2)·10⁷ L mol^–1 s^–1. The course of decay obeys first-order kinetics; the rate constant decreases at higher pH. Radiochemical yields of pernitrite, nitrite and nitrate at various pH and initial NH₃ concentrations were determined. A mechanism of ammonia oxidation in aqueous solution is proposed.Translated fromIzyestiya Akademii Nauk. Seriya Khimicheskaya, No. 2, pp. 280–283, February, 1993.     

Radiation formation of polymeric nanogels

An alternative method of synthesis of polymeric nanogels is proposed, based not on polymerization, but on intramolecular crosslinking of polymer chains, initiated by pulse irradiation in dilute aqueous solutions. Kinetic data show that for many water-soluble polymers irradiation under these conditions result in intramolecular crosslinking. Preliminary product studies on poly(vinyl alcohol) indicate that in fact internally crosslinked macromolecules can be obtained by this technique.     

Synthesis and spectroscopic analysis of tetraphenylporphyrinatoantimony(V) complexes linked to boron-dipyrrin chromophore on axial ligands

Tetraphenylporphyrinatoantimony(V) complexes, linked to boron-dipyrrin chromophores on axial ligands, were synthesized. The fluorescence spectra of 1a, 1b and 1c (3-[4-(N,N′-difluorobornyl-5-dipyrrinyl)phenyl]propoxo(methoxo)antimony(V) tetraphenylporphyrin bromide (1a); 6-[4-(N,N′-difluorobornyl-5-dipyrrinyl)phenyl]hexyloxo(methoxo)antimony(V) tetraphenylporphyrin bromide (1b); bis{3-[4-(N,N′-difluorobornyl-5-dipyrrinyl)phenyl]propoxo}antimony(V) tetraphenylporphyrin bromide (1c)) were analyzed under the excitations of N,N′-difluorobornyl-5-dipyrrinylphenyl (Bdpy) and tetraphenylporphyrinatoantimony(V) (Sb(TPP)) chromophores. Under the irradiation of Bdpy chromophore, the excitation energy was transferred from Bdpy chromophore to the Sb(TPP) moiety at 0.13–0.40 of the quantum yields, even in a polar solvent. On the other hand, the emission of Sb(TPP) chromophores was quenched by Bdpy chromophores at rate constants of 10⁸–10⁹ s⁻¹, independent of on the solvent polarity. Under the excitation of the Bdpy chromophore of 1d (3-[4-(N,N′-difluorobornyl-5-dipyrrinyl)phenyl]propoxo(phenyloxo)antimony(V) tetraphenylporphyrin bromide) involving both the Bdpy and the phenoxy chromophores on the axial ligands, the excited singlet state of the Sb(TPP) chromophore generated by the energy transfer from the Bdpy chromophore was quenched by the phenoxy ligand via non-radiative processes involving electron transfer. However, rapid back electron-transfer may occur because no absorption of the anion radical of Sb(TPP) was observed by nanosecond laser photolysis.     

Synthesis and polymerization of coupled compounds of 1,11-dodecadiyne

The dimer, trimer, and tetramer of 1,11-dodecadiyne, HC?C? (CH₂)₈? C?CH, were synthesized. The solid-state polymerization of the dimer was investigated by infrared (IR) spectroscopy. IR bands due to the diacetylene moiety were identified through the comparison of the IR spectra of the dimer, trimer, and tetramer. The dimer was found to have two polymorphs, melt-crystallized and solution-crystallized. Both of the polymorphs undergo solid-state polymerization by exposure to γ-ray or UV irradiation. The former has higher polymerizability for the diacetylene moiety than the latter. The solid-state polymerization of the terminal acetylene group was not observed. It is shown that the previously reported dimer structure in which both the diacetylene and terminal acetylene groups are polymerized to form an inherently electrically conducting polymer is incorrect. © 1995 John Wiley & Sons, Inc.     

Thermal degradation behavior of radiation synthesized polydiallyldimethylammonium chloride

Thermogravimetric analysis (TGA) and differential scanning calorimetric (DSC) studies were carried out on gamma radiation synthesized polydiallyldimethylammonium chloride (PDADMAC). The polymer was found to undergo thermal degradation in two stages. The first stage showed a weight loss of 33% and the second stage showed a weight loss of 67%. The DSC thermogram shows two endothermic peaks corresponding to the two stages in the TG thermogram and the experimental enthalpy change associated with the first and second stages were 650 J g⁻¹ and 129.5 J g⁻¹, respectively. The nth-order kinetic parameters (order of the reaction, activation energy and the pre-exponential factor) were determined from a single dynamic DSC or thermogravimetric (TG) thermogram by the method of least square. Theoretical TG/differential thermogravimetric (DTG) and DSC thermograms derived from the calculated kinetic parameters were in good agreement with the experimental ones at the heating rate employed. However, the kinetic parameters determined using TG and DSC were different. This leads to the conclusion that the degradation mechanism could be complicated and may consists of a number of parallel or consecutive reactions. The glass transition temperature (T_g) of the polymer was found to be around 150 °C depending on the test method employed.     

Analysis of low Z elements on Si wafer surfaces with synchrotron radiation induced total reflection X-ray fluorescence at SSRL, Beamline 3-3: comparison of droplets with spin coated wafers

The unique properties of synchrotron radiation, such as high incident flux combined with low divergence, its linear polarization and energy tunability, make it an ideal excitation source for total reflection X-ray fluorescence (TXRF) spectroscopy in order to non-destructively detect trace impurities of transition metals on Si wafer surfaces. When used with a detector suitable for the determination of low energy radiation this technique can be extended to the detection of low-Z elements, such as Al, Na and Mg. Experiments have been performed at SSRL Beamline 3-3, a bending magnet beamline using monochromatic radiation from a double multilayer monochromator. The wafer was mounted vertically in front of the detector, which was aligned along the linear polarization vector of the incoming synchrotron radiation. This configuration allows the detector to accept a large solid angle as well as to take advantage of the reduced scattered X-ray intensity emitted in the direction of the linear polarization vector. A comparison between droplet samples and spin coated samples was done, in order to compare the capabilities of vapor phase decomposition (VPD-TXRF) with conventional SR-straight-TXRF. Detection limits in the range of 50 fg corresponding to 2E10 atoms/cm² have been obtained for Na. The spin coated samples, prepared from solutions containing an equal amount of Na, Mg and Al showed an unexpected result when performing a scan of the angle of incidence of the incoming X-rays suggesting a different adsorption behavior of the elements in a multielement solution on the wafer surface. The observation of this behavior is important because the spin coating technique is the standard method for the preparation of surface standards in semiconductor quality control. This effect could be characteristic of the Na, Mg, Al solution used, but the angle dependence of the fluorescence signal of a standard should always be investigated before using the standard for calibration of the apparatus and quantification.     

ToF‐SIMS observation of PTFE surfaces modified by α‐particle irradiation

The surface structure of polytetrafluoroethylene (PTFE) upon α‐particle irradiation has been investigated at doses in the range of 1 × 10⁷ to 1 × 10¹¹ Rad and compared with the surface structure of the unirradiated polymer. Both neat and 25% fiberglass content PTFE were studied. The samples, maintained at nominal room temperature, were irradiated in vacuum by 5.5 MeV ⁴He²⁺ ions generated in a tandem accelerator beam line. Static time‐of‐flight SIMS (ToF‐SIMS) was employed to probe chemical changes at the surface as a function of the irradiation level. In general, the data are indicative of increased cross‐linking at α‐doses less than 1 × 10⁹ Rad, followed by increased fragmentation and unsaturation at α‐doses greater than 1 × 10⁹ Rad. Throughout the irradiation regime, scission is a constant factor promoting cross‐linking, branching, and unsaturation. However, at α‐doses greater than 1 × 10¹⁰ Rad, extreme structural degradation of the polymer becomes evident and is accompanied by conversion to oxygen‐functionalized and aliphatic compounds. Thus, for PTFE in an α‐particle field, an upper exposure limit of ～10¹⁰ Rad is essential for nominal retention of molecular structure. Finally, a quantitative relationship between α‐dose and characteristic fragment ion intensity is developed. Copyright © 2005 John Wiley & Sons, Ltd.     

遗传算法优化变分模态分解提取舰船辐射噪声特征线谱方法

特征线谱提取是舰船目标识别的一个重要研究环节,常采用传统的DEMON谱分析方法,处理过程中,一般对舰船噪声时域信号未予抑噪,低信噪比情况下,传统DEMON谱分析性能差。对此,提出一种采用遗传算法优化变分模态分解方法,用于分解舰船噪声原时域信号,获得抑制噪声后的舰船噪声重构信号,进而有效提取了舰船目标噪声幅度调制特征线谱。该方法首先采用遗传算法优化变分模态分解的两个关键输入参数(分解所取模态个数和惩罚因子),对变分模态分解得到的各阶固有模态分量加以判别,去除噪声主导分量,保留信号主导分量,使重构舰船噪声信号显著抑制了干扰噪声,然后对降噪后的重构信号进行频谱分析,获得目标噪声调制特征线谱。理论分析、仿真和实验数据处理结果表明,相比传统DEMON谱分析法,基于遗传算法优化变分模态分解的舰船噪声特征线谱提取方法具有更好的噪声抑制能力,所获取的舰船噪声幅度调制特征线谱信噪比明显高于传统DEMON方法,具有一定优势,前景良好。