Photolytic oxidation of As species for determination of total As (including the ‘hidden’ As fraction) in coastal seawater by hydride generation-atomic fluorescence spectrometry

Ultraviolet irradiation (photolysis) in alkaline medium was applied for pretreatment of seawater samples so as to accurately determine total As by continuous-flow hydride generation-atomic fluorescence spectrometry. This sample pretreatment is meant to convert non-reducible As forms into inorganic As, which easily forms arsine. The optimised parameters were the treatment time and the pH of the medium. The behaviour of four hydride-reactive As species [As(III), As(V), MMA, DMA], and AsB, i.e. a typical non-hydride-reactive As species, when subjected to UV irradiation was studied. UV irradiation at pH 1 lead to conversion of all species into As(V) with the exception of AsB and DMA. Conversions of DMA and AsB into As(V) at pH 11 in less than 30 min were observed under UV irradiation. The limit of detection of As (measured as As(V)) by hydride generation-atomic fluorescence spectrometry was 0.1 μg/L and the repeatability of the oxidation procedure was about 10%. The method was applied to determination of total and directly reducible As at 11 sampling points of the Galician Coast (Atlantic Ocean, Spain). Total As concentrations were in the range 1.4-4.8 μg/L. A significant As fraction, between 20 and 44%, depending on the sampling point, corresponded to non-reducible As which was converted by UV irradiation into hydride-reactive As. This fraction should represent the sum of DMA, which yields a low sensitivity in the continuous flow-AFS system, and the hidden As fraction.     

PREPARATION AND CHARACTERIZATION OF SHISH-KEBAB TYPE LIQUID CRYSTALLINE POLY（p-PHENYLENEVINYLENE）

Novel shish-kebab type liquid crystalline poly（p-phenylenevinylene） derivatives were synthesized by Stille coupling reaction from 2,5-bis[（4-n-alkoxyl）benzoyloxy]1,4-dibromobenzene （monomer l） and 1,2-bis（tributylstannyl） ethylene （monomer 2）. The polymers with alkoxy groups are soluble in common organic solvents and exhibit blue fluorescence. Both the cast film and the annealed film have large red-shifts in fluorescence spectra and show yellow fluorescence. The polymers with CN and NO2 groups show poor solubility and green fluorescence. All the polymers possess liquid crystalline smectic phases. The melting point （Tm） of the polymers decreases when the length of the alkoxy tails of the mesogenic units increases. The polymers are easily aligned under a magnetic field of 10 Tesla. It is found that the conjugated backbone and LC side chain are aligned perpendicular and parallel to the magnetic field, respectively. The polymers show optical dichroism in fluorescence spectra, suggesting that they are available for advance materials with linear optical polarization.     

Synthesis and fluorescent properties of some new unsymmetricbis-benzothiazolyl furans and thiophenes

Summary Some newmono- andbis-benzothiazolyl compounds with furan or thiophene nuclei were synthesized by multistep reactions from the corresponding furan and thiophene aldehydes. The data obtained from emission spectra show a large influence of the benzothiazole rings on the relative quantum efficiency of the compounds under investigation.

---

Synthese und Fluoreszenzeigenschaften von neuen unsymmetrischenbis-Benzothiazolylfuranen und thiophenen

Zusammenfassung Einige neuebis-Benzothiazolylverbindungen mit einem Furan- bzw. Thiophenenring wurden in einer mehrstufigen Reaktion dargestellt. Die Fluoreszenzdaten der untersuchten Verbindungen zeigen einen großen Einfluß der Benzothiazolringe auf die relative Fluoreszenzquantenausbeute.

     

Hydrogen peroxide in basic media for whole blood sample dissolution for determination of its lead content by electrothermal atomization atomic absorption spectrometry

Hydrogen peroxide in basic media is proposed as a means for dissolving whole blood samples to be analyzed by electrothermal atomization atomic absorption spectrometry, ET AAS. Approximately 2 g of the whole blood sample were directly weighed in a 150 mL volumetric flask; 3 mL of a NaOH 0.2 mol L⁻¹ solution, two drops of 1-octanol, as an antifoaming agent, and 1 mL of 30% volume hydrogen peroxide were added to the flask to promote oxidation. The solution was then manually shaken and after approximately three minutes of shaking, a clear solution, with no apparent suspended solids or greasy layers, was obtained. Distilled-deionized water was used to complete the volume. Ten μL of the resulting solution along with 10 μL of a solution containing 5000 mg L⁻¹ of NH₄H₂PO₄ and 300 mg L⁻¹ of Mg(NO₃)₂ as a modifier, were injected into transversely heated graphite tubes for lead determination. Both aqueous standards and standard addition calibration curves produced results not significantly different at a 95% confidence limit level. Accuracy of the measurements was assessed by analysis of the IAEA A-13 (concentration of trace and minor elements in freeze dried animal blood) standard reference material containing 0.18 mg L⁻¹ lead on a dry basis and by means of recovery tests. Analysis of the IAEA A-13 standard produced 0.17 ± 0.02 mg L⁻¹ lead on a dry basis; recovery tests afforded values from 95 to 105%. Ten consecutive measurements of a 5 ppb lead solution gave a characteristic mass of 47.2 pg and a (3S) detection limit of 1.77 μg L⁻¹ Pb. Results obtained from analysis of whole blood samples of volunteer donors covered a lead concentration range between 8 and 21 μg L⁻¹ with a mean value of 11.9 ± 4.7 μg L⁻¹.     

Hydride generation atomic fluorescence spectrometric determination of As, Bi, Sb, Se(IV) and Te(IV) in aqua regia extracts from atmospheric particulate matter using multivariate optimization

A highly sensitive and simple method, based on hydride generation and atomic fluorescence detection, has been developed for the determination of As, Bi, Sb, Se(IV) and Te(IV) in aqua regia extracts from atmospheric particulate matter samples. Atmospheric particulates matter was collected on glass fiber filters using a medium volume sampler (PM1 particulate matter). Two-level factorial designs have been used to optimise the hydride generation atomic fluorescence spectrometry (HG-AFS) procedure. The effects of several parameters affecting the hydride generation efficiency (hydrochloric acid, sodium tetrahydroborate and potassium iodide concentrations and flow rates) have been evaluated using a Plackett-Burman experimental design. In addition, parameters affecting the hydride measurement (delay, analysis and memory times) have been also investigated. The significant parameters obtained (sodium tetrahydroborate concentration, sodium tetrahydroborate flow rate and analysis time for As; hydrochloric acid concentration and sodium tetrahydroborate flow rate for Se(IV); and sodium tetrahydroborate concentration and sodium tetrahydroborate flow rate for Te(IV)) have been optimized by using 2ⁿ + star central composite design. Hydrochloric acid concentration and sodium tetrahydroborate flow rate were the significant parameters obtained for Sb and Bi determination, respectively. Using a univariate approach these parameters were optimized. The accuracy of methods have been verified by using several certified reference materials: SRM 1648 (urban particulate matter) and SRM 1649a (urban dust). Detection limits in the range of 6 × 10⁻³ to 0.2 ng m⁻³ have been achieved. The developed methods were applied to several atmospheric particulate matter samples corresponding to A Coruña city (NW Spain).     

Selective spectrofluorimetric method for paracetamol determination through coumarinic compound formation

A spectrofluorimetrical selective method was designed for determination of paracetamol in tablets. This important technique can be characterized by its sensitivity, simplicity, celerity and cheaper cost than current official methods. The employed methodology involves coumarinic compound formation obtained by reaction between paracetamol and ethylacetoacetate (EAA) in the presence of sulphuric acid as catalyst. The reaction product is highly fluorescent at 478 nm, being excited at 446 nm.The linear concentration range of the application was 0.1-0.4 μg/ml of paracetamol and the detection limit was 57 ng/ml.The influence of different variables was studied and optimized through chemometric techniques. Applying the above-mentioned method good results were obtained with regard to pharmaceutical formulations containing paracetamol. Therefore, it is relevant to suggest this profitable technique for medicament control analysis.     

聚酯聚醚嵌段共聚物与1,4-二咔唑环丁烷在激发态及基态的相互作用

<正> 聚酯聚醚嵌段共聚物具有十分良好的物理和机械性能,能加工成橡胶、纤维、塑料胶粘剂等,近年来也有作为医用高分子材料的报道。所以对聚酯聚醚嵌段共聚物的研究十分活跃。然而,有关其光物理性质的研究还很少见。本文报道了混合聚醚-聚酯嵌段共聚物(MPEE)与反式1,4-二咔唑环丁烷(1,4-DCC)在激发态和基态下的相互络合作用。结果表明,MPEE可以猝灭1,4-DCC的荧光,同时形成激基复合物。在分散     

Single-molecule fluorescence detection in microfluidic channels—the Holy Grail in μTAS?

Both single-molecule detection (SMD) methods and miniaturization technologies have developed very rapidly over the last ten years. By merging these two techniques, it may be possible to achieve the optimal requirements for the analysis and manipulation of samples on a single molecule scale. While miniaturized structures and channels provide the interface required to handle small particles and molecules, SMD permits the discovery, localization, counting and identification of compounds. Widespread applications, across various bioscience/analytical science fields, such as DNA-analysis, cytometry and drug screening, are envisaged. In this review, the unique benefits of single fluorescent molecule detection in microfluidic channels are presented. Recent and possible future applications are discussed.Dedicated to the memory of Wilhelm Fresenius     

Oligonucleotides containing new fluorescent 1-phenylethynylpyrene and 9,10-bis(phenylethynyl)anthracene uridine-2′-carbamates: synthesis and properties

The synthesis of two novel fluorescent uridine-2′-carbamate phosphoramidites is described. The reagents carrying fluorescent polyaromatic hydrocarbons 1-phenylethynylpyrene (PEPy) or 9,10-bis(phenylethynyl)anthracene (BPEA) are suitable for oligonucleotide synthesis. Prepared oligonucleotide conjugates show strong dye emissions at 401 and 485 nm, but low FRET rate when located in the oligonucleotide duplex. The dyes show considerable compensation of the usual carbamate duplex destabilization. The possible explanation of both effects is binding of PEPy and BPEA to the minor groove of the DNA duplex.