Multilayer optics for XUV spectral region: technology fabrication and applications

We present research investigations in the field of multilayer optics in X-ray and extreme ultra-violet ranges (XUV), aimed at the development of optical elements for applications in experiments in physics and in scientific instrumentation. We discuss normal incidence multilayer optics in the spectral region of “water window”, multilayer optics for collimation and focusing of hard X-ray, multilayer dispersing elements for X-ray spectroscopy of high-temperature plasma, multilayer dispersing elements for analysis of low Z-elements. Our research pays special attention to optimization of multilayer optics for projection EUV-lithography (ψ-13nm) and short period multilayer optics.     

Solid phase extraction for analysis of biogenic carbonates by electrothermal vaporization inductively coupled plasma mass spectrometry (ETV-ICP-MS): an investigation of rare earth element signatures in otolith microchemistry

Uptake of trace elements into fish otoliths is governed by several factors such as life histories and environment in addition to stock and species differences. In an attempt to elucidate the elemental signatures of rare earth elements (REEs) in otoliths, a solid phase extraction (SPE) protocol was used in combination with electrothermal vaporization (ETV) as a sample introduction procedure for the determinations by inductively coupled plasma quadrupole mass spectrometry (ICP-MS). Effects of various parameters, such as carrier gas flow rate, atomization temperature and chemical modification, were examined for optimization of the conditions by ETV-ICP-MS. Atomization was achieved at 2800 °C. Lower temperatures (i.e. 2600 °C) resulted in severe memory problems due to incomplete atomization. Palladium was used as a chemical modifier. It was found that an increase in Pd concentration up to 0.5 μg in the injection volume (70 μl) led up to four-fold enhancement in the integrated signals. This phenomenon is attributed to the carrier effect of Pd rather than the stabilization since no significant losses were observed for high temperature drying around 700 °C even in the absence of Pd. Preconcentration was performed on-line at pH 5 by using a mini-column of Toyopearl AF-Chelate 650M chelating resin, which also eliminated the calcium matrix of otolith solutions. After preconcentration of 6.4 ml of solution, the concentrate was collected in 0.65 ml of 0.5% (v/v) HNO₃ in autosampler cups, and then analyzed by ETV-ICP-MS. The method was validated with the analysis of a fish otolith certified reference material (CRM) of emperor snapper, and then applied to samples. Results obtained from otoliths of fish captured in the same habitat indicated that otolith rare earth element concentrations are more dependent on environmental conditions of the habitat than on species differences.     

Fe/Si多层膜的层间耦合与界面扩散

对以本征Si及重掺杂ｐ型和ｎ型Si作为中间层的Fe/Si多层膜的层间耦合进行研究，并通过退火，增大Fe，Si之间的扩散，分析界面扩散对层间耦合的影响. 实验结果表明，层状结构良好的制备态的多层膜，Fe，Si之间也存在一定程度的扩散，它是影响层间耦合的 主要因素，远远超过了半导体意义上的重掺杂，使不同种类的Si作为中间层的层间耦合基本 一致.进一步还发现，在一定范围内增大Fe，Si之间的扩散，即使多层膜的层状结构已经有了相当的退化，Fe/Si多层膜的反铁磁耦合强度基本保持不变. 关键词： Fe/Si多层膜 层间耦合 界面扩散     

Application of Pulsed Traveling Hydrogen Arcs for Metal Oxide Reduction

A plasma reactor that has a transient traveling arc has been used to study hydrogen in relation to in-flight reduction of metal oxide particles. Experiments were done to determine the nature of the arc and its interaction with the reactor gas. The lifetime of the excited atomic hydrogen was measured and it was found to be more than 4 ms after the arc had ceased. Powders and tablets of oxides were exposed to the pulsed-arc treated hydrogen and found to react much more rapidly and intensely than when exposed to hot molecular hydrogen. The results suggest that atomic hydrogen will exist throughout the volume of such a reactor for a period that is sufficient to reduce particles of FeO, Cr₂O₃, and TiO₂.     

Electrochemical characterization of poly(vinylidenefluoride)-zinc triflate gel polymer electrolyte and its application in solid-state zinc batteries

Gel polymer electrolyte (GPE) films comprising of poly(vinylidenefluoride), propylene carbonate, ethylene carbonate and zinc trifluoromethane sulfonate are prepared and characterized. The composition of GPE is optimized to contain minimum liquid components with a maximum specific conductivity of 3.94×10⁻³ S cm⁻¹ at (25±1) °C. A detailed investigation on the properties such as ionic conductivity, transport number, electrochemical stability window, reversibility of Zn/Zn²⁺ couple and Zn/gel electrolyte interfacial stability have been carried out. The ionic conductivity follows a VTF behaviour with an activation energy of about 0.0014 eV. Cationic transport number varies from 0.51 at 25 °C to 0.18 at 70 °C. Several cells have been assembled with GPE as the electrolyte, zinc as the anode, γ-MnO₂ as the cathode and their charge–discharge behaviour followed. Capacity values of 105, 82, 64 and 37 mAh/g of MnO₂ have been achieved at 10, 50, 100 and 200 μA/cm² discharge current densities, respectively. The discharge capacity values are almost constant for about 55 cycles for all values of current densities. Cyclic voltammetric study of MnO₂ electrode in Zn/GPE/MnO₂ cell clearly shows intercalation/deintercalation of Zn²⁺.     

二氧化碳和丙烯直接合成甲基丙烯酸的NiPMo/TiO2催化剂的研究

用溶胶 凝胶法以磷钼酸 (MPA)的镍盐溶液水解钛酸四丁酯制备了NiPMo/TiO2 催化剂 .使用ICP、XRD、TG DTA、IR、TPD MS和微反应技术研究了催化剂的化学组成、热稳定性、化学吸附性质和催化反应性能 .杂多钼酸盐与TiO2 通过O2 -在TiO2 表面发生了键合 .在 6 2 3K下 ,杂多阴离子仍保持原有的Keggin结构 .CO2 在Lewis酸位Ni(Ⅱ )和Lewis碱位Ni-O -Mo的桥氧协同作用下生成CO2 卧式吸附态Ni(Ⅱ )←O - (CO)← (O--Ni) .丙烯有多种吸附态在催化剂上吸附 .在 5 6 3K、1MPa和空速 15 0 0h-1的反应条件下 ,丙烯的摩尔转化率为 3.2 % ,产物MAA选择性为 95 % .     

Spectrophotometric Study of Luminol in Dimethyl Sulfoxide–Potassium Hydroxide

The spectrophotometric study of luminol (LH₂) in dimethyl sulfoxide (DMSO), DMSO-water solutions, and alkaline DMSO and DMSO-water solutions has been done, focusing on the effect of the KOH additon on LH₂ absorption and fluorescence properties. The absorption spectra indicate an acid-base equilibrium, and the luminol dianion (L^2–) formation at 3 × 10^–4 – 2.4 × 10^–3 M KOH. The decrease of the fluorescence intensity and the variation of the excitation spectra of LH₂-DMSO-KOH solutions with KOH concentration have been similarly explained. The acid-base process is reversible. The addition of HCl to the solution with 3.0 × 10^–3 M KOH leads to an increase of the fluorescence intensity to its highest value, observed in pure DMSO. The addition of HCl to the LH₂-DMSO solution leads to the decrease of the fluorescence intensity as a result of the LH⁺ ₃ cation formation. In LH₂-DMSO-water, the fluorescence band is shifted from 405 nm to 424 nm and increased in the intensity. In the presence of KOH (in LH₂-DMSO-water-KOH solution) a new band appears, with the maximum at 485 nm and the band at 405 nm decreased. The changes in fluorescence lifetimes also evidence the different chemical species formed.     

Total synthesis of (±) maculalactone A, maculalactone B and maculalactone C and the determination of the absolute configuration of natural (+) maculalactone A by asymmetric synthesis

Maculalactones A, B and C from the marine cyanobacterium Kyrtuthrix maculans are amongst the only compounds based on the tribenzylbutyrolactone skeleton known in nature and (+) maculalactone A from the natural source possesses significant biological activity against various marine herbivores and marine settlers. We now report a concise synthesis of racemic maculalactone A in five steps from inexpensive starting materials. Maculalactones B and C were synthesized by a minor modification to this procedure, and the synthetic design also permitted an asymmetric synthesis of maculalactone A to be achieved in around 85% ee. The (+) and (−) enantiomers of maculalactone A were assigned, respectively, to the S and R configurations on the basis of the chiral selectivity expected for catecholborane reduction of an unsymmetrical ketone in the presence of Corey's oxazoborolidine catalyst. Surprisingly, it appeared that natural (+) maculalactone A was biosynthesized in K. maculans in a partially racemic form, comprising ca. 90-95% of the (S) enantiomer and 5-10% of its (R) enantiomer. Coincidentally therefore, the percentage enantiomeric excess of the product obtained from asymmetric synthesis almost exactly matched that found in nature.