Weak solutions for a hyperbolic system with unilateral constraint and mass loss

We consider isentropic gas dynamics equations with unilateral constraint on the density and mass loss. The γ and pressureless pressure laws are considered. We propose an entropy weak formulation of the system that incorporates the constraint and Lagrange multiplier, for which we prove weak stability and existence of solutions. The nonzero pressure model is approximated by a kinetic BGK relaxation model, while the pressureless model is approximated by a sticky-blocks dynamics with mass loss.     

负关联噪声驱动下单模激光的定态分析

研究了负关联的加法和乘法高斯白噪声驱动下单模激光损失模型的定态情况。文中推导了负关联情况下，定态时的激光场幅的几率分布，光强的平均值，光强的协方差以及光强的偏斜率。并和文献〔１，２〕中正关联时的定态分析作了比较，发现了有意义的新现象。     

线圈型全光纤偏振器的研究

本文采用等效电流法对线圈型全光纤偏振器进行了分析计算.对应于保偏光纤中两正交传输基模的消光比,提出了一种分析保偏光纤弯曲损耗的新方法,这种方法基于将保偏光纤两个不同偏振模式分别等效为两个普通圆光纤的基模,等效参数通过测量不同偏振模式的模场半径来确定.实验证明这种理论计算方法与实验结果一致.最终,我们研制出的线圈型光纤偏振器在1.31μm工作波长下,实测消光比达30dB以上,工作偏振模式插入损耗≤3dB.     

On sequential procedures for the point estimation of the mean of a normal population

The sequential procedures developed by Starr (1966, Ann. Math. Statist., 37, 1173–1185) for estimating the mean of a normal population are further analyzed. Asymptotic properties of the regret and first two moments of the stopping rules are studied and second-order approximations are derived.     

Concentration and clean-up of trace hydrocarbons from atmospheric particulate matter

Summary The aim of this work is to establish the best conditions for concentration and purification steps in the trace analysis of aliphatic and polycyclic aromatic hydrocarbons (PAH) from atmospheric particulate matter by gas chromatography-flame ionisation detection (GC-FID) and high performance liquid chromatography with ultraviolet and fluorescence detection (HPLC-UV-FL). The best results for the more volatile compound were obtained with a combination of rotary evaporation and a stream of nitrogen (near to 100% for aliphatic hydrocarbons and from 70 to 105% for PAH). Two types of solid phase extraction (SPE)cartridges (Supelclean ^tm LC-Silica SPE tubes and Sep-Pak^? Plus silica cartridges) and glass column were examined for the purification and fractionation step. Blank chromatograms of both types of cartridges analysed by GC-FID made this study difficult, because a PSS (programmed split-splitless) injector was employed thereby increasing the sensitivity. This problem was not observed in the HPLC-UV-FL blank chromatograms of these cartridges. Glass columns filled with silica and alumina were chosen because no interference was found in the GC-FID blank chromatograms and the best recoveries in the fractionation of both aliphatic hydrocarbons and PAH were achieved. This is especially important when aliphatic hydrocarbons concentrations are lower than 1 μg mL⁻¹. Finally, the selected conditions were applied to the analysis of hydrocarbons in real atmospheric particulate samples.     

Case for projectile kinetic energy gain in stopping power studies

Under certain collision conditions, a swift ion projectile colliding with a target will gain rather than lose kinetic energy, contrary to the standard conception of stopping power. In this work, we consider the conditions for such a collision such that the energy loss is negative, that is, that there will be projectile kinetic energy gain. In particular, for a target initially in the ground state we find that the projectile gains kinetic energy only when charge exchange and de‐excitation processes are involved. This occurs when the electron affinity of the projectile is larger than the ionization potential of the target. Consequences of this effect are analyzed. © 2003 Wiley Periodicals, Inc. Int J Quantum Chem 94: 215–221, 2003     

纳米Zn-Co铁氧体的固相合成及电磁损耗特性研究

采用NH₄HCO₃与FeCl₃·6H₂O，Zn(NO₃)₂·6H₂O，Co(NO₃)₂·6H₂O进行室温固相反应制得前驱物，经微波加热处理后，进而热分解分别制得复合氧化物ZnFe₂O₄、CoFe₂O₄和Co_0.5Zn_0.5Fe₂O₄。由激光粒度分析仪、XRD和SEM表征：获得了颗粒分布比较均一、平均粒度为65 nm左右、立方晶系尖晶石结构的纳米铁氧体粉体。经测试样品的相对介电常数和相对磁导率后，研究了它们的电磁损耗特性。结果表明：Co_0.5Zn_0.5Fe₂O₄在100～1 800 MHz内比另外两种铁氧体具有更好的电磁损耗特性。     

Rapid and sensitive liquid chromatography-tandem mass spectrometry for the quantitation of epirubicin and identification of metabolites in biological samples

A highly sensitive and selective liquid chromatography-mass spectrometry (LC-MS) method has been developed for the determination of epirubicin in serum and cell specimens using daunorubicin as an internal standard. Using atmospheric pressure chemical ionisation (APCI), the epirubicin metabolites were readily distinguishable by their fragmentation pattern in the mass spectrometer. Selected reaction monitoring (SRM) mode was employed for quantitation of epirubicin and the metabolites. Following extraction, chromatography was performed on a C18 column with a mobile phase consisting of water-acetonitrile-formic acid, pH 3.2, with a flow rate of 200 μl/min. The limit of detection (LOD) and the limit of quantitation (LOQ) of this method in serum were determined to be 1.0 and 2.5 ng/ml, respectively. Linearity of the method was verified over the concentration range of 2.5-2000 ng/ml, with a high correlation coefficient (R² ≥ 0.998). For the extraction procedure, an aliquot of 500 μl serum, spiked with internal standard, was extracted using a chloroform-2-isopropanol (2:1, v/v) mixture. The method has been applied to the analysis of epirubicin in cancer cell samples and the identification of known and unknown metabolites in clinical trial patient serum samples.     

Electron microscopic phase analysis of BN-thin films

A series of BN films was deposited by means of r.f. magnetron sputtering of a h-BN target onto Si(1OO) surfaces. Hereby, the substrate bias voltage was varied. Special interest is focussed to the influence of the deposition parameters on the orientation of the growing hexagonal BN film with respect to the substrate. For structural investigation, cross section samples were prepared. In addition to HRTEM and diffraction investigations, especially electron energy loss spectroscopy (EELS) was applied successfully for phase identification. For negative bias voltages of U _B =–300 V and U _B =–350V, we found a phase system consisting of a first-grown 25 nm thick layer of hexagonal structure with the c axis parallel to the substrate surface followed by the cubic phase.Dedicated to Professor Dr. rer. nat. Dr. h.c. Hubertus Nickel on the occasion of his 65th birthday     

Hydride generation atomic fluorescence spectrometric determination of As, Bi, Sb, Se(IV) and Te(IV) in aqua regia extracts from atmospheric particulate matter using multivariate optimization

A highly sensitive and simple method, based on hydride generation and atomic fluorescence detection, has been developed for the determination of As, Bi, Sb, Se(IV) and Te(IV) in aqua regia extracts from atmospheric particulate matter samples. Atmospheric particulates matter was collected on glass fiber filters using a medium volume sampler (PM1 particulate matter). Two-level factorial designs have been used to optimise the hydride generation atomic fluorescence spectrometry (HG-AFS) procedure. The effects of several parameters affecting the hydride generation efficiency (hydrochloric acid, sodium tetrahydroborate and potassium iodide concentrations and flow rates) have been evaluated using a Plackett-Burman experimental design. In addition, parameters affecting the hydride measurement (delay, analysis and memory times) have been also investigated. The significant parameters obtained (sodium tetrahydroborate concentration, sodium tetrahydroborate flow rate and analysis time for As; hydrochloric acid concentration and sodium tetrahydroborate flow rate for Se(IV); and sodium tetrahydroborate concentration and sodium tetrahydroborate flow rate for Te(IV)) have been optimized by using 2ⁿ + star central composite design. Hydrochloric acid concentration and sodium tetrahydroborate flow rate were the significant parameters obtained for Sb and Bi determination, respectively. Using a univariate approach these parameters were optimized. The accuracy of methods have been verified by using several certified reference materials: SRM 1648 (urban particulate matter) and SRM 1649a (urban dust). Detection limits in the range of 6 × 10⁻³ to 0.2 ng m⁻³ have been achieved. The developed methods were applied to several atmospheric particulate matter samples corresponding to A Coruña city (NW Spain).