内含式化合物X@B12P12的结构与稳定性研究

采用B3LYP/6-31G*方法，对内含式化合物X@B₁₂P₁₂(X=Li^0/+、Na^0/+、K^0/+、Be^0/2+、Mg^0/2+、Ca^0/2+、H和He)的不同对称性构型进行了计算，讨论其最稳定构型的几何参数、布居分析、偶极矩、电离势、包含能、振动频率、能隙和自旋密度． 发现在X@B₁₂P₁₂化合物中，客体X=Li、Na^0/+、K^0/+、Mg^0/2+、Ca^0/2+和He处在偏离笼的中心0.006 nm的半径内． Be²⁺沿着C₃轴偏离中心点0.279 nm． 在Be@B₁₂P₁₂和H@B₁₂P₁₂的基态结构中，Be和H与笼上的B原子成键． 除Li@B₁₂P₁₂、 Be²⁺@B₁₂P₁₂和He@ B₁₂P₁₂外， 其余结构为C_s对称稳定构型．     

Analysis of petroleum fractions by on-line micro HPLC-HRGC coupling,involving increased efficiency in using retention gaps by partially concurrent solvent evaporation

Two-dimensional chromatography of gasoline by on-line coupled HPLC-HRGC, as described in this paper, allows separate GC analysis of paraffins and aromatics. The GC system contains a retention gap of only 10 m length for introducing HPLC fractions of 100 μl volume. This becomes possible through evaporation of part of the solvent during introduction of the HPLC eluent. This “partially concurrent solvent evaporation” technique allows transfer of large volumes of HPLC eluent into relatively short retention gaps, maintaining the full efficiency of the solvent effects in reconcentrating the bands of the early eluted solutes.     

Optical and Electrical Properties of Polymerizing Plasmas and Their Correlation with DLC Film Properties

Diamond-like carbon (DLC) films were grown from radiofrequency plasmas of acetylene-argon mixtures, at different excitation powers, P. The effects of this parameter on the plasma potential, electron density, electron temperature, and plasma activity were investigated using a Langmuir probe. The mean electron temperature increased from about 0.5 to about 7.0 eV while the mean electron density decreased from about 1.2 × 10⁹ to about 0.2 × 10⁹ cm^–3 as P was increased from 25 to 150 W. Both the plasma potential and the plasma activity were found to increase with increasing P. Through actinometric optical emission spectrometry, the relative concentrations of CH, [CH], and H, [H], in the discharge were mapped as a function of the applied power. A rise in [H] and a fall in [CH] with increasing P were observed and are discussed in relation to the plasma characteristics and the subimplantation model. The optical properties of the films were calculated from ultraviolet-visible spectroscopic data; the surface resistivity was measured by the two-point probe method. The optical gap, E _G, and the surface resistivity, _s, fall with increasing P. E _G and _s are in the ranges of about 2.0–1.3 eV and 10¹⁴–10¹⁶ /, respectively. The plasma power also influences the film self-bias, V _b, via a linear dependence, and the effect of V _b on ion bombardment during growth is addressed together with variation in the relative densities of sp² and sp³ bonds in the films as determined by Raman spectroscopy.     

Photophysics of ruthenium(II) complexes with 2-(2′-pyridyl) pyrimidine and 2,2′-bipyridine ligands in fluid solution

The photophysics of three complexes of the form Ru(bpy)₃₋(pypm)²⁺ (where bpy2,2′-bipyridine, pypm 2-(2′-pyridyl)pyrimidine and P=1, 2 or 3) was examined in H₂O, propylene carbonate, CH₃CN and 4:1 (v/v) C₂H₅OH---CH₃OH; comparison was made with the well-known photophysical behavior of Ru(bpy)₃²⁺. The lifetimes of the luminescent metal-to-ligand charge transfer (MLCT) excited states were determined as a function of temperature (between −103 and 90 °C, depending on the solvent), from which were extracted the rate constants for radiative and non-radiative decay and ΔE, the energy gap between the MLCT and metal-centered (MC) excited states. The results indicate that ^*Ru(bpy)₂(pypm)²⁺ decays via a higher lying MLCT state, whereas ^*Ru(pypm)₃²⁺ and ^*Ru(pypm)₂(bpy)²⁺ decay predominantly via the MC state.     

Efficient organic photovoltaic cells based on thiazolothiazole and benzodithiophene copolymers with π‐conjugated bridges

New donor–π–acceptor (D–π–A) type conjugated copolymers, poly[(4,8‐bis((2‐hexyldecyl)oxy)benzo[1,2‐b:4,5‐b′]dithiophene)‐alt‐(2,5‐bis(4‐octylthiophen‐2‐yl)thiazolo[5,4‐d]thiazole)] (PBDT‐tTz), and poly[(4,8‐bis((2‐hexyldecyl)oxy)benzo[1,2‐b:4,5‐b′]dithiophene)‐alt‐(2,5‐bis(6‐octylthieno[3,2‐b]thiophen‐2‐yl)thiazolo[5,4‐d]thiazole)] (PBDT‐ttTz) were synthesized and characterized with the aim of investigating their potential applicability to organic photovoltaic active materials. While copolymer PBDT‐tTz showed a zigzagged non‐linear structure by thiophene π‐bridges, PBDT‐ttTz had a linear molecular structure with thieno[3,2‐b]thiophene π‐bridges. The optical, electrochemical, morphological, and photovoltaic properties of PBDT‐tTz and PBDT‐ttTz were systematically investigated. Furthermore, bulk heterojunction photovoltaic devices were fabricated by using the synthesized polymers as p‐type donors and [6,6]‐phenyl‐C₇₁‐butyric acid methyl ester as an n‐type acceptor. PBDT‐ttTz showed a high power conversion efficiency (PCE) of 5.21% as a result of the extended conjugation arising from the thienothiophene π‐bridges and enhanced molecular ordering in the film state, while PBDT‐tTz showed a relatively lower PCE of 2.92% under AM 1.5 G illumination (100 mW/cm²). © 2018 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2018 , 56, 1978–1988     

Improved estimation of duality gap in binary quadratic programming using a weighted distance measure

We present in this paper an improved estimation of duality gap between binary quadratic program and its Lagrangian dual. More specifically, we obtain this improved estimation using a weighted distance measure between the binary set and certain affine subspace. We show that the optimal weights can be computed by solving a semidefinite programming problem. We further establish a necessary and sufficient condition under which the weighted distance measure gives a strictly tighter estimation of the duality gap than the existing estimations.     

Photosensitivity,substituent and solvent-induced shifts in UV-visible absorption bands of naphthyl-ester liquid crystals: a comparative theoretical approach

The substituent- and solvent-induced shifts in UV-visible absorption bands of naphthyl-ester nematic liquid crystals, viz., 4-octylphenyl-6-octyloxy-2-naphthoate (NAPHE1) and 6-octyloxy-2-naphthylyl-4-octyloxybenzoate (NAPHE2), have been investigated using the DFT, CNDO/S and INDO/S methods. A correlation has been made between molecular charge distribution and phase stability based on Mulliken, Loewdin, AM1, PM3, MNDO, CNDO/S and INDO/S methods. The observed π→π* and n→π* electronic transitions have been reported. The substituent- and solvent-induced shifts in absorption bands, transition energies and energy gaps have been discussed. The photosensitivity of the molecules has been analysed based on these shifts. It has been observed that the substituent has a dominant role on both absorption maxima and energy band gap, whereas the solvent has a dominant role only on absorption maxima, and no effect has been observed on the energy gap. These shifts may provide beneficial consequences in determining the end use of compounds.     

一种高稳定性光纤F-P标准具的设计

法布里-珀罗(F-P)标准具广泛应用于光纤通信与光纤传感领域。实心标准具受自身材料的限制,无法满足高稳定性的要求。空气隙标准具采用热膨胀系数极低的垫片,提高了器件的温度稳定性能。介绍了低温漂光纤F-P标准具的设计和制作,出射光自由光谱范围为100GHz,损耗为3dB,0~70℃温度漂移小于3GHz。相比于采用传统方法制作的标准具,该光纤F-P标准具稳定性更高,解决了实心标准具折射率和热膨胀变化大的问题。     

L~p空间中的Fejér和Hermite-Hadamard型不等式

给出了二阶导数属于Lp空间时Fejér和Hermite-Hadamard型不等式的推广,得到两个新结果.     

Filling the Charge–Discharge Voltage Gap in Flexible Hybrid Zinc-Based Batteries by Utilizing a Pseudocapacitive Material

The high charge–discharge voltage gap is one of the main bottlenecks of zinc–air batteries (ZABs) because of the kinetically sluggish oxygen reduction/evolution reactions (ORR/OER) on the oxygen electrode side. Thus, an efficient bifunctional catalyst for ORR and OER is highly desired. Herein, honeycomb-like MnCo₂O_4.5 spheres were used as an efficient bifunctional electrocatalyst. It was demonstrated that both ORR and OER catalytic activity are promoted by Mn^IV-induced oxygen vacancy defects and multiple active sites. Importantly, the multivalent ions present in the material and its defect structure endow stable pseudocapacitance within the inactive region of ORR and OER; as a result, a low charge–discharge voltage gap (0.43 V at 10 mA cm⁻²) was achieved when it was employed in a flexible hybrid Zn-based battery. This mechanism provides unprecedented and valuable insights for the development of next-generation metal–air batteries.