超声波燃气表矩形流道的雷诺修正系数仿真研究

在超声波流量计测量技术中, 雷诺修正系数相关的研究对于提高计量精度有重要作用. 为研究矩形流道的雷诺修正系数与雷诺数的关系, 对矩形流道在常温常压流量较小情况下进行仿真, 结果发现: 矩形流道层流状态下的雷诺修正系数与雷诺数呈线性相关. 保持压强、体积流量不变, 在不同温度下进行仿真及拟合, 结果表明: 在不同温度下雷诺修正系数与雷诺数的线性关系依然满足. 在上述实验基础上, 对矩形流道湍流状态下的雷诺修正系数与雷诺数关系进行研究, 通过改变温度、压强和体积流量进行仿真及拟合发现, 矩形流道湍流状态下雷诺修正系数与雷诺数呈非线性相关.     

染料敏化太阳能电池载流子传输的数值模拟

由于在染料敏化太阳能电池(dye-sensitized solar cell, DSSC)中存在染料弛豫、半导体薄膜中电子与氧化态染料分子发生反应和电子在电解质中与氧化态离子复合等不利反应,利用一个更完善的DSSC载流子传输模型对电池的光电性能进行模拟就显得非常重要。为此,本文基于由多重俘获理论建立的DSSC中的包括电子、染料阳离子、碘化物和三碘化物在内的载流子传输模型,数值模拟得到了不同TiO₂薄膜厚度、不同入射光强度与不同染料分子吸收系数下DSSC的J-V曲线。结果表明,随着TiO₂薄膜厚度的增加,太阳能电池的短路电流密度增大,开路电压减小,光电转换效率先增大后减小。当DSSC的TiO₂薄膜厚度为20 μm时,光电转换效率达到最大值7.41%,同时光电转换效率随入射光强度与染料分子吸收系数的增大均有一定程度提高,其中在吸收系数为4 500 cm^-1时,光电转换效率为6.73%。以上结果可以为改进DSSC的光电性能提供理论指导。     

System-size effect on the friction at liquid-solid interfaces

The friction at the liquid-solid interfaces is widely involved in various phenomena ranging from nanometer to micrometer scales. By the molecular dynamic(MD)simulation, the friction properties of liquid-solid interfaces at the molecular level are calculated via the Green-Kubo relation. It is found that the system size will influence the value of the friction coefficient, especially for the solid surfaces with the larger polar charge. The value of the friction coefficient decreases with the increase in the system size and converges at large system sizes. The large polar charge will lead to a significant friction coefficient. However, the diffusion of water molecules on this surface is almost a constant, indicating that the diffusion coefficient seems to be independent of the system size and polar charge. This work provides insights for the selection of the system size in modeling the frictional properties of hydrophobic/hydrophilic surfaces.     

航空导管弯曲试验的疲劳裂纹萌生寿命

飞行器液压导管受接头和卡箍等约束,在使用的振动环境中,会因弯曲应力而导致破裂,影响到飞行安全．本文对飞行器液压系统通用的不锈钢导管的裂纹萌生寿命进行了试验研究．首先在对8 mm、12 mm 无缺陷导管和含U 型缺口8 mm 导管的疲劳试验和有限元分析的基础上,得到了导管的最大拉应变-裂纹萌生寿命数据．然后采用基于强度极限和弹性模量估算法的Manson-Coffin 公式来预测导管裂纹萌生寿命．最后引入加载类型修正系数、表面质量修正系数、试样尺寸修正系数、应力集中敏感系数和有效应力集中系数,使修正后的公式对三种类型的导管均有较好的裂纹萌生寿命预测精度．     

群集建筑中大跨裙摆屋盖风荷载特性的数值模拟研究

以苏州太平金融大厦为工程背景,针对其大跨裙摆屋盖的风荷载作用,首先采用RNG k-ε模型模拟分析了其平均风压分布规律,以及风向变化对屋盖表面风荷载体型系数的影响;其次,引入干扰因子IF,探讨了周边建筑对大跨裙摆屋盖风荷载的气动干扰作用。结果表明:0°风向下,走廊上方屋盖两侧区域出现“上吸下顶”的叠加作用;90°风向下屋盖北侧飘带末端区域受到狭道风效应出现正压集中现象;风向变化对大跨裙摆屋盖的风荷载体型系数分布影响较大;且周围建筑物对大跨裙摆屋盖的气动干扰效应明显,主要表现为风压“遮挡效应”,而局部区域表现为风压“放大效应”。     

双旋转附属圆柱对主圆柱尾流控制的影响

基于Fluent 软件平台,采用数值模拟方法对非稳态圆柱体结构尾流流动特性进行了研究．对在Re = 50~200范围内,双旋转附属圆柱的转速对主圆柱体尾流流动特性的影响进行了分析．研究结果表明：随着附属圆柱旋转速率的增加,主圆柱体表面所受阻力系数平均值与均方根值、升力系数均方根值均会减小．同时,旋转速率的变化对柱体结构表面压力分布的影响显著,压力系数在附属圆柱的位置产生了跳跃性变化．另外,当附属圆柱转速达到临界值时,尾流涡街变窄,涡脱落现象消失,并且系统的能量效率到达最佳状态．     

基于Raman激光雷达反演大气污染气体浓度几种方法

筊aman激光雷达是探测大气污染气体的一种重要方法,雷达回波反演是其中的重要步骤,反演的关键在于正确得到透过率指数因子。以消光系数为中心的三个方案,介绍了目前已普遍采用的方法、应用532 nm大气消光系数间接求取α(λ₁,z)和α(λ_２,z)。提出了两种新方法：(1) 采用拉曼波长与待测气体相近的参考气体,α(λ₁,z)＝α(λ_２,z);(2) 借助λ₁和λ₂的Mie-Rayleigh散射回波求取指数因子。     

Computational study of the formation of aluminum-graphene nanocrystallites

The molecular dynamics method is used to study the formation of the Al/graphene nanocomposite in the structural grains of different size under the action of internal stresses. The behavior of graphene sheets inside an individual structural grain as well as in the process of two Al grains containing graphene are joined is investigated. The motion of graphene films, starting from the middle of the aluminum matrix, ends with their location at the crystallite boundaries. Graphene moves in the Al matrix along closely packed planes. In this case, graphene sheets acquire curvature. An intergrowth of graphene sheets is also observed. A contact between two Al-C nanocrystallites through a graphene interlayer is created. The self-diffusion coefficients of atoms and the partial potential energies increased with decreasing nanocrystallite size. The angular distribution of the nearest geometric neighbors and the distribution of distances to the nearest neighbors are determined using the construction of Voronoi polyhedra.     

Short-range order structure and free volume distribution in liquid bismuth: X-ray diffraction and computer simulations studies

ABSTRACT

The structure of liquid bismuth was studied by X-ray diffraction and computer simulation methods. The contraction of the atomic structure within the first coordination sphere in the temperature interval of 575-1225?K is reported. The temperature dependencies of the coordination numbers and of the free volume are analysed. On the basis of the temperature dependencies of the free volume, the temperature dependencies of viscosity and the self-diffusion coefficient were calculated to be in the ranges from 1.17 to 0.86?mPa?s and from 2.18 × 10^?9 to 5.44 × 10^?9?m²/s, respectively. The free volume – extracted results are in fair agreement with the experimental data and with the results obtained in the molecular dynamics simulations.