Controlled synthesis of poly(acetone oxime acrylate) as a new reactive polymer: Stimuli-responsive reactive copolymers

Acetone oxime acrylate has been synthesized as a new active ester monomer. Free radical polymerization yielded a reactive polymer soluble in various organic solvents, such as chloroform, dioxane, DMSO, acetone, methanol, dichloromethane, DMF, and ethanol. Controlled radical polymerization of acetone oxime acrylate was successfully conducted using the RAFT, NMP and Iniferter method. Partly polymer analogous reaction with N-isopropylamine resulted in the reactive copolymer poly(N-isopropylacrylamide-co-acetone oxime acrylate), which featured a lower critical solution temperature (LCST) of 61 °C in water. Further, the reactivity of the copolymer was exemplary proven by complete reaction with ammonia yielding poly(N-isopropylacrylamide-co-acrylamide), which does not possess a LCST.     

Neue acetonylsubstituierte Azole I. 5-Acetonyl-1,2,4-oxadiazole

Aliphatic amidoximesR—C (NH₂)=NOH react with diketene to yield 5-acetonyl-3-alkyl-1,2,4-oxadiazoles, which are susceptible to a wide variety of reactions at the keto-group as well as at the methylene-group. Their transformations into 1-methyl-2-oxadiazolyl-vinylN,N-dimethylcarbamates, 2-chloro-1-oxadiazolylpropenes, 1-oxadiazolyl-2-(1,2,4-triazol-1-yl)propenes, 1,1-dichloro-1-oxadiazolylacetones and 3-hydroxy-2-oxadiazolyl-crotonic amides are described as well as their reactions with diazonium salts, with sodium nitrite and with carbon disulfide. Further products obtained are carbamates of of 1-oxadiazolyl-2-oxo-propane-1-oximes, 2-chloro-2-oxadiazolylvinyl phosphates and an oxadiazolyl pyrimidine.

Herrn Prof. Dr.Klaus Weissermel zu seinem 60. Geburtstag.     

SIAmate-a compact and modular sequential injection analysis controller

A number of sequential injection analysis (SIA) measurement methods have been developed during the last years. Almost all have been used in laboratory conditions with good results, but very few have been implemented as on-line methods, applied to non-stop measurements, producing immediate results for process control. The transfer of an SIA system from laboratory to an industrial facility [J. Ruzicka, Anal. Chim. Acta 261 (1992) 3] requires a whole new range of details to be taken into account. Some SIA platform related topics will be discussed. There are numerous ways of building an SIA system that meets the needs of the industry. One alternative, SIAmate, is presented.     

Histidine in enzyme active centers.

The presence of histidine in the active center of an enzyme can be demonstrated by kinetic measurements, chemical modification, NMR spectroscopy or X-ray structure analysis. Histidine is the only naturally occurring amino acid to contain an imidazole residue as a side chain. The role of histidine in enzyme catalysis depends, inter alia, upon the special features of the imidazole residue: it thus tends to form hydrogen bonds, combines donor and acceptor properties and can take part in either nucleophilic or base catalysis. In some of these enzymes the position of each atom is known; however, the theories as to how the catalysis proceeds at a molecular level are controversial.     

水中痕量钼(Ⅵ)的4-(2-吡啶偶氮)-间苯二酚螯合活性炭吸附富集分光光度法测定

提出了一种简单快速预富集水中痕量钼（Ⅵ）的新方法，方法的机理在于4－（2－吡啶偶氮）－间苯二酚（PAR）与钼（Ⅵ）螯合后被活性炭中附，然后用NaOH解吸下来，再用水杨基荧光酮与钼（Ⅵ）显色，分光光度法测定钼（Ⅵ）的含量；详细研究了影响Mo-PAR螯合物定量吸附于活性炭上的各种参数，找出了最佳吸附－解吸条件，包括吸附酸度、PAR用量、吸附时间、解吸酸度等；该法的主要优点是操作简单、快速，干扰小，避免了常规方法中用浓硝酸消化活性炭费时和污染大的解吸方法，该法已用于测定水中痕量钼（Ⅵ），加标回收率达到94％－97％。     

高活性钛镀铂电极

在电沉积过程中采用超声波振荡技术，选择最佳条件可制备牢固高活性然镀铂电极，超声波振荡技术改善他镀层与基底的粘结力。电极活性与双层电容有关，并旭因于表面粗糙度。     

丙烯酸酯共聚物乳液自交联反应的研究

本文研究了含环氧基的丙烯酸酯四元共聚物乳液交联后的溶胀度、自交联反应及动力学.结果表明:交联共聚物的溶胀度Q随甲基丙烯酸环氧丙酯单体含量的增加而降低,共聚物在受热的情况下,环氧基因在羧基的作用下开环而发生交联反应,产生网状结构.     

主动冷却点阵夹层防热结构温度响应计算模型北大核心CSCD

针对点阵夹层结构主动热防护问题,建立了夹层结构面板和芯体导热与冷却剂对流耦合的非稳态传热理论模型,利用有限体积法离散控制方程并在MATLAB中进行了迭代求解.模型首次考虑了面板与夹芯杆之间的收缩热阻,并利用分离变量法得到了收缩热阻的近似解析解.基于单胞模型和周期性边界条件,模拟得到了模型所需的表面对流传热系数h_(b)和h_(fin).最后,选取多单胞计算工况进行数值模拟和理论模型对比,并讨论了收缩热阻对模型预测精度的影响.结果表明:理论模型能够准确预测夹层结构及内部流体的温度变化,理论与仿真之间的最大误差不超过1%;随着外加热流密度不断增大,忽略收缩热阻使得计算结果造成的误差不断增大;与数值模拟相比,理论模型可显著地减少计算时间并节省计算资源,尤其适用于非均匀、非稳态复杂热载荷下点阵夹层结构的温度响应计算.     

Finding normal solutions in piecewise linear programming

Letf: ⁿ (–, ] be a convex polyhedral function. We show that if any standard active set method for quadratic programming (QP) findsx(t)= arg min _x ¦x¦²/2+t f(x) for somet> 0, then its final working set defines a simple equality QP subproblem, whose Lagrange multiplier can be used both for testing ift is large enough forx(t) to coincide with the normal minimizer off, and for increasingt otherwise. The QP subproblem may easily be solved via the matrix factorizations used for findingx(t). This opens up the way for efficient implementations. We also give finite methods for computing the whole trajectory {x(t)} _t 0, minimizingf over an ellipsoid, and choosing penalty parameters inL ₁QP methods for strictly convex QP.This research was supported by the State Committee for Scientific Research under Grant 8S50502206.     

Dimer asymmetry in superoxide dismutase studied by molecular dynamics simulation

Summary Molecular dynamics (MD) simulations of 100 ps have been carried out to study the active-site behaviour of the Cu,Zn superoxide dismutase dimer (SOD) in water. The active site of each subunit was monitored during the whole simulation by calculating the distances between functional residues and the catalytic copper. The results indicate that charge orientation is maintained at each active site but the solvent accessibility varies. Analysis of the MD simulation, carried out by using the atomic displacement covariance matrix, has shown a different intra-subunit correlation pattern for the two monomers and the presence of inter-subunit correlations. The MD simulation presented here indicates an asymmetry in the two active sites and different dynamic behaviour of the two SOD subunits.