TCH-600氧、氮、氢分析仪在唐钢的应用

通过TCH-600氧、氮、氢分析仪在唐钢的实际应用,重点介绍了助熔剂、坩埚、样品熔解及空白和校正过程中应注意的问题,钢铁样品分析条件的选择.     

三甲基硅、三甲基锗和三甲基锡取代的一系列芘衍生物的紫外吸收和荧光性质

被三甲基硅(Me3Si-)、三甲基锗(Me3Ge-)和三甲基锡(Me3Sn-)取代的芘衍生的紫外吸收波长和未取代的芘相比较,波长红移.一,二,三,四取代三甲基硅芘最大吸收波长红移小于10nm.荧光强度和周期按Me3SiAr＞Me3GeAr＞Me3SnAr顺序减弱.1,3,6,8-四-三甲基硅芘的荧光强度在一系列芘衍生物中是最大的.     

中药白茅根中金属元素的含量测定

火焰原子吸收光谱法测定中草药白茅根茎部的Fe、Cu、Zn、Mn、Ca、Mg,方法简单、精密度好、回收率在92.0%-104.4%之间,相对标准偏差(RSD)小于1.8%,结果令人满意.     

原子吸收光谱间接测定色氨酸的研究

色氨酸(Tryptophan,Trp)在碱性条件下与新生成的ZnS悬浮液反应,生成可溶性碱式色氨酸锌配合物,再用塞曼原子吸收光谱测定溶液中的总锌浓度即可间接的得到色氨酸的含量.优化了测定的最佳条件,在pH 9.10的2%硼砂底液中于室温下,使色氨酸试液与新生成的ZnS悬浮液反应22min,离心分离后测定上层清液的FAAS响应.在所选定的条件下色氨酸测定的线性浓度范围为0-18.5mg·mL-1,特征浓度为0.219mg·mL-1,检出限为1.414mg·mL-1.该法用于样品中的色氨酸测定,其相对标准偏差RSD为4.12%,方法的回收率在70.1%-120.3%之间.并对测定机理进行了探讨.     

Hinge peptide combinatorial libraries for inhilbitors of botulinum neurotoxins and saxitoxin: Deconvolution strategy

Combinatorial library screening offers a rapid process for identifying potential therapies to toxins. Hinge peptide libraries, which rely on conformational diversity rather than traditional molecular diversity, reduce the need for huge numbers of syntheses and screening steps and greatly expedite the discovery process of active molecules. Hinge peptide libraries having the structures: Acetyl-X₁–X₂–hinge–X₃–X₄–NH₂ (capped) and X₁–hinge–X₂–X₃ (uncapped), where X₁ through X₄ are near-equimolar mixtures of twelve L-amino acids and hinge = 4-aminobutyric acid, were screened for inhibitory activity in bioassays for botulinum neurotoxins A and B (BoNT/A, BoNT/B) and saxitoxin. The zinc protease activity of the reduced light chains of BoNT/A and /B was assayed by measuring the cleavage of synthetic substrates. Saxitoxin activity was measured by the restoration of the viability of neuroblastoma cells treated with ouabain and veratridine. Deconvolution of libraries was accomplished by fixing one position at a time beginning with the C-terminus. Primary library subsets in which position 4 was fixed showed moderate levels of inhibition for BoNT/A. Secondary library subsets showed stronger inhibition in the bioassays. In each of the bioassays, inhibitory potency was stronger when the second position to be fixed was on the opposite side of the hinge, rather than on the same side with respect to the C-terminus, suggesting that the hinge facilitates the interaction of side chains. Inhibitors for all three of the toxins studied were discovered within library subsets, although not necessarily in primary subsets. These studies demonstrate that (1) the best strategy for deconvoluting hinge peptide libraries is by fixing residues alternately on each side of the hinge moiety, and (2) it is essential to investigate secondary subsets even when primary subsets are inactive. The present findings support the concept that the increased flexibility imposed by the inclusion of a central hinge residue in small peptides increases the opportunity for side chain interactions, providing a distinct advantage for hinge peptide libraries over conventional peptide libraries. Hinge peptide libraries are a rich source of novel ligands for modulation of biomechanisms. The library subsets uncovered in this study may possess peptides that will lead to effective therapies to neurotoxin poisoning.     

LiNbO3∶Cr∶Cu晶体吸收特性及非挥发全息存储研究

研究了LiNbO3∶Cr∶Cu晶体的吸收特性,发现LiNbO3∶Cr∶Cu（含0.14 wt.% Cr2O3 和 0.011 wt.% CuO）晶体存在两个明显的吸收峰,中心波长分别位于480 nm和660 nm; 随着Cr的含量逐渐减小,Cu的含量逐渐增大,短波段不存在明显吸收峰,掺Cr的含量越大,中心波长在660 nm处的吸收越大；633 nm红光虽然位于中心波长为660 nm的吸收峰内,但它无助于光折变过程.分别采用390 nm紫外光和488 nm蓝光作为敏化光,514 nm绿光作为记录光的记录方案,实现了非挥发全息记录,掺入适量的Cr( 比如NCr=2.795×1025 m－3,NCr/ NCu=1)有助于全息记录性能的提高.     

A study on optical absorption and constants of doped poly(ethylene oxide)

Thin films of polymer electrolyte based on poly(ethylene oxide) doped with sodium iodide (NaI) were prepared using the solution cast method. The films obtained have average thickness of 70 μm and different NaI concentrations. Absorption and reflectance spectra of UV-radiation were studied in the wavelength range 300-800 nm. The optical results were analyzed in terms of absorption formula for non-crystalline materials.The optical energy gap and the basic optical constants, refractive index, and dielectric constants of the prepared films have been investigated and showed a clear dependence on the NaI concentration. The interpreted absorption mechanism is a direct electron transition.The observed optical energy gap for neat poly(ethylene oxide) is about 2.6 eV, and decreases to a value 2.36 eV for the film of 15 wt% NaI content. It was found that the calculated refractive index and the dielectric constants of the polymer electrolyte thin films increase with NaI content. Models were used to describe the dependences of the dielectric constant on the NaI concentration, and the refractive index on the incident photon energy.     

基于红外光谱分析的小温差物体距离估计

基于辐射传输特性的目标距离估计作为一项典型的被动测距技术,是目前光电对抗领域的一个研究热点。在测距过程中无需向外界发射能量,使得这种探测方式极大地增强了导弹或无人机的隐身能力和突防能力。针对现有被动测距系统不适用于对迎面而来目标物体实施被动距离估计的不足,提出了一种改进的小温差目标距离估计方法。在引入了信号传递函数概念的基础上,明确了当前算法的工作曲线,指出这种方法的非线性会导致目标距离估值不唯一的风险。本文应用非线性校正技术,构造了新的距离估计算法。得到了一个利用3~5和8~12 μm双波段红外传感信息,目标背景温度和气象条件的测距公式。研究表明,当目标与背景表观温差等于5 K、而背景温度估计偏差不超过±5 K时,目标距离估计误差可控制在10%左右。     

吸收谱交迭的双组分混合液的荧光谱校正研究

荧光内滤效应以及样品池中荧光物质对激发光的吸收分布会直接影响荧光谱的强度和谱形,共同制约荧光分析法的应用。使用吸收谱及荧光谱存在交迭的双组分混合溶液,研究一种新的基于物理吸收模型的校正方法,以校正荧光内滤效应及吸收分布对荧光强度的影响。对三聚噻吩和五聚噻吩混合液的光谱研究表明,使用所述校正方法可以达到较为理想的校正效果, 误差小于5%。     

A Pseudo-Stokes Mesh Motion Algorithm

This work presents a moving mesh methodology based on the solution of a pseudo flow problem. The mesh motion is modeled as a pseudo Stokes problem solved by an explicit finite element projection method. The mesh quality requirements are satisfied by employing a null divergent velocity condition. This methodology is applied to triangular unstructured meshes and compared to well known approaches such as the ones based on diffusion and pseudo structural problems. One of the test cases is an airfoil with a fully meshed domain. A specific rotation velocity is imposed as the airfoil boundary condition. The other test is a set of two cylinders that move toward each other. A mesh quality criterion is employed to identify critically distorted elements and to evaluate the performance of each mesh motion approach. The results obtained for each test case show that the pseudo-flow methodology produces satisfactory meshes during the moving process.