一种大功率窄脉冲半导体激光器测试台的研制

大功率窄脉冲半导体激光器主要光电性能参数为:输出峰值光功率、阈值电流、正向电压、上升时间、峰值波长、光谱半宽、半强度角.根据激光制导系统对大功率窄脉冲激光器参数的特殊测试要求,研制一种大功率窄脉冲激光器测试平台,将小型化大功率激励器功放模块、大范围可调DC-DC模块、信号源板、激光器座、光学准直镜集成在一个平台上,与峰值功率计、光谱仪、CCD摄像机等仪器配合,可测出大功率窄脉冲激光器的峰值功率、峰值波长及波长随温度变化的漂移特性、发光芯均匀性等参数.介绍了大功率窄脉冲激光器测试台的特点,并对测试结果作了论述.     

水溶液中Cr^3＋的火焰原子吸收光谱法测试条件的优化

为优化火焰原子吸收光谱法测定水溶液中的Cr^3＋的测试条件,分别采用单因素简单比较法、正交实验设计极差分析及正交实验回归方法考察了光谱通带n,空心阴极灯电流I,燃烧器高度h以及乙炔/空气流量比P对于仪器灵敏度的影响。结果表明单因素简单比较法获得的实验条件最优。乙炔/空气流量比P对火焰原子吸收仪器灵敏度影响最大、其次是光谱通带n,燃烧器高度h和灯电流I的影响很小。测定水溶液中的Cr^3＋时仪器灵敏度最佳的实验条件为：乙炔/空气流量比P=0.4;光谱通带n=0.2nm;灯电流I=5mA;燃烧器高度h=5cm。     

Sixth harmonic generation of 1064-nm laser in KBBF prism coupling devices under two kinds of gas conditions

The conversion efficiency on the sixth harmonic of 1064 nm in KBe2BO3F2 （KBBF） at different gas pressures in two kinds of gases, helium and nitrogen, is measured and compared. In the both gases, maximum conversion efficiency on the sixth harmonic of 1064 nm in high vacuum is nearly 10% of 355 nm, which is almost four times higher than that in low vacuum. The maximum average output power at 177.3 nm is 670 ttW with the repetition rate of 10 Hz and the duration of 20 ps in high vacuum. It indicates that the sixth harmonic generation in high vacuum is more preferable than that in low vacuum.     

牵引变流器网侧电流谐波抑制研究

作为电力机车牵引传动系统核心部件的牵引变流器是牵引供电网的主要谐波来源之一。牵引变流器采用的单相四象限整流器,输出含有二次脉动,且工作开关频率较低,导致变流器网侧电流谐波问题严重。目前单相四象限整流器的控制脉冲产生主要采用SPWM技术。与SPWM相比,SHEPWM（特定谐波消除PWM）可以针对性的消除特定的谐波,谐波含量更小,效率更高,但其无法消除调制波中本身就存在的谐波。针对SHEPWM调制策略进行了分析设计,同时对陷波滤波器技术、PR控制策略和LC回路在降低谐波含量中的作用进行深入分析。经过合理的方案选择,有效的降低了网侧电流谐波含量,并通过MATLAB仿真实验进行了分析验证。     

大气压直流激励空气等离子体羽发光的时空演化

在针-针电极结构的放电装置中以环境空气作为工作气体,大气压下产生了刷形等离子体羽。尽管使用的是直流电源,但放电发光呈现出脉冲性质,发光脉冲频率几乎不受气体流速的影响,但与电源输出功率成正相关关系。等离子体羽的长度与气体流速或者电源功率成正相关关系。通道出口附近,777.4 nm的氧原子谱线强度分布是非对称的,阴极附近处的谱线强度高于阳极附近处的谱线强度。远离通道出口位置,谱线强度逐渐趋于轴对称分布。电学特性和10 μs曝光高速影像结果表明,空气等离子体羽实际上是由拱形放电丝在远离通道出口的运动过程中叠加而成,同时放电从弧光放电丝向均匀辉光放电转化。     

金属型脉冲堆惯性效应计算

金属型脉冲堆的反应性负反馈主要来自燃料的热膨胀。当脉冲堆爆发短周期脉冲时,由于燃料的热膨胀不能及时响应温度的变化,致使负反馈滞后,产生惯性效应。采用ANSYS程序计算了在突然热加载条件下的振荡特性,同时采用随机中子输运程序计算了平均关闭系数,然后把带有振荡特性的热反馈带入点堆动力学方程,采用数值方法求解得到了考虑惯性效应的裂变脉冲波形。计算结果与Godiva实验测量结果一致。采用的数值方法中,脉冲周期与振荡效应存在定量关系。由计算结果可知,脉冲周期短,惯性效应明显;脉冲周期越长,惯性效应的影响越小,金属型脉冲堆爆发脉冲时应尽量避免短周期脉冲。     

1:10缩尺人工头研制及其在建筑声学缩尺模型测量中的应用

采用三维激光扫描技术对01dB MK2B人工头进行扫描,建立了包含耳道的人工头数字模型,再利用3D打印技术按照1:10的缩尺比打印出缩尺人工头,并将1/8 in传声器嵌入缩尺人工头内。在消声室内分别测量了足尺和缩尺人工头的双耳脉冲响应,并计算了双耳时间差ITD、双耳声压级差ILD以及双耳互相关系数IACC,对比分析结果显示两者吻合很好。将研制的人工头应用于天津文化中心音乐厅1:10声学缩尺模型IACC参数测量,模型测量结果与现场测量结果一致。该方法制作的缩尺人工头可用于声学缩尺模型实验中厅堂空间感参数的测量并有望应用于可听化技术。     

An Interacting Gauge Field Theoretic Model for Hodge Theory: Basic Canonical Brackets

We derive the basic canonical brackets amongst the creation and annihilation operators for a two （1 ＋ 1）- dimensional （2D） gauge field theoretic model of an interacting Hodge theory where a U（1） gauge field （Aμ） is coupled with the fermionic Dirac fields （ψ and ψ）. In this derivation, we exploit the spin-statistics theorem, normal ordering and the strength of the underlying six infinitesimal continuous symmetries （and the concept of their generators） that are present in the theory. We do not use the definition of the canonical conjugate momenta （corresponding to the basic fields of the theory） anywhere in our whole discussion. Thus, we conjecture that our present approach provides an alternative to the canonical method of quantization for a class of gauge field theories that are physical examples of Hodge theory where the continuous symmetries （and corresponding generators） provide the physical realizations of the de Rham cohomological operators of differential geometry at the algebraic level.     

Theory of noise in a kilo-Hz cascaded high-energy Yb-doped nanosecond pulsed fiber amplifier

A theoretical analysis of noise in a high-power cascaded fiber amplifier is presented. Unlike the noise theory in low power communication, the noise of a high power system is redefined as the leaked output energy between pulses with coherent beat noise uncounted. This definition is more appropriate for high power usage in which the pulse energy receives more attention than the pulse shape integrity. Then the low power pre-amplifying stages are considered as linear amplification and analyzed by linear theory. In the high-power amplification stages, the inversion is assumed to recover linearly in the time interval between pulses. The time shape of the output pulse is different from that of the input signal because of different gains at the front and back ends of the pulse. Then, a criterion is provided to distinguish the nonlinear and linear amplifications based on the signal-to-noise ratio （SNR） analysis. Then, an experiment that shows that the output SNR actually drops off in nonlinear amplification is performed. The change in the noise factor can be well evaluated by pulse shape distortion.     

Scattering of particles in wave beam based on series expansion

Based on the orthogonalities of the vector wave functions, the expressions of scattering fields are developed as the particle in the zero order field and in the first order fields of x, y, and z, respectively. A general relation between the expansion coefficients of scattering field and incident field is presented. Taking the elliptical beam for example, the scattering property of a particle in beam is investigated. After analyzing the effects of the beam waist, irradiating distance, etc. on scattering property, the validity of the proposed algorithm is demonstrated. Results show that the beam waist may improve the particle identification property and the particle has a strong scattering both in the forward direction and in the backward direction. The method proposed is simple and is a new way of researching the scattering from particles in electromagnetic beams.